PBO-10C-15

Additional Resources: Product Page date 05/26/2022 page 1 of 8 SERIES: PBO-10C Ϳ DESCRIPTION: INTERNAL AC-DC POWER SUPPLY wide input range (85 ~ 305 Vac) wide operating temperature range (-40 to +85 C) IEC/EN/UL 62368 certified designed to meet 61558 & 60335 safety standards 1,000,000 hour MTBF flexible implementations to power a wide array of applications output voltage (Vdc) 3.3 PBO-10C-5 5.0 PBO-10C-9 9.0 PBO-10C-12 PBO-10C-15 PBO-10C-24 ripple and noise¹ HϒFLHQF\² max (A) max (W) W\S (mVp-p) W\S (%) 2.0 6.6 150 73.0 2.0 10.0 150 77.0 1.1 10.0 150 80.0 12.0 0.83 10.0 150 82.0 15.0 0.67 10.0 150 82.0 24.0 0.42 10.0 150 83.0 1. At full load, nominal input, 20 MHz bandwidth oscilloscope, see Application Circuit. 2. At 230 Vac input. O Note: output power N PBO-10C-3 output current TI MODEL N U • • • • • • ED FEATURES PBO-10C - XX Output Voltage Base Number D IS C PART NUMBER KEY cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: PBO-10C Ϳ DESCRIPTION: AC-DC POWER SUPPLY date 05/26/2022 Ϳ page 2 of 8 INPUT conditions/description min max units voltage ac input dc input 85 100 305 430 Vac Vdc 47 63 Hz 0.30 0.18 A A frequency current at 115 Vac at 230 Vac inrush current at 115 Vac at 277 Vac no load power consumption at 230 Vac 3.3 & 5 Vdc output models 9, 12 & 15 Vdc output models 24 Vdc output models U 15 30 OUTPUT capacitive load 3.3 Vdc output models 5 Vdc output models 9 Vdc output models 12 Vdc output models 15 Vdc output models 24 Vdc output models initial set point accuracy 3.3 Vdc output other outputs line regulation at rated load load regulation 0% ~ 100% load min N PROTECTIONS conditions/description over voltage protection output voltage clamp & hiccup 3.3 & 5 Vdc output models 9 Vdc output models 12 Vdc output models 15 Vdc output models 24 Vdc output models min C over current protection auto recovery short circuit protection continuous, auto recovery, hiccup A A 0.10 0.12 0.15 W W W max units 1,500 1,500 1,000 680 470 330 Nj) Nj) Nj) Nj) Nj) Nj) ±3 ±2 % % ±1 % ±1.5 % ±0.02 %/°C W\S O parameter W\S N conditions/description TI parameter WHPSHUDWXUHFRHϒFLHQW W\S ED parameter max units 9.0 15.0 16.0 21.0 32.0 Vdc Vdc Vdc Vdc Vdc 110 % IS SAFETY & COMPLIANCE conditions/description isolation voltage input to output for 1 minute, leakage current 300 mA at 100 kHz. 2. Recommended to use a high frequency, low ESR, electrolytic capacitor with at least 20% margin on voltage rating. 3. A suppressor diode (TVS) is recommended to protect the downstream application in case of converter failure and should be rated for a minimum of 1.2 times the converter’s output voltage. N Note: L1 (required) Nj)9 (solid-state capacitor) PBO-10C-5 PBO-10C-12 C2 (required) N C1Ӽ (required) TI Part no. U PBO-10C Series additional component selection guide (no EMC devices) PBO-10C Series Enviromental and EMC selection guide Application enviromental 1 Basic application None Indoor civil enviroment Smart home/Home appliances (2 Y-caps) Input voltage range Immunity -40°C to 85°C Class A Class III -25°C to 55°C Class B Class III Indoor industrial Manufacturing workoshop -25°C to 55°C Class B Class IV ITS/Video monitoring/ Charging point/Communication/Security and protection -40°C to 85°C Class A Class IV 85~305Vac Immunity design circuits reference D Emissions