BG16C

BeRex 5-4000 MHz Cascadable InGaP HBT Gain Block Device Features  28.5dBm Output IP3 at 3dBm/tone at 900MHz  17.0dB Gain at 900MHz  16.0dBm P1dB at 900MHz  Highly Reliable InGaP/GaAs HBT Technology  Temperature Compensation Circuit patent  SOT-89 Surface Mount Package  50 ohm Cascadable  Lead-free/Green/RoHS compliant Application: commercial, space, military wireless system Electrical Specifications (Ta = 25C, Vs = 5.0V) Parameters Test Conditions Frequency Range Gain 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz Vcc = 5.0V BG16C Min 5 16.2 1 6 .0 1 5 .0 14.3 Typ 17.2 17.0 16.0 15.3 -15.0 -21.0 -22.0 -20.0 -32.0 -45.0 -16.0 -15.0 28.5 28.5 28.0 27.5 15.6 16.0 15.5 15.0 42 5.0 -0.004 50 Max 4000 18.2 18.0 17.0 16.3 Unit MHz dB S11 dB S22 dB OIP3 P1dB Icc Vc c dG/dT Rth 26.5 26.5 26.0 25.5 14.6 1 5 .0 14.5 14.0 35 dBm dBm 50 mA V dB/C C/W Test conditions unless otherwise noted. 1. Device performance is measured on BeRex evaluation board at 25C, 50 ohm system. 2. OIP3 measured with two tones at an output power of 3dBm/tone separated by 1MHz. http: //www.berex.com BeRex Absolute Maximum Ratings Parameters Operating Case temperature Storage Temperature Junction Temperature Operating Voltage Supply Current Input RF Power BG16C Rating -40 to +85C -55 to +155C +220C 6.5V 120mA 23dBm Operation of this device above any of these parameters may result in permanent damage. [I-V Characteristics] [Generic SOT89 Evaluation Board] BeRex Evaluation Board MMIC Innovator *Dielectric constant is 4.2 *RF pattern width 52mil *31mil thick FR4 PCB Application Circuit: 5 - 4000 MHz Schematic Diagram C3 C4 C5 +5V BOM C1 C2 100pF 100pF 100pF 1000pF 10uF 33nH Tolerance ± 5% ± 5% ± 5% ± 5% ± 20% 5% L1 RFin C1 BG16C C3 C2 RFout C4 C5 *L1 *Note: Less than 20nH improves RF performance at frequencies over 1.9GHz. 40nH or higher value L1 improves RF performance at frequencies under 500MHz. Optimum value of L1 may vary with board design. http: //www.berex.com BeRex Typical Device Data BG16C S-parameters (Vc=5V, Ic=40mA, T=25C) (Vdevice = 5.0V, Icc = 40mA, T = 25 C, measured on a BeRex evaluation board) Freq [MHz] 100.00 500.00 1000.00 1500.00 2000.00 2500.00 3500.00 4000.00 S11 Mag 0.718 0.177 0.07 0.0499 0.0932 0.103 0.128 0.0679 S11 Ang -45.3 -148 120 14.8 -82 -131 159 127 S21 Mag 5.28 7.42 7.16 6.82 6.34 5.79 5.2 4.86 S21 Ang -144 122 50.8 -16.6 -83.7 -147 86.9 23.9 S12 Mag 0.0499 0.0907 0.0913 0.0911 0.0885 0.0905 0.0886 0.0941 S12 Ang 71.1 -31.8 -89.4 -143 164 118 14.7 -35.6 S22 Mag 0.78 0.119 0.0247 0.104 0.166 0.177 0.155 0.122 S22 Ang 133 72.7 -127 -159 -177 149 92.2 37.3 S-Parameter http: //www.berex.com BeRex BG16C Typical Performance (Vc = 5V, Ic = 40mA, Ta = 25C) Freq MHz 500 900 1900 2140 S21 dB 17.2 17.0 16.0 15.7 S11 dB -17 -22 -24 -20 S22 dB -23 -29 -17 -16 P1 dBm 15.6 16.0 15.5 15.5 OIP3 dBm 28.5 28.5 28.0 28.0 NF dB 4.9 4.5 4.6 4.6 2450 15.3 -16 -15 15.0 27.5 4.7 3000 14.7 -15 -14 14.4 27.0 4.7 3500 14.4 -19 -13.9 12.7 25 4.7 Typical Performance (V device = 4.7 V, Ic = 34 mA, Ta = 25 ℃) Freq S21 S11 S22 P1 OIP3 NF MHz dB dB dB dBm dBm dB 70 19.6 -11.8 -5.9 13.8 25.5 4.9 500 17.0 -29.8 -13.9 13.3 23.5 4.9 900 16.8 -24.6 -15.8 12.9 24.5 4.5 1900 15.7 -18.8 -13.5 13.6 25 4.6 2140 15.4 -16.9 -12.3 13.1 24 4.6 2450 15.1 -18.9 -13.1 13.5 24.5 4.7 3500 14.2 -18.1 -13.4 11.9 23.5 4.7 Typical Performance (V device = 4.5 V, Ic = 29 mA, Ta = 25 ℃) Freq MHz 70 500 900 1900 2140 S21 dB 19.4 16.8 16.3 15.4 15.2 S11 dB -13.1 -25.2 -24.3 -18.2 -16.3 S22 dB -5.7 -13.1 -14.7 -12.7 -11.6 P1 dBm 13.3 12.8 11.8 12.0 12.2 OIP3 dBm 23.5 23.5 22.0 20.0 22.0 4.9 4.5 4.6 4.6 NF dB 4.9 2450 14.8 -18.1 -12.5 13.0 22.0 4.7 3500 14 -17.1 -12.9 11.4 22.0 4.7 http: //www.berex.com BeRex WCDMA 4FA 2140 -60dBc BG16C WCDMA 6FA 2140 -60dBc http: //www.berex.com BeRex BG16C ACLR Device Performance Pin-Pout-Gain 900MHz, 5V/40mA 1900 MHz, 5V/40mA http: //www.berex.com BeRex OIP3 BG16C http: //www.berex.com BeRex ACPR BG16C Gain Flatness http: //www.berex.com BeRex BG16C Package Outline Dimension Suggested PCB Land Pattern and PAD Layout PCB Land Pattern PCB Mounting 0.40 1.30 0.40 Ø0.40 0.40 0.75 1.20 1.20 1.20 1.20 1.50 1.00 0.65 2.80 2.00 0.50 Note : All dimension are in millimeters Visit http://www.berex.com for PCB layout http: //www.berex.com BeRex BG16C Tape & Reel SOT89 Packaging information: Tape Width (mm): 12 Reel Size (inches): 7 Device Cavity Pitch (mm): 8 Devices Per Reel: 1000 Lead plating finish 100% Tin Matte finish. (All BeRex products undergoes a 1 hour, 150 degree C, Anneal bake to eliminate thin whisker growth concerns) MSL / ESD Rating ESD Rating: Value: Test: Standard: MSL Rating: Standard: Class 2 Passes