PL78M05XJ3

CYStech Electronics Corp. Three Terminal Medium Current Positive Voltage Regulators Spec. No. : C520J3 Issued Date : 2003.04.10 Revised Date : .. Page No. : 1/4 PL78M05XJ3 Description TO-252 These regulators employ internal current-limiting and thermal-shutdown, making them essentially indestructible. They can deliver up to 500mA output current, if the case temperature can be kept at Tc=25°C. They are intended as fixed voltage regulators in a wide range of applications including local (on-card) regulation for elimination of noise and distribution problems associated with single-point regulation. In addition, they can be used with power pass elements to make high-current voltage regulators. The PL78M05XJ3 used as a Zener diode/resistor combination replacement, offers an effective output impedance improvement of typically two orders of magnitude, along with lower quiescent current and lower noise. Absolute Maximum Ratings (Ta=25°C) • Input Voltage………………………………………………………………………………………………. 35 V • Total Power Dissipation……………………………………………………………………. Internally limited • Operating Temperature Range……………………………………………………………. 0 °C to +125 °C • Maximum Junction Temperature………………………………………………………………………125 °C • Storage Temperature Range………………………………………………………………-55 °C to +150 °C • Lead Temperature (Soldering 10S)……………………………….. ……………………………...260 °C Typical Application Schematic Diagram Vin Vin PL78M05 L78M05 Vout 5k 5.7kΩ 100 1.5kΩ 1.9kΩ Vout C1 C2 576Ω 3.41kΩ 3.89kΩ 7.8kΩ 13kΩ 100 5p 2.23kΩ Note: C1 and C2 are required if regulator is located far from power supply filter and load, or oscillation may induced on the loop. 2.84kΩ Gnd PL78M05J3 CYStek Product Specification CYStech Electronics Corp. Ordering Information Device PL78M05AJ3 PL78M05BJ3 PL78M05CJ3 Output Voltage Range 4.8V〜4.9V 4.9V〜5.1V 5.1V〜5.2V Spec. No. : C520J3 Issued Date : 2003.04.10 Revised Date : .. Page No. : 2/4 Electrical Characteristics Vin=10V, Iout=350mA, PD≤5W,0°C≤Tj≤125°C, Cin=0.33uF, Cout=0.1uF (unless otherwise noted) Symbol Vo ∆Vo ∆Vo IQ ∆IQ Vn RR VD IOS IMAX TCVo Parameter Output Voltage Line Regulation Load Regulation Quiescent Current Quiescent Current Change Output Noise Voltage Ripple Rejection Dropout Voltage Output Short Circuit Current Peak Output Current Temperature Coefficient of Output Voltage Conditions Tj=25°C 5mA≤Io≤350mA and 7V≤Vin≤20V Tj=25°C, 7V≤Vin≤25V Tj=25°C, 8V≤Vin≤25V Tj=25°C, 5mA≤Io≤500mA Tj=25°C, 5mA≤Io≤200mA Tj=25°C 5mA≤Io≤350mA 8V≤Vin≤25V,Io=200mA Ta=25°C, 10Hz≤f≤10KHz 8V≤Vin≤18V,Io=300mA, f=120Hz Tj=25°C,Io=500mA Tj=25℃,Vin=35V Tj=25℃ Io=5mA PL78M05A Min Typ Max 4.80 4.90 4.75 62 3 15 3.2 40 78 2 300 700 -1.1 5.25 100 50 100 50 6 0.5 0.8 100 Units V mV mV mA mA uV dB V mA mA mV/℃ PL78M05J3 CYStek Product Specification CYStech Electronics Corp. Symbol Vo ∆Vo ∆Vo IQ ∆IQ Vn RR VD IOS IMAX TCVo Parameter Output Voltage Line Regulation Load Regulation Quiescent Current Quiescent Current Change