1N4572

• 1N4565A-1 THRU 1N4584A-1 AVAILABLE IN JAN, JANTX, JANTXV AND JANS PER MIL-PRF-19500/452 • 6.4 VOLT NOMINAL ZENER VOLTAGE + 5% • TEMPERATURE COMPENSATED ZENER REFERENCE DIODES • METALLURGICALLY BONDED 1N4565 thru 1N4584A and 1N4565A-1 thru 1N4584A-1 MAXIMUM RATINGS Operating Temperature: -65°C to +175°C Storage Temperature: -65°C to +175°C DC Power Dissipation: 500mW @ +50°C Power Derating: 4 mW / °C above +50°C REVERSE LEAKAGE CURRENT lR = 2µA @ 25°C & VR = 3Vdc ELECTRICAL CHARACTERISTICS @ 25°C, unless otherwise specified. JEDEC TYPE NUMBER ZENER TEST CURRENT EFFECTIVE TEMPERATURE COEFFICIENT VOLTAGE TEMPERATURE STABILITY ( ∆ VZT MAX) (Note 1) mV 48 100 24 50 10 20 5 10 2.5 5 48 100 24 50 10 20 5 10 2.5 5 48 100 24 50 10 20 5 10 2.5 5 48 100 24 50 10 20 5 10 2.5 5 TEMPERATURE RANGE MAX. DYNAMIC ZENER IMPEDANCE (Note 2) °C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C 0 to + 75°C -55 to + 100°C OHMS 200 200 200 200 200 200 200 200 200 200 100 100 100 100 100 100 100 100 100 100 50 50 50 50 50 50 50 50 50 50 25 25 25 25 25 25 25 25 25 25 mA 1N4565 1N4565A 1N4566 1N4566A 1N4567 1N4567A 1N4568 1N4568A 1N4569 1N4569A 1N4570 1N4570A 1N4571 1N4571A 1N4572 1N4572A 1N4573 1N4573A 1N4574 1N4574A 1N4575 1N4575A 1N4576 1N4576A 1N4577 1N4577A 1N4578 1N4578A 1N4579 1N4579A 1N4580 1N4580A 1N4581 1N4581A 1N4582 1N4582A 1N4583 1N4583A 1N4584 1N4584A .5 .5 .5 .5 .5 .5 .5 .5 .5 .5 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 2.0 2.0 2.0 2.0 2.0 2.0 2.0 2.0 2.0 2.0 4.0 4.0 4.0 4.0 4.0 4.0 4.0 4.0 4.0 4.0 %/°C .01 .01 .005 .005 .002 .002 .001 .001 .0005 .0005 .01 .01 .005 .005 .002 .002 .001 .001 .0005 .0005 .01 .01 .005 .005 .002 .002 .001 .001 .0005 .0005 .01 .01 .005 .005 .002 .002 .001 .001 .0005 .0005 FIGURE 1 DESIGN DATA CASE: Hermetically sealed glass case. DO – 35 outline. LEAD MATERIAL: Copper clad steel. LEAD FINISH: Tin / Lead POLARITY: Diode to be operated with the banded (cathode) end positive. MOUNTING POSITION: ANY. NOTE 1 NOTE 2 The maximum allowable change observed over the entire temperature range i.e., the diode voltage will not exceed the specified mV at any discrete temperature between the established limits, per JEDEC standard No.5. Zener impedance is derived by superimposing on lZT A 60Hz rms a.c. current equal to 10% of lZT. 2 2 COREY STREET, MELROSE, MASSACHUSETTS 02176 PHONE (781) 665-1071 FAX (781) 665-7379 WEBSITE: http://www.cdi-diodes.com E-mail: mail@cdi-diodes.com 1N4565 +.0015 +.0010 +.0005 0 CHANGE IN TEMPERATURE COEFFICIENT ( %/°C) -.0005 -.0010 -.0015 thru 1N4584A INCLUDING -1 VERSIONS 1N4570-1N4574 1N4565-1N4569 .1 .2 .3 .4 .5 .6 .7 .8 OPERATING CURRENT lZT (mA) .9 .25 .5 1.0 1.5 2.0 OPERATING CURRENT lZT (mA) +.0010 +.0005 0 -.0005 -.0010 -.0015 1N4575-1N4579 1N4580-1N4584 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 OPERATING CURRENT lZT (mA) 4.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 OPERATING CURRENT lZT (mA) 6.0 TYPICAL CHANGE OF TEMPERATURE COEFFICIENT WITH CHANGE IN OPERATING CURRENT 10000 5000 ZENER IMPEDANCE ZZT (OHMS) 10000 1N4565-1N4574 ZENER IMPEDANCE ZZT (OHMS) 5000 1N4575-1N4584 1000 500 1000 500 100 50 100 50 10 .25 .5 1.0 1.5 2.0 2.5 3.0 3.5 OPERATING CURRENT IZT (mA) 10 1.0 2.0 3.0 4.0 5.0 6.0 OPERATING CURRENT IZT (mA) ZENER IMPEDANCE VS. OPERATING CURRENT