8PH100

8PH SINGLE-PHASE FULL WAVE BRIDGE 8 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING ponent der the com cognition un s, inc. dicates re This mark in derwriters Laboratorie of Un program PRV/Leg Type No. 50V 8PH05 100V 8PH10 200V 8PH20 400V 8PH40 600V 8PH60 800V 8PH80 1000V 8PH100 ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unl es s Oth erw ise Spe ci fie d) Average Output Current. lo @65 C Tc (Fig.1) Max. Forward Voltage Drop, VF=1.0 V @ IF = Max.DC Reverse Current @ PRV, IR Max.DC Reverse Current @ PRV,and 100 OC, IR Max.Peak Surge Current, IFSM Thermal Resistance , R0 j -c Ambient Operating Temperature Range,TA Storge TemperatureRange,T STG (8.3ms) (Fig.2) O 8 2.5 10 300 300 5.8 -55 to +150 -55 to +150 Amp Amp A A Amp o C/ W o C C o Note 1:Derate Io by 20% for capacitive loads EDI reserves the right to change these specifications at any time without notice 8PH FIG.1 CURRENT DERATING 12 lO.AVERAGE FORWARD CURRENT(AMP) L BRIDGE OUTPUT RES.-IND. LOADS MAX.PEAK SURGE CURRENT IFSM Derate current by 20% for capacitive loads 65 O 1000 500 FIG.2 NON-REPETITIVE SURGE CURRENT 10 8 200 100 TC HEAT SINK MOUNTING 6 65 O TL PC BOARD MOUNTING WITH 3/8 LEADS   4 2 50 20 10 0 0 25 50 75 O 100 125 150 1 2 5 10 20 50 100 TEMPERATURE ( C) NUMBER OF CYCLES AT 60 CPS FIG.3 CASE STYLE FOR 8PH .935 .895 .280 .260 .160 .140 .700 .660 .760Max .185 .165 45 .085 .065 .455 .405 .075R.Typ. (2 Places) 1.0Min .260 .180 .205 .185 .220 .180 .052 .048 C. Dielectric test voltage 2,500 V rms.,max. 50-60Hz NOTE Maximum lead and terminal temperature for soldering, 3/8 inch from case, 5 seconds at 250 ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 * FAX 914-965-5531 * 1-800-678-0828 E e-mail:sales@edidiodes.com * website: http://www.edidiodes.com W