515-1086F

NEW 2mm Round ® OptopipeTM 515-1086 Optical Light Pipe Assembly & Light Shield, 8 Array 20.32 [.80] MicroLED SMT LEDs for use with 515-1086 7.87 [.310] 2.54 [.100] TYP; 7 PLCS 1.14 [.045] 1.47 [.058] DIFFUSED FRONT SURFACE PART NO. 6.10 [.240] 3.18 [.125] 3.05 [.120] Ø 1.93 [.076 ±.007] TYP; 8 PLCS 5.08 ±.13 [.200 ±.005] TYP; 3 PLCS 1.50 [.059] TYP 2.26 [.089] CL LED 1.27 [.050] MOUNTING PINS TYP; 4 PLCS 5.84 [.230] [.200 ±.003] TYP; 3 PLCS 4.57 [.180] Ø [.067 ±.002] TYP; 4 PLCS 1.25 [.049] TYP 2.00 [.079] 1.09 [.043] P.C. BOARD FRONT EDGE 2.79 [.110] RECOMMENDED SOLDERPAD/HOLES LAYOUT NOTE: designed for post-reflow PC board insertion. 2.54 [.100] TYP Dimensions in mm [inches] Recommended 597-5111-4xx 597-5202-4xx 597-5311-4xx 597-5411-4xx Alternatives 597-5004-4xx 597-5112-4xx 597-5203-4xx 597-5213-4xx 597-5223-4xx 597-5312-4xx 597-5412-4xx PAGE # 1-27 1-27 1-27 1-27 1-26 1-26 1-26 1-26 1-26 1-26 1-26 Solder Pad/Holes layout shown is for single color LEDs listed under “Recommended” Category Contact factory for bi-color layout Features • • • • • • High transmissivity polycarbonate material UL94V-0 compliance ESD protection (circuit isolation from front panel) Wide viewing angle Arrays reduce insertion costs Secures to PCB by press-fit LED Data For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. Operating/Storage Temperature –30°C to +100°C Dialight Optopipe Light Pipe Description This 8 element shielded Optopipe™ resembles our 555 Series CBIs in both look and size. These bright light elements are spaced vertically 0.125" from the PCB and then 0.100" between each element. This Optopipe™ will maintain its 2.54mm LED mounting pitch when made into longer arrays. This Optopipe™ is held in place by 4 press-fit pins along the bottom of the device. The light source is a 597 Series Type, top looking LED. Made from black PBT, the light shield restricts light bleed between the elements. Both the water clear transmissive polycarbonate light pipe material and the light shield are rated UL94-V0. The light pipe has a 35% oxygen index, and the light shield has a 32% oxygen index. Dialight can provide custom Optopipe™ solutions for your applications. 2-30 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com