CZRW5230

Surface Mount Zener Diodes COMCHIP www.comchip.com.tw C ZR W 5221 - C ZR W 5259 V oltage: 2 .4 - 39 Volts Power : 500mW FEATURES Planar Die constructions 500mW Power Dissipation Zener Voltages from 2.4V - 39V . 028(0.70) . 019(0.50) .154 (3.90) .141 (3.60) .110 (2.80) .098 (2.50) SOD-123 . 071(1.80) . 053(1.35) . 055(1.40) Ideally Suited for Automated Assembly Processes MECHANICAL DATA Case: SOD-123, Molded Plastic . 008(0.20) Max. . 037(0.95) Terminals: Solderable per MIL-STD-202, Method 208 Polarity: See Diagram Below Approx. Weight: 0.008 grams Mounting Position: Any .005 (.12) MAX. .016 (.40)Min. Dimensions in inches and (millimeters) Maximum Ratings and Electrical Characterics Parameter Power Dissipation (Note A) at 75°C Peak Forward Surge Current Surge, 8.3ms Single Half Sine-wave Superimposed on Rated Load (JEDEC Method) (Note B) Operating Junction and Storage Temperature Range Symbol PD IFSM TJ Value 500 4 -55 to +150 Units mW A °C NOTES: A. Mounted on 5.0mm 2(.013mm thick) land areas. B. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum. M DS020800 5 A Page 1 Surface Mount Zener Diodes Maximum Ratings and Electrical Characterics (TA=25 unless otherwise noted) VF=1.2V, IF=100m A for all types COMCHIP www.comchip.com.tw Nominal Zener Voltage Part Number Nom. V CZRW5221 CZRW5222 CZRW5223 CZRW5225 CZRW5226 CZRW5227 CZRW5228 CZRW5229 CZRW5230 CZRW5231 CZRW5232 CZRW5234 CZRW5235 CZRW5236 CZRW5237 CZRW5239 CZRW5240 CZRW5241 CZRW5242 CZRW5243 CZRW5245 CZRW5246 CZRW5248 CZRW5250 CZRW5251 CZRW5252 CZRW5254 CZRW5255 CZRW5256 CZRW5257 CZRW5258 CZRW5259 NOTE: NOTE: Max. Zener Impedance ZZT @ IZT Ohm mA 30 30 30 30 28 24 23 22 19 17 11 7 5 6 8 10 17 22 30 13 16 17 21 25 29 33 41 44 49 58 70 80 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 9.5 8.5 7.8 7 6.2 5.6 5.2 5 4.5 4.2 3.8 3.4 3.2 ZZK @ IZK Ohm mA 1200 1250 1300 1600 1600 1700 1900 2000 1900 1600 1600 1000 750 500 500 600 600 600 600 600 600 600 600 600 600 600 600 600 600 700 700 800 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 Max Reverse Leakage Current IR @ VR nA V 100 100 75 50 25 15 10 5 5 5 5 5 3 3 3 3 3 3 2 1 0.5 0.1 0.1 0.1 0.1 0.1 0.1 0.1 0.1 0.1 0.1 0.1 1 1 1 1 1 1 1 1 2 2 3 4 5 6 6 6.5 8 8.4 9.1 9.9 11 12 14 15 17 18 21 21 23 25 27 30 VZ @ IZT Min. V Max. V 2.28 2.38 2.57 2.85 3.14 3.42 3.71 4.09 4.47 4.85 5.32 5.89 6.46 7.13 7.79 8.65 9.5 10.45 11.4 12.35 14.25 15.2 17.1 19 20.9 22.8 25.65 26.6 28.5 31.35 34.2 37.05 2.52 2.63 2.84 3.15 3.47 3.78 4.1 4.52 4.94 5.36 5.88 6.51 7.14 7.88 8.61 9.56 10.5 11.55 12.6 13.65 15.75 16.8 18.9 21 23.1 25.2 28.35 29.4 31.5 34.65 37.8 40.95 Max Zener Current IZM@ TA mA 188 180 167 150 138 126 115 106 97 89 81 73 67 61 55 50 45 41 38 35 30 28 25 23 21 19.1 16.8 16.2 15.1 13.8 12.6 11.6 500 mWatts Zener Diodes 2.4 2.5 2.7 3 3.3 3.6 3.9 4.3 4.7 5.1 5.6 6.2 6.8 7.5 8.2 9.1 10 11 12 13 15 16 18 20 22 24 27 28 30 33 36 39 1. Tolerance and Type Number Designation. The type numbers listed have a standard tolerance on the nominal zener voltage of ±5%. 