User's Guide
SNVA134B – February 2007 – Revised April 2013
AN-1416 LP3991TL DSBGA Evaluation Board Information
1
Introduction
This board is designed to allow the evaluation of the LP3991 low voltage CMOS regulator. Each board is
pre-assembled and tested in the factory. The board contains the LP3991 in a 4 bump DSBGA package
and input and output capacitors connected to GND . The LP3991 is capable of operating with an input
voltage as low as 1.65 V for output voltage options of 1.5 V or less. The LP3991 can supply a maximum
output current of 300 mA and is particularly suitable for powering digital circuits, where good transient
behavior is required. It can be employed in applications requiring post regulation of switching regulators to
provide maximum efficiency in battery powered products.
2
Operation
The input voltage, applied between VIN and GND should be at least 0.5 V above the output voltage with a
minimum of 1.65 V and a maximum of 3.3 V. For output voltages of 1.5 V or higher, the LP3991 will
operate with an input voltage of only 0.2 V above VOUT. However, some loss in performance of PSSR and
transient behavior can be expected when operating the device with such a low VIN to VOUT difference. Input
connections should be kept reasonably short (
很抱歉,暂时无法提供与“LP3991TL-1.5EV”相匹配的价格&库存,您可以联系我们找货
免费人工找货