EPS060100

a d ivision of CUI INC date 09/2010 page 1 of 4 SERIES: 6 W WALL PLUG DESCRIPTION: SWITCHING POWER SUPPLY FEATURES •Level V (efficient design) •100 ~ 130 V ac input voltage •regulated output voltage •short circuit, over load protection •meets EISA / efficiency level IV regulations •custom designs available RoHS MODEL EPS030100 EPS033100 EPS036100 EPS045100 EPS050100 EPS060100 EPS075080 EPS090066 EPS100060 EPS120050 EPS135044 EPS150040 EPS180033 EPS240025 output voltage nominal (V dc) output current min (A) max (A) output wattage max (W) ripple* max. (mVp-p) efficiency level cord length (mm) 3 3.3 3.6 4.5 5 6 7.5 9 10 12 13.5 15 18 24 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1 0.8 0.66 0.6 0.5 0.44 0.4 0.33 0.25 3 3.3 3.6 4.5 5 6 6 6 6 6 6 6 6 6 100 100 100 100 100 100 100 100 100 120 135 150 180 240 IV IV IV V V V V V V V V V V IV 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 1800 ±100 *at full load, 100 ~ 130 V ac input, measured at 20MHz bandwidth with a 10 uF electrolytic cap and a 0.1 uF ceramic cap on the output PART NUMBER KEY EPS030100 - PXXXX - SZ - CXX example of 3 V dc, 1 A Base Number Reserved for custom orders DC Plug type: see output plug options on page 4 Factory Designation 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 www.v-infinity.com a d ivision of CUI INC date 09/2010 page 2 of 4 SERIES: 6 W WALL PLUG DESCRIPTION: SWITCHING POWER SUPPLY INPUT parameter rated input voltage rated frequency frequency range inrush current no load power consumption 120 V ac, inrush lasts no longer than 0.5 ms before settling to steady state current Input: 100 ~ 120 V ac conditions/description min 100 50 47 nom 120 max 130 60 63 40 0.5 units V ac Hz Hz A W OUTPUT parameter line regulation load regulation over/undershoot temp. coefficient start-up time hold-up time output power limit overload protection short circuit protection full load to no load, > 5 V full load to no load, < 5 V at turn-on and turn-off 0 ~ 40°C, full load, after initial 1 hour warm-up time needed to reach regulation at 115 V ac, full load primary power limited Fold-back current limiting starts at 105 ~ 160% of the rated output current. Auto-recovery. Long term exposure to overload condition may reduce product reliability. Continuous, auto-recovery upon removal of short 10 -5% 0 ±0.02 3 conditions/description min nom ±2 ±5 +0.25 V % %/°C s ms max units % % SAFETY & EMI parameter HI-POT insulation resistance safety approvals EMI standard leakage current RoHS compliant class 2 power supply conditions/description input to output at 10 mA for 1 second input to output at 500 V dc UL/cUL 1310 FCC part 15 class B at 120 V ac yes yes 0.5 mA 100 min nom max 3000 units V ac M ENVIRONMENTAL parameter operating temperature operating humidity storage temperature storage humidity conditions/description min 0 10 -20 10 nom max 40 90 85 90 units °C % °C % RELIABILITY parameter MTBF conditions/description at 25°C, per MIL-HDBK-217E min 240,000 nom max units hours 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 www.v-infinity.com a d ivision of CUI INC date 09/2010 page 3 of 4 SERIES: 6 W WALL PLUG DESCRIPTION: SWITCHING POWER SUPPLY MECHANICAL DRAWING 17.0 43.3 1.0 26.6 1.0 12.7 63 1.0 22.3X18.0 1800 100 Units: mm 6.3 Tolerance: X.X ±0.5mm X.XX ±0.03mm NOTE 1: THIS POWER UNIT IS INTENDED TO BE CORRECTLY ORIENTED IN A VERTICAL OR FLOOR MOUNT POSITION. 3.0 (TYP) 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 www.v-infinity.com a d ivision of CUI INC date 09/2010 page 4 of 4 SERIES: 6 W WALL PLUG DESCRIPTION: SWITCHING POWER SUPPLY OUTPUT PLUG OPTIONS 3.5 mm Phono Plug *Tip positive P1 P1R Standard DC Plug P5/P5R P6/P6R P7/P7R P8/P8R P9/P9R A 5.5 5.5 3.5 3.8 3.8 B 2.1 2.5 1.3 1.35 1.05 C 9.5 9.5 9.5 9.5 9.5 Unit mm mm mm mm mm Standard PX Right Angle PXR Locking DC Plug A 5.5 5.5 B 2.1 2.5 C 9.5 9.5 Unit mm mm P10 P11 EIAJ Plugs EIAJ A B P12/P12R EIAJ-1 2.35 0.7 P13/P13R EIAJ-2 4.0 1.7 P14/P14R EIAJ-3 4.75 1.7 C 9.5 9.5 9.5 D NA 5.0 5.0 Unit mm mm mm Standard PXX Right Angle PXXR Stripped and Tinned DC PLUG TYPE ST stripped and tinned Plug type PXX X X Plug angle: “blank” = standard R = right angle Plug polarity: “blank” = N/A P = center positive N = center negative *Contact CUI for additional output plug options. 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 www.v-infinity.com