4114N/2H7P

Max. 570 m /h DC axial fans 3  119 x 38 mm – Possible special versions: Housing: Die-cast aluminum (See chapter DC fans - specials) Impeller: GRP1) (PA) - Speed signal Direction of air flow: Intake over struts - Go / NoGo alarm Direction of rotation: Clockwise, looking - Alarm with speed limit towards rotor - External temperature sensor Connection: Via single wires AWG 18, 20 or - Internal temperature sensor AWG 22, TR 64, speed signal - PWM control input (standard) and control input AWG 22 - Analog control input Highlights: Highly efficient and smoothly - Moisture protection operating 3-phase fan drive - Salt spray protection Housing with grounding lug for screw M4 x 8 (Torx) Weight: 425 g – Material: – – – – – m3/h cfm VDC VDC 4114 N/2 H7P 500 294 24 16...30 76 8.5 90 9 500 -20...+75 57 500 / 25 000 97 500 4114 N/2 H8P 570 336 24 16...30 78 8.9 120 11 000 -20...+75 55 000 / 22 500 92 500 4118 N/2 H7P 500 294 48 36...60* 76 8.5 90 9 500 -20...+75 57 500 / 25 000 97 500 4118 N/2 H8P 570 336 48 36...60* 78 8.9 120 11 000 -20...+75 55 000 / 22 500 92 500 Subject to change * 36...72 VDC on request. dB(A) Bel(A) Speed control range from 500 rpm-1 up to maximum nominal speed. Standstill at 0% PWM, maximum speed if control cable is interrupted. To attain the specified service life, an external capacitor must be wired between the plus and minus strands. Please note the wiring suggestion on page 16. ** Power consumption at free air flow, these values can be significantly higher in the operating point. ** Power consumption - in operation Fan type optimum operating range (W) 4114 NH7P 100 4114 NH8P 160 4118 NH7P 100 4118 NH8P 160 Tin-p la Air performance measured according to: ISO 5801. Installation category A, without contact protection. Noise: Total sound power level LWA ISO 103002 measured on a hemisphere with a radius of 2 m. Sound pressure level LpA measured at 1 m distance from fan axis. The values given are applicable only under the specified measuring conditions and may differ depending on the installation conditions. In the event of deviation from the standard configuration, the parameters must be checked after installation! For detailed information see http://www.ebmpapst.com/general conditions 62 Finger guards from p. 242 ted Hours Hours Curve Life expectancy L10IPC (40 °C) see page 17 Service life L10 (Tmax) ebm-papst standard Type Nominal data 2016-01 Service life L10 (40 °C) ebm-papst standard Temperature range Power consumption** Nominal speed Sintec sleeve bearings Ball bearings Sound power level °C Voltage range rpm-1 Nominal voltage Watts Air flow / Air flow Series 4100 N High Performance Sound pressure level 1) Fiberglass-reinforced plastic ¿ ¡ ¿ ¡