515-1023F

3mm Square ® Optopipe® Optical Light Pipe, Quad High 3.20 [.126] LIGHTSHIELD S 2 PLCS 4.95 [.195] Recommended MicroLED SMT LEDs for use with 515-1023-803 .76 [.030] REF . 3.18 [.125] 4.95 [.195] 21.59 [.850] 4.95 [.195] 5.16 [.203] 4.45 [.175] 4.45 [.175] 4.45 [.175] 6.02 [.237] 28.75 [1.132] 3.53 [.139] 4.31 [.170] NOTE: C.L. of LED 5.31 [.209] 19.69 [.775] 8.23 [.324] 13.34 [.525] 9.07 [.357] 4.45 [.175] Direction of Light 1.24 [.049] .99 [.039] 2.01 [.079] .51 [.020] Ø [.113 ± .002] 4.12 [.162] .99 [.039] RECOMMENDED PIN HOLES AND SOLDER PAD LAYOUT FOR SUGGESTED MicroLED s LED 515-1023-803 [.116 DIA]TYP . (2) PLACES PART NO. COLOR PAGE # 597-3001-1xx 597-3111-1xx 597-3211-1xx 597-3301-1xx 597-3401-1xx 597-7701-1xx 597-7721-1xx 597-7731-1xx Red AlGaAs Red Orange Green Yellow Red/Green Yellow/Green Red/Yellow 1-19 1-19 1-19 1-19 1-19 1-20 1-20 1-20 NOTE: designed for post-reflow PC board insertion. Dimensions in mm [inches] COMPONENT SIDE OF PRINTED CIRCUIT BOARD Features LED Data • High transmissivity polycarbonate material For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. • UL94V-0 compliance • ESD protection (circuit isolation from front panel) • Wide viewing angle Operating/Storage Temperature • Arrays reduce insertion costs –30°C to +100°C • Allows quad level SMT indicators • Secures to PCB by press-fit Dialight Optopipe® Light Pipe Description This Optopipe® has a relatively low vertical height considering the number of light pipe elements. The element’s square emitting surfaces are vertically spaced 0.203" from the PCB to the first element, and then 0.195" between each of the other elements. This Optopipe® is held in place by 2 press-fit pins on the bottom of the device. The wide base offers added stability to the installed part. The light pipe is not attached to the panel at any point, but protrudes through holes in the panel. This Optopipe® was specifically designed to accept Dialight’s 597 Series Type 1210 LEDs. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe® solutions for your applications. Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com