VSNS15-5-2R5

• VSNS15 Series Point of Load Converter Features ·Delivers 15A of output current ·High efficiency ·Low output ripple and noise ·Small size and low profile ·Cost efficient open frame design ·single-in-line (SIP) and SMT package ·Remote on/off (active low) ·Remote sense ·Trimmable output voltage via external resistor ·Output over current protection ·Over temperature protection ·Wide operating temperature range -40 °C ~85 °C ·Non-isolated Model Number VSNS15-5-1R0 VSNS15-5-1R5 VSNS15-5-1R8 VSNS15-5-2R0 VSNS15-5-2R5 VSNS15-5-3R3 VSNS15-12-1R0 VSNS15-12-1R5 VSNS15-12-1R8 VSNS15-12-2R5 VSNS15-12-3R3 VSNS15-12-5R0 Input Voltage 3.0-5.5V 3.0-5.5V 3.0-5.5V 3.0-5.5V 3.0-5.5V 4.5-5.5V 10-14V 10-14V 10-14V 10-14V 10-14V 10-14V Output Voltage 1.0V 1.5V 1.8V 2.0V 2.5V 3.3V 1.0V 1.5V 1.8V 2.5V 3.3V 5.0V Output Current 15A 15A 15A 15A 15A 15A 15A 15A 15A 15A 15A 15A Max. Power 15.0W 22.5W 27.0W 30.0W 37.5W 49.5W 15.0W 22.5W 27.0W 37.5W 49.5W 75.0W Ripple & Noise max 40mVp-p 40mVp-p 40mVp-p 40mVp-p 40mVp-p 40mVp-p 60mVp-p 60mVp-p 60mVp-p 60mVp-p 60mVp-p 60mVp-p MTBF 7.6x105 hrs 7.6x105 hrs 7.6x105 hrs 7.6x105 hrs 7.6x105 hrs 7.6x105 hrs 8.0x105 hrs 8.0x105 hrs 8.0x105 hrs 8.0x105 hrs 8.0x105 hrs 8.0x105 hrs Efficiency typ. 84% 88% 89% 91% 92% 94% 82% 87% 88% 90% 92% 94% 1. Typical at Ta+ +25°C under nominal line voltage and full load conditions, unless other wise noted. All models are tested and specified with external input and output capacitors. (Cin=100uFx2 Cout=10uF), These capacitors are necessary to accommodate out test equipment. 2. Ripple and Noise are tested/specified over a 20MHz bandwidth and may be reduced with external filtering. 3. This device has no minimum load requirement and will regulate under no-load conditions. The regulation part of the specification describes the output voltage deviation as the line voltage or load is varied from its minimum value to either extream . V-Infinity, LLC, 9615 SW Allen Blvd Suite 103, Beaverton, OR 97005 www.v-infinity.com 1-866-372-1258 • VSNS15 Series Point of Load Converter Electrical Specifications Voltage tolerance Line regulation Load regulation Switching frequency Dimensions Note : Suffix V is for SIP packaging Suffix H is for SMT packaging ±2.0% ±0.3% ±0.4% 300KHz 50.8x13.97x8.64mm (SIP package) Drawings V-Infinity reserves the right to make changes to its products or to discontinue any product or service without notice, and to advise customers to verify the most up-to-date product information before placing orders. V-Infinity assumes no liability or responsibility for customer's applications using V-Infinity products other than repair or replacing (at V-I's option) V-Infinity products not meeting V-I's published specifications. Nothing will be covered outside of standard product warranty. V-Infinity, LLC, 9615 SW Allen Blvd Suite 103, Beaverton, OR 97005 www.v-infinity.com 1-866-372-1258