2. Specials Available Include: A. Nominal zener voltages between the voltages shown and tighter voltage tolerances. B. Matched sets. 3.Zener Voltage (VZ) Measurement. Guarantees the zener voltage when measured at 90 seconds while maintaining the lead temperature (TL) at 30OC, from the diode body. 4. Zener Impedance (ZZ) Derivation. The zener impedance is derived from the 60 cycle ac voltage, which results when an AC current having an rms value equal to 10% of the dc zener current (IZT or IZK) is superimposed on IZT or IZK. 5. Surge Current (IR) Non-Repetitive. The rating listed in the electrical characteristics table is maximum peak, non-repetitive, reverse surge current of 1/2 square wave or equivalent sine wave pulse of 1/120 second duration superimposed on the test current, IZT, per JEDEC registration; however, actual device capability is as described in Figure 5. MDS0208005A Page 2 Surface Mount Zener Diodes COMCHIP COMCHIP www.comchip.com.tw 8 7 100 TEMPERATURE COEFFICIENT,mV / oC) 6 5 4 3 2 1 0 -1 -2 -3 2 3 4 5 6 7 8 9 10 11 12 TEMPERATURE COEFFICIENT,mV / oC) 10 1 10 100 NOMINAL ZENER VOLTAGE, Volts NOMINAL ZENER VOLTAGE, Volts TYPICAL REVERSE CURRENT STEADY STATE POWER DERATING 1000 DYNAMIC IMPEDANCE, W 1000 FORWARD CURRENT, mA IZ = 1 mA TJ=25 C IZ(AC)=0.1IZ(DC) F=1 kHZ O 100 5 mA 20 mA 100 10 10 150 C 75OC O 25 C O 5C O 1 1 10 NORMAL ZENER VOLTAGE, Volts 100 1 0.4 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 FORWARD VOLTAGE, Volts TYPICAL FORWARD VOLTAGE 1.2 1.0 0.8 0.6 1000 0 V BIAS 1 V BIAS 100 BIAS AT 50% OF VZ NOM 10 TA=25oC POWER DISSIPATION, Watts PD V.S. TA 0.4 0.2 0 CAPACITANCE, pF 75 100 125 150 155 25 50 1 TEMPERATURE (oC) 1 10 NOMINAL ZENER VOLTAGE, Volts 100 STEADY STATE POWER DERATING M DS020800 5 A TYPICAL CAPACITANCE Page 3 Surface Mount Zener Diodes COMCHIP COMCHIP www.comchip.com.tw 100 TA=25 C ZENER CURRENT, mA ZENER CURRENT, mA o 100 TA=25 C o 10 10 1 1 0.1 0.1 0.01 0 2 4 6 8 10 12 0.01 10 30 50 70 90 ZENER VOLTAGE, Volts ZENER VOLTAGE, Volts ZENER VOLTAGE V.S. ZENER CURRENT ZENER VOLTAGE V.S. ZENER CURRENT 1000 LEAKAGE CURRENT (mA) 100 10 1 0.1 0.01 0.001 0.0001 0.00001 0 10 20 30 40 50 60 70 +150 C O +25OC -55 C 80 90 O NOMINAL ZENER VOLTAGE, Vlots TYPICAL LEAKGE CURRENT M DS020800 5 A Page 4