CTDD5025DF-D1K-10

DC/DC Converters ctparts.com SPECIFICATIONS CTDD5025DF-D1K-10 Series Wide Input Isolated & Regulated 10W Output, Dual Output Part Number CTDD5025DF-2405-D1K-10 CTDD5025DF-2412-D1K-10 CTDD5025DF-2415-D1K-10 CTDD5025DF-2424-D1K-10 CTDD5025DF-4805-D1K-10 CTDD5025DF-4812-D1K-10 CTDD5025DF-4815-D1K-10 CTDD5025DF-4824-D1K-10 Vin Nom. (VDC) 24 24 24 24 48 48 48 48 Input Range (VDC) 18-36 18-36 18-36 18-36 36-72 36-72 36-72 36-72 Vin Max.* (VDC) 40 40 40 40 80 80 80 80 Vout (VDC) ±5 ±12 ±15 ±24 ±5 ±12 ±15 ±24 Iout Max. (mA) ±1000 ±420 ±330 ±210 ±1000 ±420 ±330 ±210 Iout Min**. (mA) ±100 ±42 ±33 ±21 ±100 ±42 ±33 ±21 Effi. Typ. (%) 75 78 82 85 78 81 84 85 Not shown at actual size. Compliant RoHS *If Input voltage above specified may cause permanent damage to the device **The load should not be less than 10%, otherwise ripple will increase dramatically ISOLATION SPECIFICATIONS Item Isolation Voltage Isolation Resistance Test Condition Flash tested for 1 minute Test at 500VDC MIN 1000 1000 TYP MAX Units VDC MΩ OUTPUT SPECIFICATIONS Item 10W Output Power Test Condition Refer to Recommended Circuit From 25% to 100% load; Refer to Recommended Circuit Negative Load regulation Line regulation Temperature drift (Vout) Ripple Noise Switching frequency From 25% to 100% load; Refer to Recommended Circuit Input Voltage from low to high Refer to Temp. Derating Graph 20Hz to 300KHz Bandwidth DC-20MHz Bandwidth 100% load, nominal input voltage 30 100 300 ±0.2 ±0.5 0.02 50 300 % %/°C mVp-p mVp-p KHz ±3 ±5 % MIN TYP ±1 ±0.5 MAX 10 ±3 ±1 Units W % % FEATURES Efficiency: To 85% Temperature Range: -40°C to +85°C I/O-Isolation: 1KVDC Case Size: 50.7(L). *25.4(W)*10.2(H) mm. Miscellaneous: Wide (2:1) Input Range. No heat sink required. Industry Standard Pin out. Dual Output. Samples available. Output voltage accuracy Positive Load Regulation CHARACTERISTICS Output Short Circuit Protection: Continuous Temperature Rise at Full Load: 30°C (Typ.) Cooling: Free air convection No Load, Power Consumption: 500mW (typical) Operating Temperature Range: -40°C to +85°C Storage Temperature Range: -55°C to +125°C Lead Temperature: 300°C (1.5mm from case for 10 seconds) Storage Humidity Range: < 95% Case Material: Metal MTBF: >3,500,000 hours Miscellaneous: RoHS Compliant. Note: 1. All specifications measured at TA=25°C, humidity