551-0206-003F

3mm LED CBI Circuit Board Indicator Tri-Block, .100” High LED Centerline 13.55 [.534] 4.57 [.180] TYP (2) 2.21 [.087] NOM Dimension 2 3.68 ±.25 [.145 ±.010] Dimension 3 CATHODE TYP (3) 3X 2.54 [.100] 5.08 [.200] 2X 4.57 [.180] Green Yellow Red A A A 551-1106-003 551-1206-003 551-1306-003 Red Yellow Green B B B * LED1, LED 2, LED 3 Dimension 4 2.54 ±.05 [.100 ±.002] 551-0206-003 551-0306-003 551-0406-003 LOW CURRENT 90° LED 0.51 [.020] COLOR* CHART HIGH EFFICIENCY HOUSING 0.51 [.020] 4.57 [.180] 2.54 [.100] PART NO. 6.35 [.250] Dimension 1 551-xx06-003 Custom Combinations 4.57 ±.05 [.180 ±.002] • Contact factory for information on custom color combinations RECOMMENDED PC BOARD HOLE PATTERN 4 Dimensions in mm [inches] Features Standard Polarity shown in drawing: Cathode right CHART A CHART B Dimension 1 2.67 [.105] 2.41 [.095] Dimension 2 3.10 ±.20 [.122 ±.008] 2.92 ±.25 [.115 ±.010] Dimension 3 .51 [.020] .46 [.018] Dimension 4 • Multiple CBIs form horizontal LED arrays on 4.57mm (0.180”) center-lines • • • • • Ø 1.09 ±.05 Ø 1.02 ±.05 [.043 ±.002] TYP (6) [.040 ±.002] TYP (6) • LEDs are safe for direct viewing per IEC 825-1, EN-60825-1 REVERSE POLARITY OPTION AVAILABLE See Part Number Ordering Code below. PART NUMBER ORDERING CODE Series LED Type High Contrast, UL 94 V-0 rated, black housing Oxygen index: 31.5% Polymer content: PBT, 0.346 g Housing stand-offs facilitate PCB cleaning Solderability per MIL-STD-202F, method 208F Tolerance note: As noted, otherwise: Tri Block • LED Protrusion: ±0.04 mm [±0.016] • CBI Housing: ±0.02mm[±0.008] 5 5 1 - x x 0 6 - 0 x 3 Polarity Option 0 - Standard Cathode Right 1 - Reverse Cathode Left Typical Operating Characteristics (TA=25°C) See LED data sheet for additional information See page 4-70 and 4-71 for Reference Only LED Drive Circuit Examples. See page 4-72 for Pin Out Part Number Color Peak Wavelength nm IV mcd VF Volts Test Current (mA) Viewing Angle 2Θ Θ½ LED Data sheet Page # 551-0206-003 551-0306-003 551-0406-003 551-1106-003 551-1206-003 551-1306-003 Green Yellow Red Red Yellow Green 563 585 650 635 585 565 16 6.3 10 1.6 1.6 1.6 2.1 2.1 2 1.7 1.8 1.9 10 10 10 2 2 2 45° 45° 45° 60° 60° 60° 521-9408 521-9428 521-9427 521-9324 521-9325 521-9326 4-64 4-64 4-64 4-60 4-60 4-60 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com 4-23 3mm Discrete LED Low Current Diffused 521-9324, -9325, -9326 4.4 [.175] 1.01 [.040] .40 [.016] 1.0 [.040] 2.54 [.100] 3.3 [.130] 5.97 [.235] 1.00 26.67 [.040] [1.05] MIN. PART NO. COLOR 521-9324 521-9325 521-9326 Red Yellow Green .40 [.016] CATHODE Dimensions in mm [inches] MOUNTING CLIP: 515-0006 located on page 4-65 Red Yellow Green -9324 -9325 -9326 Power Dissipation (mW) 20 20 20 Forward Current (mA) Derating (mA/°C) From 90°C 7 .7 7 .7 7 .7 500 500 500 Operating Temperature (°C) -55/+100 -55/+100 -55/+100 Storage Temperature (°C) -55/+100 -55/+100 -55/+100 ABSOLUTE MAXIMUM RATINGS (TA=25°C) Peak Current (mA) Pulse width = 10 µs Soldering Temperature 260°C, 5 seconds, 1.6 mm from case Solder Adherence per MIL-STD-202E, Method 208C OPERATING CHARACTERISTICS (TA=25°C) Red Yellow Green -9324 -9325 -9326 Luminous Intensity (mcd) IF=2mA Min. Typical 1 1.6 1 1.6 1 1.6 Peak Wavelength (nm) λ Peak Typical 635 585 565 Viewing Angle (2Θ ½) Typical 60° 60° 60° Forward Voltage (V) IF=2mA Typical Max. 1.7 2.2 1.8 2.7 1.9 2.2 Reverse Voltage (V), IR=50µA Min. 5 5 5 Θ is the off axis angle at which the luminous intensity is half the axial luminous intensity  4-60 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com 3mm Discrete LED High Efficiency Diffused 4.70 ±.20 [.185 ±.008] .79 ±.20 [.031 ±.008] 521-94xx TYPE 521-9408 521-9427 521-9428 3.30 [.130] MAX .50 [.020] NOM COLOR Green Red Yellow 2.49 ±.25 [.098 ±.010] 3.09 ±.20 [.122 ±.008] 1.30 ±.25 [.051 ±.010] 1.0 [.040] 24.00 ±.25 [.945 ±.010] 6.10 ±.38 [.240 ±.015] .50 [.020] NOM CATHODE (–) MOUNTING CLIP: 515-0006 located on page 4-65 Dimensions in mm [inches] Green Red Yellow -9408 -9427 -9428 Power Dissipation (mW) 75 60 60 Forward Current (mA) 25 20 20 ABSOLUTE MAXIMUM RATINGS (TA=25°C) Derating (mA/°C) .5 .5 .5 60 60 60 Operating Temperature (°C) -25/+85 -25/+85 -25/+85 Storage Temperature (°C) -30/+100 -30/+100 -30/+100 From 50°C Peak Current (mA) Soldering Temperature 260°C, 5 seconds, 1.6 mm from case Solder Adherence per MIL-STD-202E, Method 208C OPERATING CHARACTERISTICS (TA=25°C) Green Red Yellow -9408 -9427 -9428 Luminous Intensity (mcd) IF=10mA Min. Typical 5.6 16 3.6 10 2.2 6.3 Peak Wavelength (nm) λ Peak Typical 563 650 585 Viewing Angle (2Θ ½) Typical 45° 45° 45° Forward Voltage (V) IF=10mA Typical Max. 2.1 3 2 3 2.1 3 Reverse Voltage (V), IR=10µA Min. 3 3 3 Θ  is the off axis angle at which the luminous intensity is half the axial luminous intensity 4-64 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com