AE10-UW-S5

Additional Resources: Product Page date 07/27/2021 page 1 of 6 SERIES: AE10-UW Ϳ DESCRIPTION: DC-DC CONVERTER FEATURES U input voltage output voltage output current range (Vdc) (Vdc) min (A) 200~1500 5 0 output power ripple & noise1 HϒFLHQF\2 max (A) max (W) max (mVp-p) W\S (%) 2.0 10 300 64 TI MODEL ED 10 watts high operating temp -40 to +70°C 4,000 Vac isolation designed to meet UL 1741; EN 62109 approved board mounted input voltage range of 200~1,500 Vdc low ripple & noise OVP protection output short circuit protection N • • • • • • • • • AE10-UW-S5 1. Measured at nominal input, 20 MHz bandwidth oscilloscope, with 10 µF electrolytic and 1 µF ceramic capacitors on the output. 2. Measured at 800 Vdc input voltage, full load. $OOVSHFL¿FDWLRQVDUHPHDVXUHGDW7D ƒ&KXPLGLW\QRPLQDOLQSXWYROWDJHDQGUDWHGRXWSXWORDGXQOHVVRWKHUZLVHVSHFL¿HG PART NUMBER KEY N Notes: O AE10-UW - SXX Output Voltage D IS C Base Number cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: AE10-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 07/27/2021 Ϳ page 2 of 6 INPUT parameter conditions/description min under voltage shutdown shut-down range turn-on range current at 200 Vdc at 800 Vdc at 1500 Vdc inrush current at 200 Vdc at 800 Vdc at 1500 Vdc input fuse 4 A / 1500 Vdc (external) W\S units 1500 Vdc 170 180 185 195 Vdc Vdc 120 30 16 mA mA mA 30 80 150 U OUTPUT parameter max 200 ED operating input voltage conditions/description min maximum capacitive load max units 6,000 Nj) ±2 % line regulation from low line to high line, full load ±1 % load regulation from 0% to full load ±1 delay time IURP9LQ 9WRRIUDWHGRXSWXWYROWDJH WHPSHUDWXUHFRHϒFLHQW at full load PROTECTIONS conditions/description over voltage protection min N parameter TI switching frequency N voltage accuracy W\S A A A over current protection automatic recovery short circuit protection continuous, automatic recovery parameter O SAFETY AND COMPLIANCE conditions/description isolation voltage input to output for 1 minute 65 kHz %/°C W\S W\S 4,000 max units 8 Vdc 320 % max units Vac CSA, EN 62109 C safety approvals s ±0.02 120 min % 2 conducted emissions CISPR22/EN55022, class A (external circuit required, see Figure 2) radiated emissions CISPR22/EN55022, class A (external circuit required, see Figure 2) ESD IEC/EN61000-4-2, contact ± 6kV/air ± 8kV, class B IEC/EN61000-4-3, 10V/m, class A ()7EXUVW IEC/EN61000-4-4, ± 2kV, class B (external circuit required, see Figure 2) surge IEC/EN61000-4-5, line-line ± 1kV, class B (external circuit required, see Figure 2) conducted immunity IEC/EN61000-4-6, 10 Vr.m.s, class A PDJQHWLF¿HOGLPPXQLW\ IEC/EN61000-4-8, 10 A/m, class A 07%) as per MIL-HDBK-217F, 25°C RoHS yes D IS radiated immunity 300,000 cui.com hours Additional Resources: Product Page CUI Inc Ϳ SERIES: AE10-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 07/27/2021 Ϳ page 3 of 6 ENVIRONMENTAL parameter conditions/description min max units operating temperature see derating curves -40 70 °C -40 85 °C 95 % 5000 m storage humidity non-condensing altitude see derating curves ED storage temperature W\S SOLDERABILITY parameter conditions/description min W\S max units hand soldering for 3~5 seconds 350 360 370 °C wave soldering for 5~10 seconds 255 260 265 °C max units U MECHANICAL conditions/description dimensions 125.00 x 75.00 x 40.00 [4.921 x 2.953 x 1.575 inch] case material EODFNÀDPHUHWDUGDQWKHDWSURRISODVWLF8/9 weight units: mm [inch] tolerance: ±0.50[±0.020] pin diameter tolerance: ±0.10[±0.004] pin height tolerance: ±1.50[±0.059] Function -Vin 2 +Vin 3 NC 5 -Vout C 4 O 3,1&211(&7,216 1 300 N In high vibration environments, this series should be mounted with screws. tightening torque: max 0.4 N*m W\S TI MECHANICAL DRAWING PIN min N parameter +Vout D IS 1& QRFRQQHFWLRQ Recommended PCB Layout 7RS9LHZ cui.com mm g Additional Resources: Product Page CUI Inc Ϳ SERIES: AE10-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 07/27/2021 Ϳ page 4 of 6 C O N TI N U ED DERATING CURVES D IS EFFICIENCY CURVES cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: AE10-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 07/27/2021 Ϳ page 5 of 6 APPLICATION CIRCUIT Table 1 5 4 A / 1500 Vdc C1 Nj) C2 Nj) 796 N Fuse 1 120 SMBJ7.0A TI Vout (Vdc) U ED Figure 1 EMC RECOMMENDED CIRCUIT D IS C O N Figure 2 1RWHV Table 2 Recommended External Circuit Components FUSE 4 A/1500 Vdc C7, C8, C9, C10 104K/275 Vac C3, C4, C5, C6 47 µF/450 Vdc R1, R2, R3, R4 0Ÿ: LDM 330 µH/1 A LCM 7 mH/1 A 1RWH6HHDOVR7DEOH &LVDFHUDPLFFDSDFLWRUXVHGWR¿OWHUKLJKIUHTXHQF\QRLVH 2. C2 is electrolytic and is recommended to be high frequency and low resistance. For capacitance and current of the capacitor, refer to the datasheet provided by the manufacturer. Capacitance withstand voltage derating should be 80% or above. cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: AE10-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 07/27/2021 Ϳ page 6 of 6 REVISION HISTORY description date 09/13/2017 1.0 initial release 1.01 updated datasheet 1.02 changed external input fuse recommendation 1.03 company logo updated 1.04 ED rev. 03/05/2018 07/24/2019 04/12/2021 GHUDWLQJFXUYHHϒFLHQF\FXUYHVDQGFLUFXLW¿JXUHVXSGDWHG 07/27/2021 D IS C O N TI N U 7KHUHYLVLRQKLVWRU\SURYLGHGLVIRULQIRUPDWLRQDOSXUSRVHVRQO\DQGLVEHOLHYHGWREHDFFXUDWH Headquarters 20050 SW 112th Ave. 7XDODWLQ25 800.275.4899 Fax 503.612.2383 cui.com techsupport@cui.com &8,RϑHUVDWZR\HDUOLPLWHGZDUUDQW\&RPSOHWHZDUUDQW\LQIRUPDWLRQLVOLVWHGRQRXUZHEVLWH CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use. CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical component is any component of a OLIHVXSSRUWGHYLFHRUV\VWHPZKRVHIDLOXUHWRSHUIRUPFDQEHUHDVRQDEO\H[SHFWHGWRFDXVHWKHIDLOXUHRIWKHOLIHVXSSRUWGHYLFHRUV\VWHPRUWRDϑHFWLWVVDIHW\RUHϑHFWLYHQHVV