BSIP10-12W

BTCPower BSIP10-12W BSMT10-12W Series TM Broadband TelCom Power, Inc. Redefining “Current” Limits In Power Conversion 10A SIP & SMT 12V Input DC-DC Converters Features • • • • • • • • • • Industry standard pin out High efficiency to 95% 300KHz switching frequency 6.0 – 14 Vdc input range 0.75-5.0Vdc wide output range Over temperature protection Continuous short circuit protection Remote On/Off Cost efficient open frame design UL / cUL 60950 certified Model Number Input Voltage Output Voltage Output Current Input Current No Load Full Load % Efficiency BSIP10-12-075W / BSMT10-12-075W BSIP10-12-120W / BSMT10-12-120W BSIP10-12-150W / BSMT10-12-150W BSIP10-12-180W / BSMT10-12-180W BSIP10-12-200W / BSMT10-12-200W BSIP10-12-250W / BSMT10-12-250W BSIP10-12-330W / BSMT10-12-330W BSIP10-12-500W / BSMT10-12-500W 6.0 -14 Vdc 6.0 -14 Vdc 6.0 -14 Vdc 6.0 -14 Vdc 6.0 -14 Vdc 6.0 -14 Vdc 6.0 -14 Vdc 6.5 -14 Vdc 0.75 Vdc 1.2 Vdc 1.5 Vdc 1.8 Vdc 2.0 Vdc 2.5 Vdc 3.3 Vdc 5.0 Vdc 10A 10A 10A 10A 10A 10A 10A 10A 40 mA 40 mA 50 mA 40 mA 60 mA 65 mA 75 mA 95 mA 762 mA 1149 mA 1404 mA 1666 mA 1832 mA 2264 mA 2956 mA 4386 mA 82 87 89 90 91 92 93 95 Broadband TelCom Power, Inc. – 1719 S. Grand Avenue, Santa Ana, CA 92705 U.S.A. Tel.: 714-259-4888 • Fax: 714-259-0840• www.btcpower.com • Email: sales@btcpower.com DS BSIP10-12W Rev1 10-26-04 BSIP10-12W Series Specifications Input Specifications: 10A SIP&SMT 12Vi DC-DC Converters BTCPower TM Input Voltage Range…………….………12V………………... 6.0-14V Under voltage lock-out ………………power up ……………5.0V Typ. Power down ………..4.0V Typ. Input Filter……………………………………………………Capacitive Positive remove on /off control: Module On …………………………Open circuit or =Vin Module Off …………………………………….. < 0.4Vdc Output Specifications: Voltage Accuracy…………….. ………………………….+/- 1.5 % max. Transient response : 25% step load change ……………< 200 u sec. Ripple & Noise, 20 MHz BW (note3)………………….50 mV p-p max. 5Vo ………………………………...75 mV p-p max. Temperature Coeffcient………………………… +/- 0.03 % / ºC max. Short Circuit Protection………………………………..……Continuous Line Regulation (note1) ………………………….……..+/- 0.2 % max. Load Regulation (note2) …… …………….…….….….+/- 0.5 % max. Capacitive load, low ESR…………………………………8000uF max. Sequencing delay time …………………………….……….20 ms max. Sequencing slew rate capacibility (dVseq/dt) …………0.1-1.0V / ms. Tracking accuracy ………………………power up ……..200 mv max. Power down …….400 mv max. Power good signal asserted logic high ….… Vo = 90% - 110%, nom. General Specifications: Efficiency………………………………………………..……...see table Isolation Resistance………………………………………Non-isolation Switching Frequency……………………………………..300 KHz, Typ. Over temperature protection ………………….………….. 130 ºC Typ. Operating Temperature Range…………………………-40ºC ~ +85ºC Case Temperature………………………………………….100 ºC max. Power derating curve …………………………………….. see fig. 1,2. Storage Temperature Range……………………..…..-55 ºC ~ +125ºC Dimensions: SIP package: 2.0” x 0.51” x 0.327“ (50.8 x 12.95 x 8.3 mm) SMT package: 1.3” x 0.53” x 0.346” (33.0 x 13.46 x 8.8 mm) Structure …………………………..Non-potted with open frame type Note: 1. 2. 3. 4. 5. Measured from high line to low line; Measured from full load to zero load; Measured with 10uF tantalum capacitor and 1 uF ceramic capacitor across output The input terminal recommend to parallel with 100uF capacitor ESR < 100 mohm Suffix “N” to the model number with Negative logic remote Model On: Open circuit or < 0.4Vdc Model Off: > +2.8Vdc to Vin 6. Suffix “P” to the model number with Power Good function Outline Information and Pin-out SMT Outline information Broadband TelCom Power, Inc. – 1719 S. Grand Avenue, Santa Ana, CA 92705 U.S.A. Tel.: 714-259-4888 • Fax: 714-259-0840• www.btcpower.com • Email: sales@btcpower.com DS BSIP10-12W Rev1 10-26-04 BSIP10-12W Series 10A SIP&SMT 12Vi DC-DC Converters BTCPower TM SIP Outline Inforamtion Dimensions are in Inches (millimeters) Tolerances: .XX ± 0.2” (.X ±0.5), unless otherwise noted .XXX ±0.01” (.XX ±0.25) PIN CONNECTION Pin 1 2 3 4 5 6 7 8 9 10 11 12 Function + Output + Output + Sense + Output Common No pin / PGood Common + V Input + V Input Squency Trim On / Off Control Broadband TelCom Power, Inc. – 1719 S. Grand Avenue, Santa Ana, CA 92705 U.S.A. Tel.: 714-259-4888 • Fax: 714-259-0840• www.btcpower.com • Email: sales@btcpower.com DS BSIP10-12W Rev1 10-26-04 BSIP10-12W Series 10A SIP&SMT 12Vi DC-DC Converters BTCPower TM Product Brief Temperature Typical Derating Curve Fig 1.: Typical Derating Curve of BSIP10-12W series Fig 2.: Typical Derating Curve of BSMT10-12W series Trim Resistor Values Vo (set) (V) 0.75 1.2 1.5 1.8 2 2.5 3.3 3.63 Fig 3.: Simplified Schematic Rtrim (Kohm) Open 22.46 13.05 9.024 7.417 5.009 3.122 1.472 The information and specifications contained in this brief are believed to be accurate and reliable at the time of publication. Specifications are subject to change without notice. Refer to product specification sheet for performance characteristics and application guidelines. Broadband TelCom Power, Inc. – 1719 S. Grand Avenue, Santa Ana, CA 92705 U.S.A. Tel.: 714-259-4888 • Fax: 714-259-0840• www.btcpower.com • Email: sales@btcpower.com DS BSIP10-12W Rev1 10-26-04