AH289-Y

AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Features • • • • • • • • • On Chip Hall Sensor Rotor-Locked Shutdown Automatically Restart Rotor-State Detection (RD) Output Built-in Zener Protection for Output Driver Operating Voltage: 3.8V~28V Output Current: IO (AVE) = 400mA Lead Free Finish/RoHS Compliant for Lead Free products (Note 1) Lead Free Packages: SIP-5L and SOT89-5L General Description AH289 is a monolithic fan motor controller with Hall sensor’s capability. It contains two complementary open-drain transistors for motors coil driving, an automatic lock current shutdown, and recovery protection. In addition, the Rotor-State Detection (RD) output is for Rotor-State Detection. Rotor-lock shutdown detection circuit turns off the output driver when the rotor is blocked to avoid coil overheat. Then, the automatic recovery circuit will restart the motor. These protected actions are repeated and periodic during the blocked period. Until the blocking is removed, the motor recovers and runs normally. Ordering Information - A H289 XXX Package P: SIP-5L Y: SOT89-5L Note: 1. Lead L : Lead Free Packing -B : Bulk -13 : Taping RoHS revision 13.2.2003. Glass and High Temperature Solder Exemptions Applied, see EU Directive Annex Notes 5 and 7. Device Lead-free Package Code P Y Packaging SIP-5 SOT89-5 Quantity Lead-free AH289-P AH289-Y Tube/Bulk Part Number Suffix 1000 -B NA NA 7” Tape and Reel Part Number Suffix NA NA 2500/Tape & Reel -13 Quantity Note: 2. Pad layout as shown on Diodes Inc. suggested pad layout document AP02001, which can be found on our website at http://www.diodes.com/datasheets/ap02001.pdf. Pin Assignment 289 ( Front View ) 1 : RD 2 : VCC 3 : DO 4 : DOB 5 : GND VCC 1 GN D 2 289 5 RD DO 3 SOT89-5L 7 DOB 4 123 45 SIP-5L AH289 Rev. 3 1 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Pin Descriptions Symbol RD Vdd DO DOB GND Description Rotor-State Detection Input Power Output Pin Output Pin Ground Block Diagram Vdd 2 Lock Shutdown and Automatic Recovery Regulator 3 Hall Plate DO Amp. Control Logic 4 DOB 5 GND 1 RD AH289 Rev. 3 2 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Typical Application Circuit D2 Vdd (24V) R pu D1 1 2 3 4 5 289 Coil 2 Coil 1 RD GND 48V C1=1uF 48V 24V DC Brush-Less Fan with RD Output Function Absolute Maximum Ratings Characteristics Supply Voltage Output Current Power Dissipation Operating Temperature Storage Temperature Maximum Junction Temperature Thermal Resistance ( TA = 25°C ) Symbol VCC IO (AVE) PD Topr Tstg Tj θJA SIP5 SOT89-5 SIP5/SOT89-5 IO (PEAK) SIP5 SOT89-5 Rating 30 400 700 550 800 -40 ~ 100 -55 ~ 150 150 227 156 Unit V mA mW °C °C °C °C/W °C/W TA TJ Tc θ JA θ JC Note: θ JA should be confirmed with what heat sink thermal resistance. If no heat sink contacting, θ JA is almost the same as θ JC . JANUARY 2007 AH289 Rev. 3 3 of 9 www.diodes.com © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Electrical Characteristics Characteristics Supply Voltage Supply Current Output Leakage Current Locked Protection On Locked Protection Off Output Saturation Voltage Output On Resistance RD Output Vds Output Zener-Breakdown Voltage *Note: ( TA = 25 °C, Vdd = 24V, unless otherwise specified ) Symbol Vdd Icc Ioff Tlrp-on Tlrp-off VOUT(SAT) Rds(on) Vol Vz Conditions Operating Operating VOUT = 24V Min. 3.8 0.4 2.4 Typ. 2.0 < 0.1 0.46 2.76 450 680 2.25 0.3 55 Max. 28 * 4.0 10 0.6 3.6 700 800 3.5 0.5 65 Unit V mA µA Sec Sec mV ohm V V IO = 200mA IO = 300mA IO = 200mA IO = 10mA 42 Please watch the current limit issue when the operation voltage is over 26.4V, because of the different efficiency in the coil. Truth Table INH L - IN+ L H - CT L L H OUT1 H L off OUT2 L H off RD L L H Mode Rotating Rotating Lockup protection activated Magnetic Characteristics ( TA = 25 °C, Vdd = 24V, unless otherwise specified ) ( 1mT = 10 Gauss ) Characteristics Operation Point Release Point Hysteresis Symbol Bop Brp Bhy Min. 10 -60 -Typ. 30 -30 60 Max. 60 -10 -Unit Gauss Gauss Gauss AH289 Rev. 3 4 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Operating Characteristics DOB Output Voltage in Volts DO RP 24 20 16 12 8 Output Voltage in Volts OFF OFF 24 20 16 12 8 OP ON 4 OP VSAT RP 4 ON VSAT Brp 0 Bop Brp 0 Bop Magnetic Flux Density in Gauss Magnetic Flux Density in Gauss S Marking side S Marking side N ( SIP5 ) N ( SOT89-5 ) AH289 Rev. 3 5 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Performance Characteristics TA (°C) PD (mW) TA (°C) PD (mW) 25 550 105 198 50 440 110 176 ( SIP-5L ) 60 396 115 154 70 352 120 132 80 308 125 110 85 286 130 88 90 264 135 66 95 242 140 44 100 220 150 0 Pd (mW) 600 500 400 300 200 100 0 0 15 30 P ower Dissipation Curve 45 60 75 90 105 100 120 135 150 Ta (°C) Performance Characteristics TA (°C) PD (mW) TA (°C) PD (mW) P D (mW ) 900 800 700 600 500 400 300 200 100 0 0 25 ( SOT89-5L ) 25 800 105 288 50 640 110 256 60 576 115 224 70 512 120 192 75 480 125 160 80 448 130 128 85 416 135 96 90 384 140 64 95 352 145 32 100 320 150 0 P ower Dissipation Curve 50 75 100 125 150 T A (°C) AH289 Rev. 3 6 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Marking Information (1) SIP-5L ( Front View ) Part Number 289 Y WW X X L : Lead Free Package Y :Year: "1" = 2001 "2" = 2002 WW : Nth week 01~52 X : Internal Code: A ~ Z (2) SOT89-5L 5 4 7 Y : Year: 0-9 M : Month: A~L 289 Y M X X : Internal code a~z : Lead Free 1 2 3 AH289 Rev. 3 7 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Package Information (1) Package type: SIP-5L (unit: mm) Location of Sensing Point 2.006 mm [0.079 inch] ( Top View) 1.016 mm [0.04 inch] 1 2 3 4 5 AH289 Rev. 3 8 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated AH289 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Package Information ( Continued ) Sensor Location IMPORTANT NOTICE Diodes Incorporated and its subsidiaries reserve the right to make modifications, enhancements, improvements, corrections or other changes without further notice to any product herein. Diodes Incorporated does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights, nor the rights of others. The user of products in such applications shall assume all risks of such use and will agree to hold Diodes Incorporated and all the companies whose products are represented on our website, harmless against all damages. LIFE SUPPORT Diodes Incorporated products are not authorized for use as critical components in life support devices or systems without the expressed written approval of the President of Diodes Incorporated. AH289 Rev. 3 9 of 9 www.diodes.com JANUARY 2007 © Diodes Incorporated