BG14B

BeRex 5-4000 MHz Cascadeable InGaP HBT Gain Block Device Features  36.5dBm Output IP3 at 9dBm/tone at 900MHz  17dB Gain at 900MHz  19.5dBm P1dB at 900MHz  Highly Reliable InGaP/GaAs HBT Technology  Temperature Compensation Circuit patent  SOT-89 Surface Mount Package  50 ohm Cascadeable  Lead-free/Green/RoHS compliant Application: commercial, space, military wireless system Electrical Specifications (Ta = 25C, Vs = 5.0V) Parameters Frequency Range Gain 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz 70 MHz 900 MHz 1900 MHz 2450 MHz Vc = 5.0V BG14B Test Conditions Min 5 16.3 16.0 15.0 14.2 Typ 17.3 17.0 16.0 1 5 .2 -16.0 -15.0 -22.0 -19.0 -16.0 -13.0 -14.0 -10.0 37.0 36.5 35.0 33.5 19.2 19.5 19.5 19.5 75 5.0 -0.004 85 Max 4000 18.3 18.0 17.0 16.2 Unit MHz dB S11 dB S22 dB OIP3 P1dB Ic Vc dG/dT Rth 35.0 35.5 33.0 31.5 18.2 18.5 18.5 18.5 70 dBm dBm 85 mA V dB/C C/W Thermal Resistance Test conditions unless otherwise noted. 1. Device performance is measured on BeRex evaluation board at 25C, 50 ohm system. 2. OIP3 measured with two tones at an output power of 9dBm/tone separated by 1MHz. http: //www.berex.com BeRex Absolute Maximum Ratings Parameters Operating Case temperature Storage Temperature Junction Temperature Operating Voltage Supply Current Input RF Power BG14B Rating -40 to +85C -55 to +155C +220C +5.5V 150mA 23dBm Operation of this device above any of these parameters may result in permanent damage. [I-V Characteristics] 160 140 120 Icc [mA] [Generic SOT89 Evaluation Board] +25C -30C +85C 100 80 60 40 20 0 0 1 2 3 4 5 6 BeRex Evaluation Board MMIC Innovator Vcc [V] *Dielectric constant is 4.2 *RF pattern width 52mil *31mil thick FR4 PCB Application Circuit: 5– 4000 MHz Schematic Diagram C3 C4 C5 +5V BOM *C1 *C2 100pF 100pF 100pF 1000pF 10uF 39nH Tolerance ± 5% ± 5% ± 5% ± 5% ± 20% 5% L1 C3 RFin C1 BG14B C2 RFout C4 C5 *L1 *Note1: Less than 20nH improves RF performance at frequencies over 1.9GHz. 40nH or higher value L1 improves RF performance at frequencies under 500MHz. Optimum value of L1 may vary with board design. *Note2: C1, C2 = 8200pF, L1 = 1200nH for 70 MHz application Vcc = 5.2V if 1200nH is used to compensate IR drop across L1 http: //www.berex.com BeRex Typical Device Data BG14B S-parameters (Vc=5V, Ic=75mA, T=25C) (Vdevice = 5.0V, Icc = 75mA, T = 25 C, calibrated to device leads) Freq [MHz] 100 500 1000 1500 2000 2500 3000 3500 4000 S11 [Mag] 0.111 0.121 0.132 0.105 0.075 0.126 0.155 0.154 0.158 S11 [Ang] 169.412 131.454 92.814 44.732 -27.875 -101.268 -124.373 -135.099 -118.070 S21 [Mag] 7.453 7.321 7.113 6.803 6.494 6.088 5.832 5.668 5.266 S21 [Ang] 173.539 148.756 117.826 87.310 57.759 29.213 1.324 -26.222 -55.209 S12 [Mag] 0.070 0.069 0.068 0.066 0.063 0.061 0.058 0.058 0.059 S12 [Ang] -3.904 -17.850 -36.333 -52.837 -69.325 -85.687 -101.832 -117.014 -136.640 S22 [Mag] 0.240 0.225 0.208 0.227 0.279 0.330 0.320 0.255 0.128 S22 [Ang] -7.438 -36.290 -76.064 -113.848 -143.207 -164.117 174.189 151.417 107.020 S-Parameter http: //www.berex.com BeRex BG14B Typical Performance (Vc = 5V, Ic = 75mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 17.3 17.3 17.0 16.0 S11 dB -20.0 -18.5 -17.5 -27.5 S22 dB -13.0 -14.0 -15.0 -10.5 P1 dBm 19.5 19.5 19.5 19.5 OIP3 dBm 37.0 37.5 36.5 35.0 NF dB 5.0 5.0 5.0 5.2 Typical Performance (Vc = 4.7V, Ic = 67mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 16.8 17.1 16.9 15.9 S11 dB -10.3 -24.8 -24.4 -25.4 S22 dB -10.6 -11.0 -10.6 -9.7 P1 dBm 17.9 17.9 18.0 18.2 OIP3 dBm 35.5 33.5 33.5 33.0 NF dB 5.0 5.0 5.0 5.2 Typical Performance (Vc = 4.5V, Ic = 58mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 16.6 17.0 16.8 15.8 S11 dB -11.0 -26.1 -25.4 -25.3 S22 dB -9.2 -10.3 -10.4 -9.5 P1 dBm 17.2 17.2 16.6 16.7 OIP3 dBm 33.0 33.0 32.0 31.5 NF dB 5.0 5.0 5.0 5.2 Typical Performance (Vc = 4.0V, Ic = 37mA, Ta = 25C) Freq MHz 70 500 900 1900 S21 dB 15.9 15.9 16.0 15.1 S11 dB -11.7 -31.4 -29.5 -23.4 S22 dB -8.6 -9.5 -9.6 -8.8 P1 dBm 12.2 12.6 12.6 12.9 OIP3 dBm 25.5 24.0 24.5 25.0 NF dB 5.0 5.0 5.0 5.2 2140 15.7 -23.0 -11.5 19.5 34.5 5.3 2450 15.2 -19.0 -10.0 19.5 33.5 5.5 3500 14.8 -16.0 -13.0 19.5 32.5 5.8 2140 15.7 -24.0 -9.2 17.6 32.5 5.3 2450 15.1 -25.4 -9.8 17.8 32 5.5 3500 13.7 -23.2 -12.6 17.1 30.0 5.8 2140 15.8 -23.6 -9.1 16.7 31.5 5.3 2450 15.1 -25.1 -9.7 16.8 30.5 5.5 3500 13.6 -22.6 -12.4 16.2 29.0 5.8 2140 14.8 -21.8 -8.5 12.3 24.5 5.3 2450 14.4 -23.1 -9.1 11.8 25.0 5.5 3500 13.3 -20.1 -11.8 12.5 24 5.8 http: //www.berex.com BeRex WCDMA 4FA 2140 -60dBc BG14B WCDMA 6FA 2140 -60dBc http: //www.berex.com BeRex BG14B ACLR Device Performance Pin-Pout-Gain 25 35% 25 35% 30% 20 25% 15 15 20 30% 25% Po/G Po/G PAE 10 15% 10 15% 10% 5 5% 5 10% 5% 0 -15 -10 -5 0 5 10 0% 0 -15 -10 -5 0 5 10 0% Pin [dBm ] Pin [dBm ] 900MHz, 5V/75mA 1900 MHz, 5V/75mA http: //www.berex.com PAE 20% 20% BeRex BG14B OIP3 F1=500, F2=501MHz 40 F1=900, F2=901MHz 40 38 38 OIP3 [dBm] OIP3 [dBm] 36 36 34 34 32 +25C 30 8 10 12 14 16 -30C +85C 32 +25C 30 8 10 12 14 16 -30C +85C Po,tot [dBm ] Po,tot [dBm ] F1=1900, F2=1901MHz 40 +25C 38 -30C +85C F1=2140, F2=2141MHz 40 +25C 38 -30C +85C OIP3 [dBm] 36 OIP3 [dBm] 8 10 12 14 16 36 34 34 32 32 30 30 8 10 12 14 16 Po,tot [dBm ] Po,tot [dBm ] F1=2450, F2=2451MHz 40 +25C 38 -30C +85C OIP3 Po=7dBm /tone, D F=1MHz 40 38 OIP3 [dBm] 36 OIP3 [dBm] 36 34 34 32 32 +25C -30C 1500 2000 +85C 2500 30 8 10 12 14 16 30 500 1000 Po,tot [dBm ] Freq [MHz] http: //www.berex.com BeRex ACPR F=500MHz, IS-95A, 9CH-FWD 885KHz Offset 0 +25C -10 -20 -30C +85C 0 -10 -20 +25C -30C BG14B F=900MHz, IS-95A, 9CH-FWD 885KHz Offset +85C ACPR [dBc] ACPR [dBc] 8 10 12 14 16 -30 -40 -50 -60 -70 -80 -30 -40 -50 -60 -70 -80 8 10 12 14 16 Po [dBm ] Po [dBm ] F=1900MHz, IS-95A, 9CH-FWD 885KHz Offset 0 +25C -10 -30C +85C IS-95A, 9CH-FWD, 885KHz Offset Po satisfies -45dBc 20 +25C 18 -30C +85C ACPR [dBc] -20 Po [dBm] 8 10 12 14 16 -30 -40 -50 16 14 12 -60 -70 10 500 1000 1500 2000 Po [dBm ] Freq [MHz] Gain Flatness Gain vs Temperature 18 S21 [dB] 16 14 12 10 0 500 1000 1500 2000 Freq [MHz] 2500 3000 3500 4000 +25C -30C +85C http: //www.berex.com BeRex BG14B Package Outline Dimension Suggested PCB Land Pattern and PAD Layout PCB Land Pattern PCB Mounting 0.40 1.30 0.40 Ø0.40 0.40 0.75 1.20 1.20 1.20 1.20 1.50 1.00 0.65 2.80 2.00 0.50 Note : All dimension are in millimeters Visit http://www.berex.com for PCB layout http: //www.berex.com BeRex BG14B Tape & Reel SOT89 Packaging information: Tape Width (mm): 12 Reel Size (inches): 7 Device Cavity Pitch (mm): 8 Devices Per Reel: 1000 Lead plating finish 100% Tin Matte finish. (All BeRex products undergoes a 1 hour, 150 degree C, Anneal bake to eliminate thin whisker growth concerns) MSL / ESD Rating ESD Rating: Value: Test: Standard: MSL Rating: Standard: Class 1C Passes