515-1004F

NEW 2.5 x 5mm Rectangular ® OptopipeTM Optical Light Pipe C.L. of LED 515-1004 Recommended MicroLED SMT LEDs for use with 515-1004 1.27 [.050] 5.03 [.198] NOTE: Designed for front panel mounting 6.91 [.272] 9.65 [.380] Ultrasonic Weld Detail 6.60 [.260] 4.93 2.49 [.194] 3.25 [.128] [.098] 5.86 [.231] DIRECTION OF LIGHT PART NO. COLOR PAGE # 597-3111-4xx 597-3201-4xx 597-3311-4xx 597-3401-4xx AlGaAs Red Orange Green Yellow 1-28 1-28 1-28 1-28 1.27 [.050] 7.57 [.298] Dimensions in mm [inches] Features LED Data • UL94V-0 compliance For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. • ESD protection (circuit isolation from front panel) • Wide viewing angle • Diffused lens • Secures to front panel by ultrasonic welding Operating/Storage Temperature –30°C to +100°C Dialight Optopipe Light Pipe Description This Optopipe™ is ultrasonically welded to the customer’s plastic housing using the tab at the top of the part. The light pipe is not attached to the PCB at any point, but floats above it. The light emitting surface is textured to increase its viewing angle. The selection of a suitable LED light source is left to the customer’s discretion. However, reflector type light sources like our 597 Series PLCC-2 or PLCC-4 Type SMT LEDs are good choices. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe™ solutions for your applications. 2-56 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com