PRQ3W-Q48-D524-S

Additional Resources: Product Page | 3D Model | PCB Footprint date 07/15/2021 page 1 of 7 SERIES: PRQ3W-S │ DESCRIPTION: DC-DC CONVERTER FEATURES • • • • • • • ultra-wide 4:1 input range dual positive output with asymmetrical options 3000 Vdc isolation input under-voltage protection output short circuit and over current protection wide operating temp: -40°C to +85°C EN62368 approved MODEL output voltage output current max max ripple and noise1 max (Vdc) Vo1/Vo2 (Vdc) Vo1/Vo2 (A) (W) Vo1/Vo2 (mVp-p) min (%) typ (%) PRQ3W-Q48-D55-S 18~75 5/5 300/300 3 150/150 76 78 PRQ3W-Q48-D512-S 18~75 5/12 300/125 3 150/150 76 78 PRQ3W-Q48-D524-S 18~75 5/24 300/63 3 150/150 76 78 Notes: input voltage range output power 1. 20MHz bandwidth, nominal input, full load 2. Efficiency is measured In nominal input voltage and rated output load. PART NUMBER KEY PRQ3W-QXX - DXXX - S Base Number Input Voltage cui.com Output Voltage efficiency2 Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRQ3W-S │ DESCRIPTION: DC-DC CONVERTER date 07/15/2021 │ page 2 of 7 INPUT parameter conditions/description input voltage filter capacitance filter current full load/no load min typ max units 18 48 80 Vdc 83/12 mA max units 680 330 220 μF μF μF OUTPUT parameter conditions/description output capacitance 5V outputs 12V outputs 24V outputs min typ line regulation low line to high line Vo1 Vo2 ±0.2 ±0.5 ±0.5 ±1.0 % load regulation 10~100% load Vo1 Vo2 ±0.5 ±1.1 ±1.0 ±2.0 % set-point accuracy Vo1 / Vo2 10~100% load 5~10% load ±1/ ±3 ±2/ ±4 ±3/±5 ±4/ ±6 % % start-up time nominal input and constant resistance load 10 switching frequency 300 transient response temperature coefficient ms full load kHz ±8 500 % Vout µs ±0.03 %/°C max units 250 %Io PROTECTIONS parameter conditions/description min over current protection short circuit protection 110 output shutdown, auto recovery cui.com typ Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRQ3W-S │ DESCRIPTION: DC-DC CONVERTER date 07/15/2021 │ page 3 of 7 SAFETY AND COMPLIANCE parameter conditions/description min isolation voltage input to output output to output 3000 1500 typ max Vdc Vdc isolation resistance input-output resistance at 500 Vdc 1000 MΩ isolation capacitance input-output capacitance at 100 KHz/0.1 V safety approvals EN/IEC 62368 EMI/EMC EN 55032: 2015 Class B (see recommended circuit) ESD IEC/EN61000-4-2, Contact ±4KV, perf. Criteria B radiated immunity IEC/EN61000-4-3, 10 v/m, perf. Criteria A EFT/burst IEC/EN61000-4-4, ±2KV (see recommended circuit), perf. Criteria B surge IEC/EN61000-4-5, line to line ±2KV (see recommended circuit), perf. Criteria B conducted immunity IEC/EN61000-4-6, 3 Vr.m.s, perf. Criteria A RoHS yes MTBF MIL-HDBK-217@25°C 1000 units pF 1000 kHours ENVIRONMENTAL parameter conditions/description min typ max units operating temperature -40 85 °C storage temperature -55 125 °C 5 95 % humidity non-condensing shock/vibration 10-150Hz, 5G, 0.75mm. along X, Y and Z cui.com Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRQ3W-S │ DESCRIPTION: DC-DC CONVERTER date 07/15/2021 │ page 4 of 7 MECHANICAL parameter conditions/description dimensions 27.40 x 9.50 x 12.00 min case material Black flame-retardant and heat-resistant plastic (UL94 V-0) typ 5.4 MECHANICAL DRAWING units: mm [inches] tolerance: ± 0.50 [±0.020] PIN CONNECTIONS FUNCTION 1 GND 2 Vin 6 +Vo1 7 -Vo1 8 CS* 9 -Vo2 10 +Vo2 units mm weight PIN max * Connecting a low ESR capacitor between CS & pin 7 may reduce output ripple & noise. Maximum value = 47 µF cui.com g Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRQ3W-S │ DESCRIPTION: DC-DC CONVERTER date 07/15/2021 │ page 5 of 7 DERATING CURVES Figure 1 APPLICATION CIRCUIT All the dc-dc converters of this series are tested before delivery using the recommended circuit shown in Fig. 2. Input and/or output ripple can be further reduced by appropriately increasing the input & output capacitor values Cin and Cout and/or by selecting capacitors with a low ESR (equivalent series resistance). Also make sure that the capacitance is not exceeding the max. capacitive load value of the product. Figure 2 Table 1 output voltage (Vdc) Cin (uF) 5 47 12 22 24 22 cui.com Cout (uF) 100 Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRQ3W-S │ DESCRIPTION: DC-DC CONVERTER date 07/15/2021 │ page 6 of 7 EMC RECOMMENDED CIRCUITS Figure 3 Table 2 List of Components Model Vin:48V FUSE Choose according to actual input current C0 680µF/100V C1/C5/C6 4.7µF/100V C2 330µF/100V C3/C4 Refer to the Cout in Fig.2 LDM1 22µH/0.6A CY1/CY2/CY4 1nF/3kV CY3 2.2nF/3kV cui.com Additional Resources: Product Page | 3D Model | PCB Footprint CUI Inc │ SERIES: PRQ3W-S │ DESCRIPTION: DC-DC CONVERTER date 07/15/2021 │ page 7 of 7 REVISION HISTORY rev. description date 1.0 initial release 05/26/2020 1.01 derating curve and circuit figures updated 07/15/2021 The revision history provided is for informational purposes only and is believed to be accurate. Headquarters 20050 SW 112th Ave. Tualatin, OR 97062 800.275.4899 Fax 503.612.2383 cui.com techsupport@cui.com CUI offers a two (2) year limited warranty. Complete warranty information is listed on our website. CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use. CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness.