HPS15Q-N3R-008

HPS15Q-N3R-008

  • 厂商:

    EMERSON-NETWORKPOWER(艾默生)

  • 封装:

  • 描述:

    HPS15Q-N3R-008 - HPS10/12/15 Series - Emerson Network Power

  • 详情介绍
  • 数据手册
  • 价格&库存
HPS15Q-N3R-008 数据手册
1000-6000 Watts HPS10/12/15 Series Electrical Specs Input Input voltage Frequency Inrush current Efficiency Power factor Turn-on time 85-264 VAC* 47-440 Hz 40 A peak max. 85% typ @ full case load 230 VAC 0.99 typical meets EN61000-3-2 AC on 1.5 sec. typical, Inhibit / Enable 100 ms typical CISPR 22 EN55022 Level “B” 2 mA max @ 264 VAC @ 60Hz (per module) CISPR 22 EN55022 Level “B” 20 ms minimum (independent of input VAC) >5 ms early warning min. before outputs lose regulation; Full cycle ride thru (50 Hz) Meets EN61000-3-2 Meets EN60950 Special Features • • • • • • • • • • • • • • • • • • • • • • • • • • Integrated OR-ing diode Remote Sense on Bulk output Overload protection on all outputs Active Inrush limiting PFC to 0.99 typical EN61000-3-2 CISPR22, EN55022 Curve B conducted/radiated EMI EN61000 immunity standards Optional 48 W fan voltage (12 V or 24 V) Standard 5 V at 5 A standby voltage (3.3V option) No minimum load Overvoltage protection Input OK signal and indicator LED Inhibit/Enable Remote Margin/Voltage Programming Optional current monitor Optional AC Line discrimination Output Good signal and indicator LED Temp good signal and indicator LED Optional single wire digital temp monitor 2 Optional module I C interface Optional Rack µController Hot Plug N+1 Redundant Standard Optional fan fail signal Module present signal Optional short circut latch EMI filter standard Leakage current standard Radiated EMI Holdup time AC OK Harmonic distortion Isolation * see modules table on the next page Output Margining Overall reg Ripple Dynamic response Recovery time Overcurrent protection Short circuit protection Overvoltage protection Reverse voltage protection Thermal protection Remote sense Single wire parallel DC OK Minimum load Standby voltage Global Inhibit/Enable ±5% of nominal 1% 1% of Vout Pk-Pk limited to 20 MHz 2% with 25% load step To within 1% in
HPS15Q-N3R-008
1. 物料型号: - 型号包括HPS10、HPS12和HPS15,分别对应1000瓦、1200瓦和1500瓦的功率等级。

2. 器件简介: - 该系列为高效率电源模块,具备集成OR-ing二极管、远程感应、过载保护、主动涌浪限制等功能,功率因数校正(PFC)达到0.99,满足EN61000-3-2标准。

3. 引脚分配: - AC输入引脚包括火线(LINE)、零线(NEUTRAL)和地线(GROUND)。 - DC输出引脚包括多个V OUT、RETURN(RTN)、CHASSIS GND、5VDC、DATA、MARGIN PROGRAM等。

4. 参数特性: - 输入电压范围85-264VAC,频率47-440Hz。 - 效率典型值为85%,功率因数达到0.99,满足EN61000-3-2标准。 - 隔离满足EN60950标准,EMI满足CISPR22, EN55022曲线B的传导/辐射EMI和EN61000抗扰度标准。

5. 功能详解: - 具备远程边距/电压编程、可选电流监控、可选AC线路识别、输出良好信号和指示灯等功能。 - 支持单线数字温度监控、模块间电流共享、全球禁止/启用逻辑等。

6. 应用信息: - 适用于需要高功率、高效率和高可靠性电源解决方案的应用场合。

7. 封装信息: - HPS10、HPS12和HPS15的最大尺寸均为5.04x3.83x12.5英寸,每个机架最多可安装4个模块,单个模块重量为10.5磅。
HPS15Q-N3R-008 价格&库存

很抱歉,暂时无法提供与“HPS15Q-N3R-008”相匹配的价格&库存,您可以联系我们找货

免费人工找货