CZRT55C3V9-G

Surface Mount Zener Diodes CZRT55C2V4-G thru CZRT55C39-G Voltage: 2.4 ~ 29 Volts Power: 410 mW Features: Planar Die Constructions 500mW Power Dissipation Zener Voltages from 2.4V ~ 39V Ideally Suited for Automated Assembly Processes .119 (3.0) .110 (2.8) .020 (0.5) SOT-23 Top View Mechanical Data: Case: SOD-23, Plastic Terminals: Solderable per MIL-STD-202, Method 208 Approx. Weight: 0.008 gram .037 (0.95) .037 (0.95) .056 (1.40) .047 (1.20) .006 (0.1) max. .029(0.5) .020 (0.5) .103 (2.6) .086 (2.2) Dimensions in inches (millimeters) Maximum Ratings and Thermal Characterics Parameter Power Dissipation (Note A) at 75oC Peak Forward Surge Current Surge, 8.3ms Single Half Sine-Wave Superimposed on Rated Load (JEDEC Method) (Note B) Operating Junction and Storage Temperature Range Symbols Value 410 Units mW PD IFSM TJ 2 Amps oC -55 to +150 Notes: A. Mounted on 5.0mm2(.013mm thick) land areas. B. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum. “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com .044 (1.15) .035 (0.90) P age1 Circuit Schematic: .006 (0.15) .002 (0.05) Surface Mount Zener Diodes CZRT55C2V4-G thru CZRT55C39-G Maximum Ratings and Electrical Characterics (TA=25°C unless otherwise noted) V F=1.2V max, I F=100mA for all types Nominal Zener Voltage Part Number VZ @ IZT Nom. V Min. V Max. V Max. Zener Impedance ZZT @ IZT Ohm mA ZZK @ IZK Ohm mA Max Reverse Leakage Current IR @ VR nA V Typical Temp. Coefficient TC Max Zener Current IZM@ TA mA 410 mWatts Zener Diodes CZRT55C2V4-G CZRT55C2V7-G CZRT55C3V0-G CZRT55C3V3-G CZRT55C3V6-G CZRT55C3V9-G CZRT55C4V3-G CZRT55C4V7-G CZRT55C5V1-G CZRT55C5V6-G CZRT55C6V2-G CZRT55C6V8-G CZRT55C7V5-G CZRT55C8V2-G CZRT55C9V1-G CZRT55C10-G CZRT55C11-G CZRT55C12-G CZRT55C13-G CZRT55C15-G CZRT55C16-G CZRT55C18-G CZRT55C20-G CZRT55C22-G CZRT55C24-G CZRT55C27-G CZRT55C30-G CZRT55C33-G CZRT55C36-G CZRT55C39-G 2.4 2.7 3.0 3.3 3.6 3.9 4.3 4.7 5.1 5.6 6.2 6.8 7.5 8.2 9.1 10.0 11.0 12.0 13.0 15 16 18 20 22 24 27 30 33 36 39 2.28 2.5 2.8 3.1 3.4 3.7 4 4.4 4.8 5.2 5.8 6.4 7 7.7 8.5 9.4 10.4 11.4 12.4 13.8 15.3 16.8 18.8 20.8 22.8 25.1 28 31 34 37 2.56 2.9 3.2 3.5 3.8 4.1 4.6 5 5.4 6 6.6 7.2 7.9 8.7 9.6 10.6 11.6 12.7 14.1 15.6 17.1 19.1 21.2 23.3 25.6 28.9 32 35 38 41 85 83 95 95 95 95 95 78 60 40 10 8 7 7 10 15 20 20 25 30 40 50 50 55 80 80 80 80 90 90 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 600 500 500 500 500 500 500 500 480 400 200 150 50 50 50 70 70 90 110 110 170 170 220 220 220 250 250 250 250 300 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 100000 75000 50000 25000 15000 10000 5000 5000 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 1 1 1 1 1 1 1 2 0.8 1 2 3 5 6 7 7.5 8.5 9 10 11 12 14 15 17 18 20 22.5 25 27 29 -0.075 -0.065 -0.06 -0.055 -0.055 -0.05 -0.035 -0.015 0.005 0.02 0.03 0.045 0.05 0.055 0.065 0.07 0.075 0.08 0.08 0.09 0.09 0.09 0.09 0.09 0.09 0.09 0.09 0.09 0.09 0.11 134 118 109 100 92 84 76 67 59 54 49 44 40 36 33 30 28 25 23 20 18 17 16 13 12 10 9 9 8 NOTE: 1.Tolerance and Type Number Designation. The type numbers listed have a standard tolerance on the nominal zener voltage of ±5%. 2.Specials Available Include: A. Nominal zener voltages between the voltages shown and tighter voltage tolerances. B. Matched sets. 3.Zener Voltage (VZ) Measurement. Guarantees the zener voltage when measured at 90 seconds while maintaining the lead temperature (TL) at 30OC, from the diode body. 4.Zener Impedance (ZZ) Derivation. The zener impedance is derived from the 60 cycle ac voltage, which results when an AC current having an rms value equal to 10% of the dc zener current (IZT or IZK) is superimposed on IZT or IZK. 5.Surge Current (IR) Non-Repetitive. The rating listed in the electrical characteristics table is maximum peak, non-repetitive, reverse surge current of 1/2 square wave or equivalent sine wave pulse of 1/120 second duration superimposed on the test current, IZT, per JEDEC registration; however, actual device capability is as described in Figure 5. “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com P age2 Surface Mount Zener Diodes CZRT55C2V4-G thru CZRT55C39-G Rating and Characteristic Curves 8 7 100 TEMPERATURE COEFFICIENT,mV/ o C) 6 5 4 3 2 1 0 -1 -2 -3 2 3 4 5 6 7 8 9 10 11 12 TEMPERATURE COEFFICIENT,mV/ o C) 10 1 10 100 NOMINAL ZENER VOLTAGE, Volts NOMINAL ZENER VOLTAGE, Volts TYPICAL REVERSE CURRENT 1000 1000 DYNAMIC IMPEDANCE, IZ = 1 mA FORWARD CURRENT, mA TJ=25 C IZ(AC)=0.1IZ(DC) F=1 kHZ O 100 5 mA 20 mA 100 10 10 150OC 75OC 25OC 5C O 1 1 10 NORMAL ZENER VOLTAGE, Volts 100 1 0.4 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 FORWARD VOLTAGE, Volts TYPICAL FORW ARD VOL TAGE 1.2 1.0 0.8 0.6 1000 0 V BIAS 1 V BIAS 100 BIAS AT 50% OF VZ NOM 10 TA=25oC POWER DISSIPATION, Watts PD V.S. TA 0.4 0.2 0 CAPACITANCE, pF 75 100 o 25 50 125 150 155 1 1 10 NOMINAL ZENER VOLTAGE, Volts 100 TEMPERATURE ( C) “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com P age3 Surface Mount Zener Diodes CZRT55C2V4-G thru CZRT55C39-G Rating and Characteristic Curves 100 TA=25 C ZENER CURRENT, mA ZENER CURRENT, mA o 100 TA=25 C o 10 10 1 1 0.1 0.1 0.01 0 2 4 6 8 10 12 0.01 10 30 50 70 90 ZENER VOLTAGE, Volts ZENER VOLTAGE, Volts ZENER VOL TAGE V.S. ZENER CURRENT 1000 LEAKAGE CURRENT ( A) 100 10 1 0.1 0.01 0.001 0.0001 0.00001 0 10 20 30 40 50 60 70 +150 C O +25 C -55 C 80 90 O O NOMINAL ZENER VOLTAGE, Vlots “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com P age4