FR1014GP

Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 FR1012GP THRU FR1020GP 1 Amp Glass Passivated Rectifier 1200 to 2000 Volts DO-41 Features • • • • • • Low Cost Low Leakage Low Forward Voltage Drop High Current Capability Fast Switching Speed For High Efficiency Glass Passivated Junction • • Maximum Ratings Device Marking Operating Temperature: -55 °C to +150°C Storage Temperature: -55°C to +150°C Maximum Recurrent Peak Reverse Voltage 1200V 1400V 1600 V 1800V 2000V Maximum RMS Voltage 840V 980V 1120 V 1260V 1400V Maximum DC Blocking Voltage 1200V 1400V 1600V 1800V 2000V Catalog Number FR1012GP FR1014GP FR1016GP FR1018GP FR1020GP D ------------ A Cathode Mark B Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage 18-20 Maximum DC Reverse Current At Rated DC Blocking Voltage IF(AV) IFSM 1A 30A TA = 55°C 8.3ms, half sine IFM = 1.0A; TA = 25°C D C VF 1.35V 1.50V 5.0µA 100µA DIMENSIONS INCHES MIN .166 .080 .028 1.000 MM MIN 4.10 2.00 .70 25.40 IR TA = 25°C TA = 100°C DIM A B C D MAX .205 .107 .034 --- MAX 5.20 2.70 .90 --- NOTE Maximum Reverse Recovery Time 300ns IF=0.5A, IR=1.0A, FR1012-1016 Trr 500ns Irr=0.25A FR1018-1020 Typical Junction CJ 15pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse Test: Pulse Width 300 µsec, Duty Cycle 1% www.cnelectr.com FR1012GP thru FR1020GP Figure 1 Typical Forward Characteristics 20 10 6 4 1.0 2 Amps 1 .6 .4 .2 .1 .06 .04 .02 .01 .4 .6 .8 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts 1.0 12 1.4 0 .2 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 50 75 100 °C Average Forward Rectified Current - Amperes ersus v Ambient Temperature - °C 125 150 175 Amps .4 25°C 1.2 Figure 2 Forward Derating Curve .8 .6 Figure 3 Junction Capacitance 100 60 40 20 pF 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 TJ=25°C Junction Capacitance - pFversus Reverse Voltage - Volts www.cnelectr.com FR1012GP thru FR1020GP Figure 4 Peak Forward Surge Current 60 50 40 30 Amps 20 10 0 1 4 6 8 10 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles 20 40 60 80 100 2 Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive www.cnelectr.com