AE40-UW-S15

Additional Resources: Product Page date 11/11/2022 page 1 of 7 SERIES: AE40-UW Ϳ DESCRIPTION: DC-DC CONVERTER FEATURES MODEL U ED 40 watts high operating temp -40 to +70°C 4,000 Vac isolation UL 1741; EN 62109 approved board mounted input voltage range of 200~1,500 Vdc low ripple & noise OVP protection output short circuit protection N • • • • • • • • • output voltage output current output power ripple & noise1 HϒFLHQF\2 range (Vdc) (Vdc) min (A) max (A) max (W) max (mVp-p) W\S (%) AE40-UW-S12* 200~1500 12 0 3.33 40 300 76 AE40-UW-S15 200~1500 AE40-UW-S24* 200~1500 15 0 2.67 40 300 78 24 0 1.67 40 300 80 TI input voltage 1. Measured at nominal input, 20 MHz bandwidth oscilloscope, with 10 µF electrolytic and 1 µF ceramic capacitors on the output. 2. Measured at 800 Vdc input voltage, full load. $OOVSHFL¿FDWLRQVDUHPHDVXUHGDW7D ƒ&KXPLGLW\QRPLQDOLQSXWYROWDJHDQGUDWHGRXWSXWORDGXQOHVVRWKHUZLVHVSHFL¿HG 4. * Discontinued model. O PART NUMBER KEY N Notes: Output Voltage Base Number D IS C AE40-UW - SXX cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: AE40-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 11/11/2022 Ϳ page 2 of 7 INPUT parameter conditions/description min under voltage shutdown shut-down range turn-on range current at 200 Vdc at 800 Vdc at 1500 Vdc inrush current at 200 Vdc at 800 Vdc at 1500 Vdc input fuse 4 A / 1500 Vdc (external) max units 200 W\S 1500 Vdc 170 180 185 195 Vdc Vdc 320 80 42 mA mA mA ED operating input voltage 30 80 150 conditions/description maximum capacitive load 12 Vdc output model 15 Vdc output model 24 Vdc output model min N parameter U OUTPUT voltage accuracy W\S A A A max units 3,000 1,500 680 Nj) Nj) Nj) ±2 % from low line to high line, full load ±1 % load regulation from 0% to full load ±1 % delay time IURP9LQ 9WRRIUDWHGRXSWXWYROWDJH switching frequency WHPSHUDWXUHFRHϒFLHQW at full load N PROTECTIONS TI line regulation parameter conditions/description over voltage protection 12 Vdc, 15 Vdc output models 24 Vdc output model automatic recovery O over current protection short circuit protection min 2 s 65 kHz ±0.02 %/°C W\S 120 max units 20 30 Vdc Vdc 320 % max units continuous, automatic recovery SAFETY AND COMPLIANCE conditions/description min C parameter W\S input to output for 1 minute 4,000 safety approvals CSA, EN 62109, UL 1741 conducted emissions CISPR22/EN55022, class A (external circuit required, see Figure 2) radiated emissions CISPR22/EN55022, class A (external circuit required, see Figure 2) ESD IEC/EN61000-4-2, contact ± 6kV/air ± 8kV, class B radiated immunity IEC/EN61000-4-3, 10V/m, class A ()7EXUVW IEC/EN61000-4-4, ± 2kV, class B (external circuit required, see Figure 2) surge IEC/EN61000-4-5, line-line ± 1kV, class B (external circuit required, see Figure 2) conducted immunity IEC/EN61000-4-6, 10 Vr.m.s, class A PDJQHWLF¿HOGLPPXQLW\ IEC/EN61000-4-8, 10 A/m, class A 07%) as per MIL-HDBK-217F, 25°C RoHS yes Vac D IS isolation voltage 300,000 cui.com hours Additional Resources: Product Page CUI Inc Ϳ SERIES: AE40-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 11/11/2022 Ϳ page 3 of 7 ENVIRONMENTAL parameter conditions/description min max units operating