CTDD2727DF-D1K-5

DC/DC Converters ctparts.com SPECIFICATIONS CTDD2727DF-D1K-5 Series Wide Input Isolated & Regulated 5W Output, Dual Output Part Number CTDD2727DF-1205-D1K-5 CTDD2727DF-1209-D1K-5 CTDD2727DF-1212-D1K-5 CTDD2727DF-1215-D1K-5 CTDD2727DF-1505-D1K-5 CTDD2727DF-1512-D1K-5 CTDD2727DF-1515-D1K-5 CTDD2727DF-2405-D1K-5 CTDD2727DF-2409-D1K-5 CTDD2727DF-2412-D1K-5 CTDD2727DF-2415-D1K-5 CTDD2727DF-4805-D1K-5 CTDD2727DF-4809-D1K-5 CTDD2727DF-4812-D1K-5 CTDD2727DF-4815-D1K-5 Vin Nom. (VDC) 12 12 12 12 15 15 15 24 24 24 24 48 48 48 48 Input Range (VDC) 9-18 9-18 9-18 9-18 12-24 12-24 12-24 18-36 18-36 18-36 18-36 36-72 36-72 36-72 36-72 Vin Max.* (VDC) 22 22 22 22 30 30 30 40 40 40 40 80 80 80 80 Vout (VDC) ±5 ±9 ±12 ±15 ±5 ±12 ±15 ±5 ±9 ±12 ±15 ±5 ±9 ±12 ±15 Iout Max. (mA) ±500 ±278 ±210 ±166 ±500 ±210 ±166 ±500 ±278 ±210 ±166 ±500 ±278 ±210 ±166 Iout Min**. (mA) ±50 ±28 ±21 ±17 ±50 ±21 ±17 ±50 ±28 ±21 ±17 ±50 ±28 ±21 ±17 Effi. Typ. (%) 72 75 77 80 75 80 81 77 80 82 84 79 82 85 85 Not shown at actual size. Compliant RoHS *If Input voltage above specified may cause permanent damage to the device **The load should not be less than 10%, otherwise ripple will increase dramatically ISOLATION SPECIFICATIONS Item Isolation Voltage Isolation Resistance Test Condition Flash tested for 1 minute Test at 500VDC MIN 1000 1000 TYP MAX Units VDC MΩ FEATURES Efficiency: To 85% Temperature Range: -40°C to +85°C Isolation: 1KVDC Miscellaneous: Wide (2:1) Input Range. Metal Shielding Package. No heat sink required. Industry Standard Pinout. Dual Output. Custom service available. Samples available. OUTPUT SPECIFICATIONS Item 5W Output Power Positive voltage accuracy Negative voltage accuracy Load regulation Line regulation Temperature drift (Vout) Ripple Noise Switching frequency Switching frequency Refer to Recommended Circuit Refer to Recommended Circuit From 10% to 100% load Input Voltage from low to high Refer to Temp. Derating Graph 20Hz to 300KHz Bandwidth DC-20MHz Bandwidth 100% load, nominal input voltage 10% load, nominal input voltage 80 250 30 80 Test Condition MIN 0.5 ±1 ±3 ±0.1 ±0.2 TYP MAX 5 ±3 ±5 ±0.2 ±0.5 0.03 50 150 200 600 Units W % % % % %/°C mVp-p mVp-p KHz KHz CHARACTERISTICS Output Short Circuit Protection: Continuous Temperature Rise at Full Load: 30°C (Typ.) Cooling: Free air convection No Load, Power Consumption: 500mW (typical) Operating Temperature Range: -40°C to +85°C Storage Temperature Range: -55°C to +125°C Lead Temperature: 300°C (1.5mm from case for 10 seconds) Storage Humidity Range: < 95% Case Material: Metal MTBF: >3,500,000 hours Miscellaneous: RoHS Compliant. Note: 1. All specifications measured at TA=25°C, humidity