84140801H

Panel Mount Datasheet Dual GN Series • Current rating 25 and 40 Amps • Output voltage 24-280 VAC and 48-660 VAC • Direct bond copper substrate • Back to back dual SCR output • 4000 VAC optical isolation • Zero Voltage and Instantaneous Turn-On • UL/cUL Recognized, CE Compliant PRODUCT SELECTION 1/4” Quick Connect 280 VAC 25 A 40 A Control Voltage 1/4” Quick Connect 660 VAC 40 A 25 A Locking Connector 280 VAC 25 A 40 A 4-15 VDC 84140000 84140200 84140500 84140600 84140800 84140900 17-32 VDC 84140410 84134210 84140510 84140610 84140810 84140910 AVAILABLE OPTIONS Series Rated Load Current Control Voltage Operating Voltage 84140 0 1 U 0 0: 24-280 VAC 1/4” Quick Connect 280 VAC 0: 25 Amp/Zero Voltage Turn-On 1: 25 Amp/Instantaneous Turn-On 2: 40 Amp/Zero Voltage Turn-On 3: 40 Amp/Instantaneous Turn-On 0: 4-15 VDC 1: 17-32 VDC 1/4” Quick Connect 660 VAC 5: 25 Amp 6: 40 Amp 0: 4-15 VDC 1: 17-32 VDC 0: 48-660 VAC/Zero Voltage Turn-On 1: 48-660 VAC/Instantaneous Turn-On Locking Connector 280 VAC 8: 25 Amp 9: 40 Amp 0: 4-15 VDC 1: 17-32 VDC 0: 24-280 VAC/Zero Voltage Turn-On 1: 24-280 VAC/Instantaneous Turn-On OUTPUT SPECIFICATIONS (1) Description Operating Voltage [Vrms] Transient Voltage(t=1 min.) [Vpk] Maximum Off-State Leakage Current @ Rated Voltage (@ max. line voltage) [mArms] 280 VAC 660 VAC 24-280 550 0.1 48-660 1000 0.25 25 A 40 A 25 100 275/300 85 1.4 0.6 380/370 500 40 100 710/750 150 1.3 0.4 2520/2320 500 OUTPUT SPECIFICATIONS (1) Description Maximum Load Current [Arms] Minimum Load Current [mArms] Maximum 1 Cycle Surge Current (50/60Hz) [Apk] 1 Second surge current (50/60 Hz @ Ta=25°C) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Thermal Resistance Junction to Case (Rjc) [°C/W] Maximum 1/2 Cycle I² t for Fusing (50/60Hz) [A² sec] Maximum Off-State dv/dt @ Maximum Rated Voltage [V/μsec] Do not forget to visit us at: www.crydom.com Copyright © 2016 Crydom Inc. Specifications subject to change without notice. Panel Mount Datasheet INPUT SPECIFICATIONS (1) Description Control Voltage Range [Vdc] Minimum Turn-On Voltage [Vdc] Must Turn-Off Voltage [Vdc] Minimum Input Current (for on-state) [mA] Maximum Input Current [mA] Nominal Input Impedance [Ohms] Maximum Turn-On Time [msec] (2) Maximum Turn-Off Time [msec] 84140x0x 84140x1x 4-15 4 1 7.5 34 500 17-32 17 1 13 24 1500 1/2 Cycle 1/2 Cycle GENERAL SPECIFICATIONS (1) Description Parameters -40 to 80 °C Ambient Operating Temperature Range Ambient Storage Temperature Range Input to Output Isolation Input/Output to Ground Isolation Input to Output Capacitance Operation Frequency Housing Material Weight (typical) -40 to 100 °C 4000 Vrms 2500 Vrms 8pF 47 to 63 Hz UL94 V-0 (self extinguishing) 3.2 oz (91.5g) GENERAL NOTES (1) All parameters at 25°C unless otherwise specified. (2) Turn-on time for Instantaneous turn-on versions is 0.02 msec. For additional information or specific questions, contact Crydom Technical Support. WIRING DIAGRAM Load AC AC V V 2A ( ) 2B ( ) 1A ( ) Load 1B ( ) S O L I D S TAT E R E L AY Input A + - + Input B - Do not forget to visit us at: www.crydom.com Copyright © 2016 Crydom Inc. Specifications subject to change without notice. Panel