Intelligent building/ Intelligent agriculture Outdoor general enviroment 4 Enviroment temperature Indoor general enviroment IS 3 C 2 Typical industry O Recommended circuit Class III Emissions design circuits reference Class IV Class A cui.com Class B Additional Resources: Product Page CUI Inc Ϳ SERIES: PBO-10C Ϳ DESCRIPTION: AC-DC POWER SUPPLY date 05/26/2022 Ϳ page 6 of 8 APPLICATION DESIGN REFERENCE (CONTINUED) Table 1 Ambient temperature range Basic application -40°C ~ 85°C Imunity Class Emissions Class N Application enviromental U ED Circuit 1 Class III Component Class A Recommended value 1A/300V, slow blow R1 (wire-wound resistor, required) LDM TI FUSE (required) ƻ: P+ƻPD[$PLQ N 1RWH5PXVWEHDZLUHZRXQGUHVLVWRUGRQRWXVHDFKLSRUFDUERQ¿OPUHVLVWRU IS C O Circuit 2 Table 2 Ambient temperature range Imunity Class Emissions Class Indoor civil / general -25°C ~ 55°C Class III Class B D Application enviromental Component Recommended value FUSE (required) 1A/300V, slow-blow R1 (wire-wound resistor, required) ƻ: CY1 (CY2) 1.0nF/400Vac LDM P+ƻ$ CX 0.1µF/310Vac Note: 1. For Smart Home and Home Appliance applications two Y-capacitors are required in series (2.2 nF/250 Vac each) to meet 60335 household safety requirements. 0DQ\VDIHW\VWDQGDUGVUHTXLUHDEOHHGHUUHVLVWRUQRJUHDWHUWKDQ0ŸLQSDUDOOHOZLWKWKH;FDSDFLWRU 3. R1 must be a wire-wound resistor; do not use a chip or carbon film resistor. cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: PBO-10C Ϳ DESCRIPTION: AC-DC POWER SUPPLY date 05/26/2022 Ϳ page 7 of 8 APPLICATION DESIGN REFERENCE (CONTINUED) Table 3 U ED Circuit 3 Ambient temperature range Imunity Class Emissions Class Indoor industrial -25°C ~ 55°C Class IV Class B N Application enviromental Component Recommended value 2A/300V, slow-blow MOV CY1 TI FUSE (required) S14K350 1.0nF/400Vac CX 0.1µF/310Vac LDM P+ƻ$ N R1 (wire-wound resistor, required) ƻ: Circuit 4 IS C O 1RWH0DQ\VDIHW\VWDQGDUGVUHTXLUHDEOHHGHUUHVLVWRUQRJUHDWHUWKDQ0ŸLQSDUDOOHOZLWKWKH;FDSDFLWRU 2. R1 must be a wire-wound resistor; do not use a chip or carbon film resistor. Application enviromental Ambient temperature range Imunity Class Emissions Class Oudoor general enviroment -40°C ~ 85°C Class IV Class A D Note: Table 4 Component Recommended value FUSE (required) 2A/300V, slow-blow MOV S14K350 LDM P+ƻ$ R1 (wire-wound resistor, required) ƻ: R1 must be a wire-wound resistor; do not use a chip or carbon film resistor. cui.com Additional Resources: Product Page CUI Inc Ϳ SERIES: PBO-10C Ϳ DESCRIPTION: AC-DC POWER SUPPLY date 05/26/2022 Ϳ page 8 of 8 rev. description date ED REVISION HISTORY 1.0 initial release 1.01 GHUDWLQJDQGHϒFLHQF\FXUYHVXSGDWHG 11/12/2020 1.02 UKCA mark added 01/21/2022 05/26/2022 D IS C O N TI N U The revision history provided is for informational purposes only and is believed to be accurate. Headquarters 20050 SW 112th Ave. Tualatin, OR 97062 800.275.4899 Fax 503.612.2383 cui.com techsupport@cui.com &8,RϑHUVDWZR\HDUOLPLWHGZDUUDQW\&RPSOHWHZDUUDQW\LQIRUPDWLRQLVOLVWHGRQRXUZHEVLWH CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use. CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical component is any component of a OLIHVXSSRUWGHYLFHRUV\VWHPZKRVHIDLOXUHWRSHUIRUPFDQEHUHDVRQDEO\H[SHFWHGWRFDXVHWKHIDLOXUHRIWKHOLIHVXSSRUWGHYLFHRUV\VWHPRUWRDϑHFWLWVVDIHW\RUHϑHFWLYHQHVV