4STD09PAM99A10X

F E Solder Instruction D C B A b 1. Cable should be prepared for soldering. The cable/wires must be pretinned. 2. Insert cable/wire into solder cup. 3. Operate the soldering iron at 350°C, 50 Watt max. and use a pencil tip. 4. Put tip to wire in solder cup. 5. After 1 second bring in solder. D b 6. Heat for 3 seconds longer. Do not heat contact more than 4 seconds in total. Ø1,12 (9x) (5:1) D 7. Remove soldering iron. 8. Wait until solder gets rigid again. 9. Do not solder adjacent contacts consecutively, SEALING COMPOUND 0,9 9,5 `0,3 alternate position within the connector to minimize heat build up. b 6 +- 0,12 0,18 30,88 +- 0,31 0,45 0,12 25 +- 0,13 16,84 +- 0,2 0,05 8,26 +- 0,02 0,23 12,6 +- 0,33 0,43 C RUBBER-GASKET PLACED ON TOP SURFACE OF MALE INSULATOR 10° POS. 1 C POS. 6 1,4 +- 00,4 b 4STD09PoM99A10X CONEC ABC Ø3,1 `0,1 B SEE NOTE 6 B NOTES: b 1. METALSHELLS: COPPER ALLOY; min. 315µin TIN over 40-80µin NICKEL 2. INSULATORS: PBT GF UL 94 V-0; BLACK 3. SIGNAL CONTACTS: COPPER ALLOY; PLATING (SEE PART NO.) o PLEASE ADD C for 30µin HARD GOLD over min. 50µin NICKEL o PLEASE ADD B for 20µin HARD GOLD over min. 50µin NICKEL o PLEASE ADD A for GOLD FLASH over NICKEL (PREFERRED TYPE) SOLDER CUP ACCEPTS CABLE AWG 20 4. SEALING COMPOUND: PUR; BLUE 5. RUBBER-GASKET: TPE; BLACK Directive 2002/95/EC RoHS compliant F E DO NOT ALTER CAD DRAWING BY HAND A THIS DRAWING MAY NOT BE COPIED OR REPRODUCED IN ANY WAY, AND MAY NOT BE PASSED ON TO A THIRD PARTY WITHOUT WRITTEN PERMISSION. OWNERSHIP AND COPYRIGHT OF CONEC GmbH 6. CONNECTOR IS PART MARKED: 4STD09PoM99A10X CONEC ABC (see note 3) scale: material: tolerance 2:1 (5:1) SEE NOTES dim. in mm date name drawn 22.08.12 Henneboel D-SUB MALE appd. 22.08.12 Fischer 9pos. SOLDER CUP for installation into water resistant hood dwg no: DIN- norm d-old 6xb Ä4434 a Original rev. description D A title: 18K1IB3A/18K1A232 22.08.2012 K.H. 15K1A1132 R date name part no: C A3 sh: 1 b 4STD09PoM99A10X (see note 3) B A