Mount Datasheet EQUIVALENT CIRCUIT BLOCK DIAGRAMS -DC - OUTPUT INPUT 2A AC Trigger Circuit +DC + 1A AC Current Limiter -DC - OUTPUT INPUT 2B AC Trigger Circuit +DC + 1B AC Current Limiter MECHANICAL SPECIFICATIONS (1) Tolerances: ±0.02 in / 0.5 mm All dimensions are in: inches [millimeters] 0.47 [11.9] 1.31 [33.2] 2.25 [57.3] S O L I D S TAT E R E L AY Input A + - 1.88 [47.6] Mating Connector AMP #640441-4 - 0.88 [22.3] 0.10 [2.54] Do not forget to visit us at: www.crydom.com 0.17 [4.31] 1.25 [31.7] + Input B 0.30 [7.62] 0.37 [9.39] Copyright © 2016 Crydom Inc. Specifications subject to change without notice. Mating Connector for 841408xxx and 841409xxx Molex # 50-57-9404 without pins Crimp Pins Molex # 16-02-0103 Panel Mount Datasheet THERMAL DERATE INFORMATION 25 A 0.7°C/W 1°C/W 40 A 0.5°C/W 2°C/W 1.5°C/W Combined Channel Output Current (Amp) Combined Channel Output Current (Amp) 50 40 30 20 10 0 20 30 40 50 60 70 80 Ambient Temperature (ºC) 80 70 60 50 40 30 20 10 0 20 30 1°C/W 40 1.5°C/W 50 60 2°C/W 70 80 Ambient Temperature (ºC) AGENCY APPROVALS EN60950-1: Meets the requirements of sections1.5: 1,7: 2.9: 2.10.5.3: 4.2: 4.5: 4.7: Certified according to EN 62314:2006 IEC 61000-4-2 Electrostatic Discharge Level 3 IEC 61000-4-4 Electrically Fast Transients Level 3 IEC 61000-4-5 Electrical Surges Level 3 E79183 LR 38595 Rev. 092616 Do not forget to visit us at: www.crydom.com Copyright © 2016 Crydom Inc. Specifications subject to change without notice. Panel Mount Datasheet DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险 HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH. • Disconnect all power before installing or working with this equipment. • Verify all connections and replace all covers before turning on power. Failure to follow these instructions will result in death or serious injury. RIESGO DE DESCARGA ELECTRICA O EXPLOSION. • Desconectar todos los suministros de energia a este equipo antes de trabajar con este equipo. • Verificar todas las conexiones y colocar todas las tapas antes de energizer el equipo. El incumplimiento de estas instrucciones puede provocar la muerte o lesiones serias. RISQUE DE DESCHARGE ELECTRIQUE OU EXPLOSION • Eteindre toutes les sources d'énergie de cet appareil avant de travailler dessus de cet appareil • Vérifier tous connections, et remettre tous couverts en olace avant de mettre sous De non-suivi de ces instructions provoquera la mort ou des lésions sérieuses sérieuses. GEFAHR EINES ELEKTRISCHE N SCHLAGES ODER EINER EXPLOSION. • Stellen Sie jeglichen Strom ab, der dieses Gerät versorgt, bevor Sie an dem Gerät Arbeiten durchführen • Vor dem Drehen auf Energie alle Anschlüsse überprüfen und alle Abdeckungen ersetzen. Unterlassung dieser Anweisungen können zum Tode oder zu schweren Verletzungen führen. RISCHIO DI SCOSSA ELETTRICA O DELL’ESPLOSI ONE. • Spenga tutta l'alimentazion e che fornisce questa apparecchiatu ra prima del lavorare a questa apparecchiatu ra 存在电击、 爆炸或电弧 闪烁危险 • 在操作此设 备之前请先 关闭电源。 若不遵守这些说明， 可能会导致严重的 人身伤害甚至死亡。 • Verificare tutti i collegamenti e sostituire tutte le coperture prima della rotazione sull'alimentazi one L'omissione di seguire queste istruz ioni provocherà la morte o di lesioni serie WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA / AVVERTENZA / 警告 RISK OF MATERIAL DAMAGE AND HOT ENCLOSURE RISQUE DE DOMMAGE MATERIEL ET DE SURCHAUFFE DU BOITIER GEFAHR VON MATERIALSCHÄDEN UND GEHÄUSEERHITZUNG • The product's side panels may be hot, allow the product to cool before touching. • Follow proper mounting instructions including torque values. • Do not allow liquids or foreign objects to enter this product. • Les panneaux latéraux du produit peuvent être chauds. Laisser le produit refroidir avant de le toucher. • Respecter les consignes de montage, et notamment les couples de serrage. • Ne pas laisser pénétrer de liquide ni de corps étrangers à l'intérieur du produit. • Die Seitenwände können heiß sein. Lassen Sie das Produkt abkühlen, bevor Sie es berühren. • Beachten Sie die Montageanweisungen, • Führen Sie keine Flüssigkeiten oder Fremdkörper in das Produkt ein. Le non-respect de cette directive peut entraîner, Failure to follow these instructions can result in des lésions corporelles graves ou des serious injury, or equipment damage. dommages matériels. Die Nichtbeachtung dieser Anweisung kann Körperverletzung oder Materialschäden zur Folge haben. RIESGO DE DAÑOS MATERIALES Y DE SOBRECALENTAMIENTO DE LA UNIDAD RISCHIO DI DANNI MATERIALI E D'INVOLUCRO CALDO 材料损坏和高温外壳的危险性 • Los paneles laterales del producto pueden estar calientes. Esperar que el producto se enfríe antes de tocarlo. • Respetar las instrucciones de montaje, y en particular los pares de apretado. • No dejar que penetren líquidos o cuerpos extraños en el producto. • I pannelli laterali dell'apparecchio possono scottare; lasciar quindi raffreddare il prodotto prima di toccarlo. • Seguire le istruzioni di montaggio corrette. • Non far entrare liquidi o oggetti estranei in questo apparecchio. Si no se respetan estas precauciones pueden producirse graves lesiones, daños materiales. La mancata osservanza di questa precauzione può causare gravi rischi per l'incolumità personale o danni alle apparecchiature. Do not forget to visit us at: www.crydom.com Copyright © 2016 Crydom Inc. Specifications subject to change without notice. • 产品的一侧面板可能很热，在其冷却前请 不要触碰。 • 遵照正确的安装说明，包括扭矩值。 • 请勿让液体及其他异物进入本产品。 如不能正确执行这些操作说明， 极有可能造成严重人体伤害或者设备的损坏。 Panel Mount Datasheet ANNEX - ENVIROMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products. Part Name Toxic or hazardous Substance and Elements Lead (Pb) Mercury (Hg) Cadmium (Cd) Hexavalent Chromium (Cr (VI)) Polybrominated biphenyls (PBB) Polybrominated diphenyl ethers (PBDE) Semiconductor die Solder 附件 - 环保信息 此附件所标示的包括电子信息产品污染图标的环保信息符合中华人民共和国电子行业标准 SJ/T11364 - 2006, 电子信息产品污染控制标识要求。 部件 名称 铅 汞 镉 有毒有害物质或元素 六价铬 多溴联苯 (Pb) (Hg) (Cd) (Cr (VI)) 半导体芯片 焊接点 50 Do not forget to visit us at: www.crydom.com Copyright © 2016 Crydom Inc. Specifications subject to change without notice. (PBB) 多溴二苯醚 (PBDE) Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Crydom: 84140800 84140810 84140900 84140910 84140000 84140010 84140200 84140210 84140300 84140600 84140110 84140500 84140100 84140310 84140610 84140911 84140611 84140801 84140510 84140601 84140811 84140511 84140901 84140501