PRC10W-72-S12

Additional Resources: Product Page | 3D Model | PCB Footprint date 01/16/2023 page 1 of 9 SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER FEATURES • • • • • • • • 10W isolated output ultra-wide 18:1 input range (8.5~160 Vdc) single/dual regulated outputs 4,200 Vdc isolation over voltage, over current, short circuit, UVLO protection certified to IEC/BS EN/UL 62368-1 meets EN 50155 with external circuit reinforced insulation MODEL input voltage output voltage output current output power ripple & noise1 efficiency² typ (Vdc) range (Vdc) (Vdc) min (mA) max (mA) max (W) max (mVp-p) typ (%) PRC10W-72-S5 72 8.5 ~ 160 5 0 2,000 10 100 84 PRC10W-72-S12 72 8.5 ~ 160 12 0 835 10 100 88 PRC10W-72-S15 72 8.5 ~ 160 15 0 668 10 100 88 PRC10W-72-D5 72 8.5 ~ 160 ±5 0 ±1,000 10 100 83 PRC10W-72-D12 72 8.5 ~ 160 ±12 0 ±416 10 100 87 PRC10W-72-D15 72 8.5 ~ 160 ±15 0 ±333 10 100 87 Notes: 1. Measured at 5Hz to 20MHz bandwidth, peak to peak. 2. At nominal input voltage 72Vdc. PART NUMBER KEY PRC10W - 72 -X XX Base Number Input Voltage cui.com Output S = single D = dual Output Voltage Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER date 01/16/2023 │ page 2 of 9 INPUT parameter conditions/description operating input voltage surge voltage input undervoltage lockout min typ max units 8.5 72 160 Vdc for maximum of 100 ms 200 Vdc turn-on voltage treshold at 80% load 8.2 9 9.5 Vdc turn-off voltage treshold at 80% load 6.9 7.5 8.0 Vdc lockout hysteresis voltage at 80% load 1.5 Vdc current Vin = 12V, full load Vin = 8.5V, 80% load input filter LC filter inrush current (I2t) as per ETS300 132-2 input reflected ripple current P-P thru 12uH inductor, 5Hz to 20MHz 30 CTRL module on: CTRL pin open or pulled high (3.5~160 Vdc) module off: CTRL pin pulled low to GND (0~1.2 Vdc) CTRL pin current when pulled low 0.4 1 mA typ max units 2,000 835 668 1,000 416 333 μF μF μF μF μF μF ±1 % 1.3 A 0.1 A2s mA OUTPUT parameter conditions/description min maximum capacitive load 5 Vdc output 12 Vdc output 15 Vdc output ±5 Vdc output ±12 Vdc output ±15 Vdc output voltage accuracy Vin = 72V, full load, 25°C output voltage balance Vin = 72V, full load, 25°C, dual models only ±1 % line regulation input voltage from low to high, full load ±0.2 % load regulation 0%~100% load single output models dual output models ±0.5 ±1 % % cross regulation load cross variation 25%/100%, dual output models ±5 % switching frequency 280 kHz transient recovery time 75% to 100% load step change, 0.1 A/us, within 1% nominal input voltage 230 250 μs transient response deviation 75% to 100% load step change, 0.1 A/us ±5 % temperature coefficient 40°C to 100°C ±0.02 %/°C cui.com 255 Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER date 01/16/2023 │ page 3 of 9 PROTECTIONS parameter conditions/description over voltage protection zener clamp, single output only 5 Vdc output 12 Vdc output 15 Vdc output min over current protection auto recovery, hiccup short circuit protection continuous, auto recovery typ max units 6.2 15 18 110 150 min typ Vdc Vdc Vdc 180 % max units 3,000 4,200 Vac Vdc SAFETY AND COMPLIANCE parameter conditions/description isolation voltage input to output, for 1 minute isolation resistance input to output isolation capacitance input to output, 100kHz / 0.25V safety approvals certified to 62368: IEC, BS EN, UL designed to meet 50155: EN designed to meet 45545-2: EN conducted emissions EN55032 and EN50155 Compliant (with external filter) radiated emissions EN55032 and EN50155 Compliant (with external filter) ESD EN 61000-4-2 Level 3: Air ±8kV, Contact± 6kV, perf. Criteria A radiated immunity EN 61000-4-3 Level 3: 80~1000MHz, 20 V/m, perf. Criteria A EFT/burst EN61000-4-4 Level 3: On power input port, ±2kV, external input capacitor required, perf. Criteria A surge EN 61000-4-5 Level 4: Line to earth, ±4kV, line to line, ±2kV, perf. Criteria A conducted immunity EN 61000-4-6 Level 3: 0.15~80MHz, 10V, perf. Criteria A voltage dips and interruptions EN 50155 Class S3: 20ms interruptions, perf. Criteria A MTBF as per MIL-HDBK-217F, 25°C 5 Vdc output 12 Vdc output 15 Vdc output ±5 Vdc output ±12 Vdc output ±15 Vdc output RoHS yes 1,000 MΩ 16 pF 1,654 2,295 2,363 1,664 2,093 2,335 K K K K K K hours hours hours hours hours hours ENVIRONMENTAL parameter conditions/description min max units operating temperature see derating curve -40 100 °C -55 125 °C 95 % max units storage temperature storage humidity typ non-condensing MECHANICAL parameter conditions/description min dimensions 31.8 x 20.3 x 12.7 [1.25 × 0.80 × 0.50 inch] weight typ mm 16 case material plastic, DAP, UL 94V-0 base material plastic, LCP, UL 94V-0 potting material UL 94V-0 pin material base: copper plated steel wire plating: tin cooling method natural convection cui.com g Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER date 01/16/2023 │ page 4 of 9 MECHANICAL DRAWING units: inch [mm] pin size diameter: 0.02±0.002 inch (0.5±0.05mm) general tolerance: inches: x.xx = ±0.02, x.xxx = ±0.010 mm: x.x = ±0.5, x.xx = ±0.25 Pin Out cui.com PIN Single outputs Dual outputs 1 +Vin +Vin 2 +Vin +Vin 3 Remote on/off Remote on/off 11 NP Common 12 -Vout NP 13 +Vout -Vout 15 NP +Vout 23 -Vin -Vin 24 -Vin -Vin Additional Resources: Product Page | CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER 3D Model | PCB Footprint date 01/16/2023 │ page 5 of 9 DERATING CURVE EFFICIENCY CURVES cui.com Additional Resources: Product Page | CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER 3D Model | PCB Footprint date 01/16/2023 │ page 6 of 9 EFFICIENCY CURVES (CONTINUED) cui.com Additional Resources: Product Page | CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER 3D Model | PCB Footprint date 01/16/2023 │ page 7 of 9 EFFICIENCY CURVES (CONTINUED) cui.com Additional Resources: Product Page | CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER 3D Model | PCB Footprint date 01/16/2023 │ page 8 of 9 EFFICIENCY CURVES (CONTINUED) cui.com Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRC10W │ DESCRIPTION: DC-DC CONVERTER date 01/16/2023 │ page 9 of 9 REVISION HISTORY rev. description date 1.0 initial release 12/19/2022 1.01 safeties updated 01/16/2023 The revision history provided is for informational purposes only and is believed to be accurate. Headquarters 20050 SW 112th Ave. Tualatin, OR 97062 800.275.4899 Fax 503.612.2383 cui.com techsupport@cui.com CUI offers a two (2) year limited warranty. Complete warranty information is listed on our website. CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use. CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness.