CEBM10016TA

CAPACITORS For general purpose Wide CV value range ALUMINIUM ELECTROLYTIC STANDARD RADIAL CEBM SECTION 1 Life 2000 hours at +85°C Safety vent construction products RANGE V µF 0.1 0.22 0.33 0.47 1.0 2.2 3.3 4.7 10 22 33 47 100 220 330 470 1000 2200 3300 4700 6800 10000 15000 6.3 øxl/mm 6.3x11 8x11.5 10x12.5 12.5x20 12.5x20 16x25 16x25 16x31.5 18x35.5 10 øxl/mm 5x11 6.3x11 8x11.5 8x11.5 10x16 12.5x20 12.5x25 16x25 16x31.5 18x35.5 18x35.5 16 øxl/mm 6.3x11 8x11.5 8x11.5 10x12.5 10x20 12.5x25 16x25 16x31.5 18x32 18x35.5 25 øxl/mm 5x11 6.3x11 8x11.5 10x12.5 10x16 12.5x20 16x25 16x31.5 18x35.5 18x35.5 35 øxl/mm 5x11 6.3x11 8x11.5 10x12.5 10x16 10x20 12.5x25 16x31.5 18x35.5 18x35.5 50 øxl/mm 5x11 6.3x11 6.3x11 8x11.5 10x16 10x20 12.5x20 16x25 16x34.5 18x35.5 63 øxl/mm 5x11 6.3x11 6.3x11 8x11.5 10x12.5 10x20 12.5x20 12.5x25 16x31.5 22x40 100 øxl/mm 5x11 5x11 5x11 5x11 5x11 6.3x11 8x11.5 10x12.5 10x16 12.5x20 16x25 16x25 16x31.5 18x40 160 øxl/mm 6.3x11 6.3x11 6.3x11 8x11.5 8x11.5 10x12.5 10x20 12.5x20 12.5x25 16x25 18x35.5 200 øxl/mm 6.3x11 6.3x11 6.3x11 8x11.5 10x12.5 10x16 10x20 12.5x25 12.5x25 16x31.5 22x35.5 250 øxl/mm 5x11 5x11 6.3x11 6.3x11 8x11 8x11 10x16 10x16 10x20 12.5x25 12.5x25 16x31.5 400 øxl/mm 6.3x11 6.3x11 6.3x11 6.6.3x11 8x11.5 8x11.5 10x16 10x20 12.5x20 16x25 16x31.5 18x35.5 450 øxl/mm 6.3x11 6.3x11 6.3x11 6.3x11 8x11 10x16 10x20 12.5x20 12.5x25 16x31.5 18x35.5 18x40 Sizes may reduce as technology continually improves. ORDERING INFORMATION CEBM Range 100 Capacitance µF 16 Voltage V TA Options: TA = Tape/Ammo-box Blank = Loose CRxx = Cropped to xxMM TA = 5mm pitch, e.g. TA 2mm = 2mm pitch 33 F ax: 01371 875075 www.dubilier.co.uk Tel: 01371 875758 CAPACITORS ALUMINIUM ELECTROLYTIC STANDARD RADIAL CEBM SPECIFICATION Item Operating Temperature Range Rated Working Voltage Range Nominal Capacitance Range Capacitance Tolerance Leakage Current tan ∂ Ripple Current Low Temperature Characteristics Impedance High Temperature Loading Shelf Life Performance Characteristics -40 to +85°C -25 to +85°C 6.3 to 100V DC 160 to 450V DC 0.47 to 15000µF 0.47 to 220µF ± 20% (120Hz, +20°C) l ≤ 0.01CV or 3[µA] after 2 minutes l ≤ 0.06CV [µA] after 2 minutes whichever is greater measured with application of rated working voltage at +20°C rated working voltage applied at +20°C Working voltage [V] 6.3 10 16 25 35 50 63 100 tan ∂ (max.) 0.22 0.19 0.16 0.14 0.12 0.10 0.09 0.08 Working voltage [V] 160 200 250 400 450 tan ∂ (max.) 0.16 0.18 0.18 0.20 0.20 (120Hz, +20°C) or capacitance value > 1000µF, add 0.02 per extra 1000µF F Refer to standard products table (120Hz, +85°C) Correction factor for frequency Frequency [Hz] 50/60 120 1K 10K Correction factor (Multiplier) 0.7 1 1.3 1.7 Impedance ratio max. at 120Hz Working voltage [V] 6.3 10 16 25 35 50 63 100 -25°C/+20°C 4 3 2 2 2 2 2 2 -40°C/+20°C 8 6 4 4 3 3 3 3 Working voltage [V] 160 200 250 400 450 -25°C/+20°C 2 2 3 15 15 For capacitance value > 1000µF, Add 0.5 per extra 1000µF for 25°C/+25°C. Add 1.0 per extra 1000µF for 40°C/+20°C. M aximum C-Z (rated cap-[µF] x Impedance [Ω]) value at 10KHz Working voltage [V] 6.3 10 16 25 35 50 63 100 C-Z max. at +20°C 220 160 125 90 80 60 55 50 C-Z max. at -25°C 3000 1900 1300 800 650 560 500 450 Working voltage [V] 160 200 250 450 C-Z max. at +20°C 100 140 150 270 C-Z max. at -25°C 2400 2500 3100 12000 Test conditions Duration 2000 hours Ambient temperature +85°C Applied voltage Rated DC working voltage Post test requirements at +20°C Leakage current ≤ Initial specified value Capacitance change ≤ ± 20% of initial measured value tan ∂ ≤ 150% of initial specified value Test conditions Duration 500 hours Ambient temperature +85°C Applied voltage (None) Post test requirements at +20°C. Same limits for high temperature loading. SECTION 1 34 F ax: 01371 875075 www.dubilier.co.uk Tel: 01371 875758 CAPACITORS ALUMINIUM ELECTROLYTIC STANDARD RADIAL CEBM PERMISSIBlE RIPPlE CuRRENT mA (rms) 85˚C/120Hz SECTION 1 Volts µF 0.47 1.0 2.2 3.3 4.7 10 22 33 47 100 220 330 470 1000 2200 3300 4700 6800 10000 15000 6.3 100 170 210 300 530 990 1150 1700 1900 2250 2680 10 65 75 110 190 330 330 620 1050 1350 1800 2150 2500 2950 16 55 70 80 140 240 300 420 740 1200 1200 2100 2500 2600 25 60 70 90 150 260 380 500 950 1500 1900 2360 2500 35 30 45 60 80 110 190 330 450 510 1050 1750 2220 2400 50 63 100 160 10 15 20 35 40 65 130 180 220 300 640 200 12 17 20 35 45 70 130 190 180 400 660 250 14 15 25 30 40 70 130 160 210 310 400 14 19 28 32 41 70 120 140 225 450 14 19 29 35 50 75 110 170 230 5 5 10 10 10 15 20 29 25 25 30 30 30 35 35 45 50 70 70 115 110 110 100 160 120 150 210 200 260 380 460 600 540 650 860 740 850 1100 1350 1550 1350 1850 2300 2170 OuTlINE DRAwING L+1 15 min 5 min P Vinyl Sleeve dø Dø ± 0.5 Dø P dø 5 6.3 2.0 2.5 0.5 8 3.5 10 5.0 0.6 13 5.0 16 7.5 18 7.5 0.8 22 10.0 For smaller case size options refer to sales office and discuss CEBR. Dimensions in mm +0.5 35 F ax: 01371 875075 www.dubilier.co.uk Tel: 01371 875758