CS-FF-MSB

M ICROWAVE A Division of Crystek Corporation NOTES: 1.0 Materials NOTE: Distance from end of cable center conductor to Re. Pl. is 0.250 (Ref) 1.1 Body, and Clamp Nut: Steel. Corrosion Resistant per ASTM-A582. UNS No. S30300. 1.2 Center Conductor: Beryllium Copper per ASTM-B196. UNS C17300. 1.3 Solder Ferrule: Brass per ASTM-B16. UNS C36000. 1.4 O-Ring: Silicone Rubber per A-A-59588. 1.5 Dielectric Bead: Polychlorotrifluoroethylene (PCTFE) per ASTM-D1430-95. (KEL-F) 2.0 Finishes 2.1 Center Contact and Solder Ferrule: Gold Plate per ASTM-B488 50 Microinches Min. thickness over Electrolytic Nickel Plate per ASTM-B689 50 Microinches Min. thickness. 2.2 Body and Clamp Nut: Passivated per SAE-AMS-2700. 2.3 O-Ring and Dielectric Bead: None. 3.0 Interface: 2.92mm Socket per CC-2.92mm-Soc. (Meets IEEE-STD-P287. Figure G.4. Except Conductor Tolerances and Contact Recession). Page 1 of 3 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation Step 1 1.1 Trim Cable as shown. Step 2 2.1 Install O-ring onto clamp nut where shown and slide clamp nut over cable in orientation shown. 2.2 Insert cable into solder ferrule until seated and solder to cable braids where shown. Step 3 3.1 Trim dielectric flush with seating surface of solder ferrule. 3.2 Verify center conductor dimension shown from ferrule seating surface. Page 2 of 3 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation Step 4 4.1 Point cable center conductor as shown. NOTE: Distance from end of cable center conductor to Ref. Pl. is 0.250 (Ref) Step 5 5.1 Insert cable sub-assembly into connector until seated and tighten clamp nut to 25-35 in-lbs. Product Control: Crystek Part Number: CS-FF-MSB Release Date: 04-Jan-11 Revision Level: A Responsible: K. Piotrowicz CRYSTEK CORPORATION Page 3 of 3 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com