VFK400W-Q24-S48-DIN

Additional Resources: Product Page | 3D Model date 09/13/2021 page 1 of 6 SERIES: VFK400W-DIN │ DESCRIPTION: DC-DC CONVERTER FEATURES • • • • • • up to 400 W isolated output rugged metal enclosure with integrated heat sink 4:1 input range (10~36 Vdc, 18~75 Vdc) single output from 12~48 Vdc 1,500 Vdc isolation over current, over temperature, over voltage, and short circuit protection • remote on/off • efficiency up to 87% • comes with DIN-rail mount MODEL input voltage output voltage output current output power ripple and noise1 efficiency range (Vdc) (Vdc) max (A) max (W) max (mVp-p) max (%) VFK400W-Q24-S12-DIN VFK400W-Q24-S12 10~36 12 33.3 400 200 87 VFK400W-Q24-S24-DIN VFK400W-Q24-S24 10~36 24 16.7 400 240 86 VFK400W-Q24-S48-DIN VFK400W-Q24-S48 10~36 48 8.3 398 480 86 VFK400W-Q48-S12-DIN VFK400W-Q48-S12 20~75 12 33.3 400 200 87 VFK400W-Q48-S24-DIN VFK400W-Q48-S24 18~75 24 16.7 400 240 86 VFK400W-Q48-S48-DIN VFK400W-Q48-S48 18~75 48 8.3 398 480 86.5 2 Note: 1. Ripple and noise are measured at full load, 20 MHz BW with 10μF tantalum capacitor and 1μF ceramic capacitor across the output. The 48 Vdc output models require a 22uF aluminum capacitor and a 1uF ceramic capacitor across the output. 2. An external input capacitor of 470uF is recommended to reduce input ripple voltage. PART NUMBER KEY VFK400W - QXX - SXX - DIN Base Number Input Voltage Output Voltage cui.com Mounting Type DIN = DIN-rail mount Additional Resources: Product Page | 3D Model CUI Inc │ SERIES: VFK400W-DIN │ DESCRIPTION: DC-DC CONVERTER date 09/13/2021 │ page 2 of 6 INPUT parameter conditions/description 24 Vdc input operating input voltage Note: max units 24 36 Vdc 20 18 48 48 75 75 Vdc Vdc 12 Vdc output model 24/48 Vdc output models 24 Vdc input power up power down 9.5 8.5 Vdc Vdc 48 Vdc input power up power down 17.8 15.5 Vdc Vdc positive logic filter typ 10 48 Vdc input under voltage shutdown CTRL1 min models ON (open circuit) models OFF (0~1.2 Vdc) pi filter 1. Do not drive high, may damage device. OUTPUT parameter conditions/description min maximum output capacitance for all models line regulation measured from high line to low line load regulation measured from full load to zero load typ voltage accuracy adjustability 90 switching frequency transient response max units 2,200 μF ±1 % ±1 % ±1.5 % 105 250 25% step load change 500 temperature coefficient % kHz ±0.03 µs %/°C PROTECTIONS parameter conditions/description short circuit protection continuous over current protection % nominal output current min over voltage protection over temperature protection max units 110 150 % 115 140 % shutdown typ 110 °C SAFETY AND COMPLIANCE parameter conditions/description min isolation voltage for 1 minute: input to output; input to case; output to case isolation resistance RoHS typ max units 1,500 Vdc 10 MΩ 2011/65/EU (CE) ENVIRONMENTAL parameter conditions/description min operating temperature see derating curves storage temperature cui.com typ max units -40 85 °C -55 105 °C Additional Resources: Product Page | 3D Model CUI Inc │ SERIES: VFK400W-DIN │ DESCRIPTION: DC-DC CONVERTER date 09/13/2021 │ page 3 of 6 MECHANICAL parameter conditions/description dimensions 7.83 x 5.00 x 2.11 (199.0 x 127.0 x 53.6 mm) min case material steel and aluminum extrusion typ max inch weight 1.53 kg MECHANICAL DRAWING units: inch[mm] tolerance: X.XX = ±0.02[±0.5] X.XXX = ±0.010[±0.25] wire range: 22~12 AWG screw size: #6-32 mounts to TS35 rails 0.18 4.5 PIN CONNECTIONS FUNCTION +Vin 3, 4 -Vin 5 REM 6 CASE 7, 8 +Vout 9 +S 10 TRIM 11 -S 12, 13 -Vout 7 1 4.63 117.5 5.00 127.0 PIN 1, 2 6 13 1.29 32.7 5.12 130.0 7.69 195.4 0.07 1.8 7.83 199.0 0.57 14.6 0.50 12.8 1.54[39.0] Top View 1.38 35.0 2 - DIN RAIL CLIP Side View OUTPUT 1.57 40.0 INPUT 1.57 40.0 1.91 48.5 Back View 0.75 19.0 Front View Bottom View cui.com units Additional Resources: Product Page CUI Inc │ SERIES: VFK400W-DIN │ DESCRIPTION: DC-DC CONVERTER | 3D Model date 09/13/2021 │ page 4 of 6 DERATING CURVES cui.com Additional Resources: Product Page | 3D Model CUI Inc │ SERIES: VFK400W-DIN │ DESCRIPTION: DC-DC CONVERTER date 09/13/2021 │ page 5 of 6 APPLICATION NOTES 1. Output Voltage Trimming Leave open if not used. Figure 1 Application Circuit for Trim pin Table 1 Table 2 Trim Up Resistor Values (MΩ)1 Trim Down Resistor Values (KΩ) Desired Vout (%Vout) 101% 102% 103% 104% 105% 2.2 1.6 1.2 0.82 0.68 24 4.3 3.3 2.2 1.6 1.5 48 10 6.8 4.8 3.9 3.5 Nom. Vout (Vdc) 12 Desired Vout (%Vout) 90% 92% 94% 96% 98% 9 12 22 51 100 24 12 22 51 100 300 48 22 32 49 100 300 Nom. Vout (Vdc) 12 Note: 1. VFK400W-Q48-S12-DIN model requires minimum input voltage of 21.6 Vdc in order to trim between 100~105%. Note: All specifications measured at 25°C, nominal input voltage, and full load unless otherwise noted. cui.com Additional Resources: Product Page | 3D Model CUI Inc │ SERIES: VFK400W-DIN │ DESCRIPTION: DC-DC CONVERTER date 09/13/2021 │ page 6 of 6 REVISION HISTORY rev. description date 1.0 initial release 01/03/2014 1.01 changed DIN-rail mount 06/16/2014 1.02 CTRL line updated 11/13/2020 derating curve and trim circuit figure updated 09/13/2021 1.03 The revision history provided is for informational purposes only and is believed to be accurate. Headquarters 20050 SW 112th Ave. Tualatin, OR 97062 800.275.4899 Fax 503.612.2383 cui.com techsupport@cui.com CUI offers a two (2) year limited warranty. Complete warranty information is listed on our website. CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use. CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness.