CVPD-037X-122.88

LVPECL Voltage Controlled Crystal Oscillator CVPD-037X Model 5×7 mm SMD, 3.3V, LVPECL Frequency Range: 40.000 to 170.000 MHz Operating Temperature Range: -40°C to 85°C Storage Temperature Range: -45°C to 90°C Input Voltage: 3.3V ± 5% Control Voltage: 1.65V ±1.65V Input Current: 56mA Max Standard Standby Current: 800uA Frequencies (MHz) Output: PECL Symmetry: 45/55% Max @ zero crossing point 100.000 Rise/Fall Time: 0.25nSec Typical, 0.5ns Max, (20% to 80%) 122.880 Pullability APR: ±50ppm Min APR 153.600 Load: 50 ohms (Vdd-2.0V) Logic “1” Level: 2.275 VDC Min 156.250 Logic “0” Level: 1.680 VDC Max Modulation BW: 15 kHz Min Input Impedance: 5 Mohm Min Mechanical: Enable Delay Time: 2 ms Max Disable Delay Time: 200 ns Max Shock: MIL-STD-883, Method 2002, Condition B Phase Noise (Typical for 160 MHz): Solderability: MIL-STD-883, Method 2003 10 Hz Offset: -60 dBc/Hz Vibration: MIL-STD-883, Method 2007, Condition A 100 Hz Offset: -90 dBc/Hz Solvent Resistance: MIL-STD-202, Method 215 1 kHz Offset: -118 dBc/Hz Resistance to Soldering Heat: MIL-STD-202, Method 210, Condition I or J 10 kHz Offset: -134 dBc/Hz 100 kHz Offset: -144 dBc/Hz Environmental: 1 MHz Offset: -150 dBc/Hz Thermal Shock: MIL-STD-883, Method 1011, Condition A 10 MHz Offset: -157 dBc/Hz Moisture Resistance: MIL-STD-883, Method 1004 40 MHz Offset: -157 dBc/Hz Part Number Example: CVPD-037X-100.000 = 3.3V, ±50ppmAPR, 100 MHz Dimensions inches (mm) All dimensions are Max unless otherwise specified. 0.276 ±0.008 (7.00 ±0.20) CVPD-037X 100M YYWW XX 0.197 ±0.008 (5.00 ±0.20) 0.071 Max (1.80 Max) Denotes pad 1 YYWW=Date Code XX=Lot Code via to ground #1 #2 #3 #6 #5 #4 0.071 SQ (1.80) 0.01µF 0.148 (3.75) 0.046 ±0.008 (1.17 ±0.20) 0.100 (2.54) 0.200 (5.08) 0.200 (5.08) 0.01uF Bypass Capacitor Recommended RECOMMENDED REFLOW SOLDERING PROFILE Ramp-Up 3°C/Sec Max. Critical Temperature Zone 260°C TEMPERATURE SUGGESTED PAD LAYOUT 0.055 Typ (1.40 Typ) Ramp-Down 6°C/Sec. 217°C 200°C PIN Connection 1 2 3 4 5 6 Cont. Volt E/D GND Ouput Comp Output Vcc Enable/Disable Function pin 2 Output pin Open or N/C "1" level 0.7×Vdd Min "0" level 0.3×Vdd Max Active Active High Z 150°C Preheat 180 Secs. Max. 90 Secs. Max. 8 Minutes Max. 260°C for 10 Secs. Max. NOTE: Reflow Profile with 240°C peak also acceptable. C CRYSTEK CORPORATION Available on 16mm Tape and Reel in quantities of 1,000 pcs. Crystek Corporation reserves the right to make changes to its products and/or information contained herein without notice. No liability is assumed as a result of its use or application. Rev: G Date: 18-Dec-2019 Page 1 of 1 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com