OVC3CF4AA

THE THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM www.conwin.com P R O D UP R O D U T AT SD A TEA CT DAC HE T SHEET CRYSTAL CONTROLLED OSCILLATORS STRATUM 3E LVCMOS OCVCXO 3.3V ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature Supply Voltage Input Voltage UNITS (Vcc) MINIMUM -55 -0.5 -0.5 NOMINAL MAXIMUM 125 4.5 Vcc+0.5 UNITS °C Vdc Vdc TABLE 2.0 MINIMUM (Fo) -0.2 -10 -1 -30 -40 3.13 -0.5 -0.5 -100 NOMINAL 10, 12.8,20 5.00E-11 3.30 5 MAXIMUM 0.2 10 1 30 300 70 3.47 0.5 0.5 4.0 1.25 500 100 5 1 UNITS MHz ppm ppb ppb/day ppb RMS ppb °C Vdc ppb ppb W W mS ppb ppb/G nS nS NOTE 1 2 3 4 5 TABLE 1.0 NOTE CONNOR WINFIELD MODEL OVC3CF4AA FREQUENCY 10.000MHz 0021 DATE CODE CAL. FREQ. 10.000000 OPERATING SPECIFICATIONS PARAMETER Center Frequency Frequency Calibration (Vc= 1.65 Vdc) Frequency Stability Aging: Daily Aging: First Year Aging: Short Term (1Sec.) Aging: Long Term (20 Years) Operating Temperature Range Supply Voltage Voltage Stability (+/-1%) Load Stability (+/-20%) Power Consumption: Turn On Power Consumption: Steady-State Start-Up Time Warm Up 2G Tip-over TDEV at 300 seconds TDEV at 40 seconds OVC3CF4AA DESCRIPTION (Vcc) 6 6 7 8 9 9 TABLE 3.0 The Connor-Winfield OVC3CF4AA is a 3.3V Voltage Controlled Oven Controlled Crystal Oscillator (OCVCXO) with an LVCMOS output. The OVC3CF4AA is designed for Stratum 3E applications requiring low jitter and tight frequency stability. INPUT CHARACTERISTICS PARAMETER Control Voltage (Pin 1) Deviation @ 25°C referenced to Fo Input Impedance (Pin 1) Vc MINIMUM 0.3 ±0.3 50K NOMINAL 1.65 MAXIMUM 3.3 ±1.0 UNITS Vdc ppm Ohm FEATURES DESIGNED TO MEET STRATUM 3E REQUIREMENTS VARIABLE FREQUENCY (OVCCXO) NOTE 10 LVCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% Spurious Output SSB Phase Noise at 1Hz offset SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset MINIMUM 12 Vcc-0.2V 45 NOMINAL 15 50 MAXIMUM 18 0.2 55 5 -80 -90 -115 -130 -140 -150 UNITS pF Vdc Vdc % nS dBc dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz TABLE 4.0 NOTE 11 FREQUENCY STABILITY ±10ppb TEMPERATURE RANGE -40 to 70°C 3.3V OPERATION LVCMOS OUTPUT RoHS 5/6 COMPLIANT (Voh) (Vol) ORDERING INFORMATION TABLE 5 .0 NOTE 12 12 12 12 12 RESTABILIZATION TIME Off Time < 1 Hour < 6 Hours < 24 Hours 1 to 16 Days > 16 Days Restabilization Time < 2 Hours < 12 Hours < 48 Hours 48 Hours + ¼ Off Time < 6 Days OVC3CF4AA OCXO SERIES - 010.0M CENTER FREQUENCY DATA SHEET #: DATA SHEET #: Cx133 Cx133 PAGE PAGE 11 OF OF 22 REV: 00 REV: 01 DATE: 8/17/07 DATE: 01/17/08 Specifications subject to change without notice. aCopyright 2008 Connor-Winfield all rights reserved. Copyright 2001 Connor-Winfield all rights reserved. THE THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM www.conwin.com P R O D UP R O D U T AT SD A TEA CT DAC HE T SHEET PACKAGE CHARACTERISTICS Package Solder Process CRYSTAL CONTROLLED OSCILLATORS TABLE 6.0 Metal package: solder sealed, grounded case, solder tinned pins. RoHS 5/6 compliant, see solder profile below. TABLE 7.0 100G’s, 6mS, halfsine per MIL-STD-202F, Method 213B, Test Condition C 0.06” D.A. or 10G peak 10 to 500 Hz, per MIL-STD-202F, Method 204D, Test condition A Pin Connections CONTROL VOLTAGE ENVIRONMNETAL CHARACTERISTICS Shock Vibration Notes: 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) Labels will include the calibration frequency at the time of ship. Initial calibration @ 25 C, Vc=1.65Vdc, at time of shipment. Frequency vs. temperature stability, referenced to 25 C. After ten days of continuous operation. Allen Variance: 1 second, 100 average. Vcc = 3.3Vdc. From Vcc=90% of final value. No more than 16 transitions at start-up before oscillator has started. Measured @ -40 C, within 5 minutes, referenced one hour after turn-on. After stabilization in a controlled airflow environment. At time of delivery. LVCMOS load. For a given off time, the time required to meet daily aging, short-term stability and TDEV requirements. Labeling Diagram MODEL OVC3CF4AA FREQUENCY 10.000MHz DATE CODE 0021 CAL. FREQ. 10.000000 Package Outline .500 12.700mm Test Circuit Temperature 225°C 183°C 150°C Solder Profile Ramp-Up Rate 3°C/second max. from 150°C to 225°C. Ramp-Down Rate 6°C/second max. 225°C tp +3.3Vdc 100°C CONTROL VOLTAGE (Vc) 25°C 0 60-120s Max. 360 Sec. Max. 10-30s 60-150s Max. Time Specifications subject to change without notice. DATA SHEET #: DATA SHEET #: Cx133 Cx133 PAGE 2 PAGE 1 OF OF 2 2 REV: 01 REV: 00 DATE: DATE: 8/17/07 01/17/08 aCopyright 2001 Connor-Winfield all rights reserved. aCopyright 2008 Connor-Winfield all rights reserved.