temperature see derating curves -40 70 °C -40 85 °C 95 % 5000 m storage humidity non-condensing altitude see derating curves ED storage temperature W\S SOLDERABILITY parameter conditions/description min W\S max units hand soldering for 3~5 seconds 350 360 370 °C wave soldering for 5~10 seconds 255 260 265 °C max units U MECHANICAL conditions/description dimensions 125.00 x 75.00 x 40.00 [4.921 x 2.953 x 1.575 inch] case material EODFNÀDPHUHWDUGDQWKHDWSURRISODVWLF8/9 weight units: mm [inch] tolerance: ±0.50[±0.020] pin diameter tolerance: ±0.10[±0.004] pin height tolerance: ±1.50[±0.059] 1 -Vin 2 +Vin NC 4 -Vout 5 C 3 O 3,1&211(&7,216 Function 410 N In high vibration environments, this series should be mounted with screws. tightening torque: max 0.4 N*m W\S TI MECHANICAL DRAWING PIN min N parameter +Vout D IS 1& QRFRQQHFWLRQ Recommended PCB Layout 7RS9LHZ cui.com mm g Additional Resources: Product Page CUI Inc Ϳ SERIES: AE40-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 11/11/2022 Ϳ page 4 of 7 C O N TI N U ED DERATING CURVES D IS EFFICIENCY CURVES cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: AE40-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 11/11/2022 Ϳ page 5 of 7 D IS C O N TI N U ED EFFICIENCY CURVES (CONTINUED) cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: AE40-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 11/11/2022 Ϳ page 6 of 7 APPLICATION CIRCUIT Fuse 4 A / 1500 Vdc 4 A / 1500 Vdc 24 4 A / 1500 Vdc 1 C2 Nj) 796 120 SMBJ20A 1 120 SMBJ20A 1 68 SMBJ30A N TI 12 15 C1 Nj) N Vout (Vdc) U Table 1 ED Figure 1 O EMC RECOMMENDED CIRCUIT Figure 2 Table 2 C Recommended External Circuit Components IS FUSE 4 A/1500 Vdc C7, C8, C9, C10 104K/275 Vac C3, C4, C5, C6 47 µF/450 Vdc R1, R2, R3, R4 0Ÿ: LDM 330 µH/1 A LCM 7 mH/1 A D 1RWH6HHDOVR7DEOH 1RWHV &LVDFHUDPLFFDSDFLWRUXVHGWR¿OWHUKLJKIUHTXHQF\QRLVH 2. C2 is electrolytic and is recommended to be high frequency and low resistance. For capacitance and current of the capacitor, refer to the datasheet provided by the manufacturer. Capacitance withstand voltage derating should be 80% or above. cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: AE40-UW Ϳ DESCRIPTION: DC-DC CONVERTER date 11/11/2022 Ϳ page 7 of 7 REVISION HISTORY description date 09/13/2017 1.0 initial release 1.01 updated datasheet 1.02 added UL safety approval 1.03 changed external input fuse recommendation ED rev. 03/05/2018 02/26/2019 07/24/2019 company logo updated 1.05 GHUDWLQJFXUYHVHϒFLHQF\FXUYHVDQGFLUFXLW¿JXUHVXSGDWHG 08/31/2021 04/12/2021 1.06 discontinued models AE40-UW-S12 & AE40-UW-S12 11/11/2022 U 1.04 D IS C O N TI N 7KHUHYLVLRQKLVWRU\SURYLGHGLVIRULQIRUPDWLRQDOSXUSRVHVRQO\DQGLVEHOLHYHGWREHDFFXUDWH Headquarters 20050 SW 112th Ave. 7XDODWLQ25 800.275.4899 Fax 503.612.2383 cui.com techsupport@cui.com &8,RϑHUVDWZR\HDUOLPLWHGZDUUDQW\&RPSOHWHZDUUDQW\LQIRUPDWLRQLVOLVWHGRQRXUZHEVLWH CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use. CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical component is any component of a OLIHVXSSRUWGHYLFHRUV\VWHPZKRVHIDLOXUHWRSHUIRUPFDQEHUHDVRQDEO\H[SHFWHGWRFDXVHWKHIDLOXUHRIWKHOLIHVXSSRUWGHYLFHRUV\VWHPRUWRDϑHFWLWVVDIHW\RUHϑHFWLYHQHVV