Output Noise Voltage Ripple Rejection Dropout Voltage Output Short Circuit Current Peak Output Current Temperature Coefficient of Output Voltage Conditions Tj=25°C 5mA≤Io≤350mA and 7V≤Vin≤20V Tj=25°C, 7V≤Vin≤25V Tj=25°C, 8V≤Vin≤25V Tj=25°C, 5mA≤Io≤500mA Tj=25°C, 5mA≤Io≤200mA Tj=25°C 5mA≤Io≤350mA 8V≤Vin≤25V,Io=200mA Ta=25°C, 10Hz≤f≤10KHz 8V≤Vin≤18V,Io=300mA, f=120Hz Tj=25°C,Io=500mA Tj=25℃,Vin=35V Tj=25℃ Io=5mA Spec. No. : C520J3 Issued Date : 2003.04.10 Revised Date : .. Page No. : 3/4 PL78M05B Min Typ Max 4.90 5.00 5.1 4.75 62 3 15 3.2 40 78 2 300 700 -1.1 5.25 100 50 100 50 6 0.5 0.8 100 - Units V mV mV mA mA uV dB V mA mA mV/℃ Symbol Vo ∆Vo ∆Vo IQ ∆IQ Vn RR VD IOS IMAX TCVo Parameter Output Voltage Line Regulation Load Regulation Quiescent Current Quiescent Current Change Output Noise Voltage Ripple Rejection Dropout Voltage Output Short Circuit Current Peak Output Current Temperature Coefficient of Output Voltage Conditions Tj=25°C 5mA≤Io≤350mA and 7V≤Vin≤20V Tj=25°C, 7V≤Vin≤25V Tj=25°C, 8V≤Vin≤25V Tj=25°C, 5mA≤Io≤500mA Tj=25°C, 5mA≤Io≤200mA Tj=25°C 5mA≤Io≤350mA 8V≤Vin≤25V,Io=200mA Ta=25°C, 10Hz≤f≤10KHz 8V≤Vin≤18V,Io=300mA, f=120Hz Tj=25°C,Io=500mA Tj=25℃,Vin=35V Tj=25℃ Io=5mA PL78M05C Min Typ Max 5.10 5.2 5.05 62 3 15 3.2 40 78 2 300 700 -1.1 5.25 100 50 100 50 6 0.5 0.8 100 - Units V mV mV mA mA uV dB V mA mA mV/℃ PL78M05J3 CYStek Product Specification CYStech Electronics Corp. TO-252 Dimension A C Spec. No. : C520J3 Issued Date : 2003.04.10 Revised Date : .. Page No. : 4/4 Marking: 78M05 B L F G D 3 H E K 2 I 1 J Style: Pin 1.Vin 2.Ground 3.Vout 3-Lead TO-252 Plastic Surface Mount Package CYStek Package Code: J3 *: Typical DIM A B C D E F Inches Min. Max. 0.0177 0.0217 0.0650 0.0768 0.0354 0.0591 0.0177 0.0236 0.2520 0.2677 0.2125 0.2283 Millimeters Min. Max. 0.45 0.55 1.65 1.95 0.90 1.50 0.45 0.60 6.40 6.80 5.40 5.80 DIM G H I J K L Inches Min. Max. 0.0866 0.1102 *0.0906 0.0354 0.0315 0.2047 0.2165 0.0551 0.0630 Millimeters Min. Max. 2.20 2.80 *2.30 0.90 0.80 5.20 5.50 1.40 1.60 Notes: 1.Controlling dimension: millimeters. 2.Maximum lead thickness includes lead finish thickness, and minimum lead thickness is the minimum thickness of base material. 3.If there is any question with packing specification or packing method, please contact your local CYStek sales office. Material: • Lead: 42 Alloy; solder plating • Mold Compound: Epoxy resin family, flammability solid burning class: UL94V-0 Important Notice: • All rights are reserved. Reproduction in whole or in part is prohibited without the prior written approval of CYStek. • CYStek reserves the right to make changes to its products without notice. • CYStek semiconductor products are not warranted to be suitable for use in Life-Support Applications, or systems. • CYStek assumes no liability for any consequence of customer product design, infringement of patents, or application assistance. PL78M05J3 CYStek Product Specification