B5011_1

SAW Components SAW IF Filter WiMAX Series/Type: Ordering code: Date: Version: B5011 B39461-B5011-H810 Jun 09, 2008 2.0 © EPCOS AG 2008. Reproduction, publication and dissemination of this data sheet, enclosures hereto and the information contained therein without EPCOS’ prior express consent is prohibited. SAW Components Low-Loss Filter for WiMAX Data Sheet Application s Low-loss IF filter for WiMAX s Usable bandwidth 3.7 MHz s Ceramic SMD package B5011 456.00 MHz Features Package size 7.0 x 5.0 x 1.33 mm3 Package code QCC12E RoHS compatible Approx. weight 0.2 g Package for Surface Mount Technology (SMT) s Ni, gold-plated terminals s s s s s Pin configuration s s s s s s 10 12 4 6 2, 3, 8, 9 1, 5, 7, 11 Input Input ground or balanced input Output Output ground or balanced output Ground Case ground Please read cautions and warnings and important notes at the end of this document. 2 Jun 09, 2008 SAW Components Low-Loss Filter for WiMAX Data Sheet Characteristics Operating temperature range: Terminating source impedance: Terminating load impedance: B5011 456.00 MHz T = –40 ˚C to +85 ˚C ZS = 200 Ω balanced and matching network ZL = 200 Ω balanced and matching network min. — typ. 456.00 max. — Nominal frequency Minimum insertion attenuation1) (including matching network) Amplitude ripple (p-p) fN ± 1.7 MHz fN ± 1.85 MHz Absolute group delay (at fN) Group delay ripple (p-p) fN ± 1.7 MHz Return loss fN ± 1.7 MHz Input Output fN αmin MHz — ∆α — — τ ∆τ — 8 10 — 8.5 10.0 dB 0.6 1.5 0.55 1.0 3.0 3.0 dB dB µs 120 12 14 250 — — ns dB dB Impulse response attenuation (Time/Height values are relative to the main time response lobe) 1-2 µs 2-3 µs > 3 µs Relative attenuation (relative to αmin) 1 MHz ... 256 MHz 256 MHz ... 360 MHz 360 MHz ... 416.0 MHz 416 MHz ... 452.65 MHz 459.35 MHz ... 656 MHz 656 MHz ... 946 MHz Temperature coefficient of frequency2) Turnover temperature 1) 2) 20 35 45 αrel 30 40 50 40 40 30 30 38 49 — — — dB dB dB 70 70 64 46 44 44 –0.036 20 — — — — — — — — dB dB dB dB dB dB ppm/K2 ˚C TCf T0 — — Could increase up to 10,8 dB with single ended matching network at 50 Ω Temperature dependance of fc: fc(TA) = fc(T0)(1 + TCf(TA – T0)2) Please read cautions and warnings and important notes at the end of this document. 3 Jun 09, 2008 SAW Components Low-Loss Filter for WiMAX Data Sheet Matching network to 200 Ω balanced 4:1 transformers are only required for measurement in a 50 Ω environment (element values depend on PCB layout) B5011 456.00 MHz L L L L Lp1 = 100 nH Ls2 = Ls3= 33 nH Lp4 = 22 nH Lp5= 27 nH Ls6 = Ls7= 18 nH Lp8 = 62 nH Matching network to 50 Ω single ended(element values depend on PCB layout) Ls2 Lp1 Ls5 Lp3 Lp4 Lp6 Lp1 not used; Ls2 = 47nH; Lp3 = 18 nH Lp4 = 22nH; Ls5=47nH; Lp6=47nH Maximum ratings Operable temperature range Storage temperature range DC voltage DC voltage ESD voltage Input power 1) T Tstg VDC VDC VESD PIN –40/+80 –40/+85 5 0 2001) 10 ˚C ˚C V V V dBm between input, output and ground between 10, 12 and between 4,6 machine model, 1 pulse acc. to J-STD22A-0115A (machine model, 1 pulse +/-). Please read cautions and warnings and important notes at the end of this document. 4 Jun 09, 2008 SAW Components Low-Loss Filter for WiMAX Data Sheet Transfer function B5011 456.00 MHz Transfer function (wideband Please read cautions and warnings and important notes at the end of this document. 5 Jun 09, 2008 SAW Components Low-Loss Filter for WiMAX Data Sheet Normalized transfer function B5011 456.00 MHz Transfer function (Impulse response) Please read cautions and warnings and important notes at the end of this document. 6 Jun 09, 2008 SAW Components Low-Loss Filter for WiMAX Data Sheet B5011 456.00 MHz Type Ordering code Marking and Package Packaging Date Codes S-Parameters Soldering profile B5011 B39461-B5011-H810 C61157-A7-A103 F61074-V8170-Z000 S_6001 For further information please contact your local EPCOS sales office or visit our webpage at www.epcos.com . Published by EPCOS AG Surface Acoustic Wave Components Division P.O. Box 80 17 09, 81617 Munich, GERMANY © EPCOS AG 2008. Reproduction, publication and dissemination of this brochure and the information contained therein without EPCOS’ prior express consent is prohibited. Purchase orders are subject to the General Conditions for the Supply of Products and Services of the Electrical and Electronics Industry recommended by the ZVEI (German Electrical and Electronic Manufacturers’ Association), unless otherwise agreed. This brochure replaces the previous edition. For questions on technology, prices and delivery please contact the Sales Offices of EPCOS AG or the international Representatives. Due to technical requirements components may contain dangerous substances. For information on the type in question please also contact one of our Sales Offices. Please read cautions and warnings and important notes at the end of this document. 7 Jun 09, 2008 Important notes The following applies to all products named in this publication: 1. Some parts of this publication contain statements about the suitability of our products for certain areas of application. These statements are based on our knowledge of typical requirements that are often placed on our products in the areas of application concerned. We nevertheless expressly point out that such statements cannot be regarded as binding statements about the suitability of our products for a particular customer application. As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them than the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS product with the properties described in the product specification is suitable for use in a particular customer application. We also point out that in individual cases, a malfunction of electronic components or failure before the end of their usual service life cannot be completely ruled out in the current state of the art, even if they are operated as specified. In customer applications requiring a very high level of operational safety and especially in customer applications in which the malfunction or failure of an electronic component could endanger human life or health (e.g. in accident prevention or life-saving systems), it must therefore be ensured by means of suitable design of the customer application or other action taken by the customer (e.g. installation of protective circuitry or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or failure of an electronic component. The warnings, cautions and product-specific notes must be observed. In order to satisfy certain technical requirements, some of the products described in this publication may contain substances subject to restrictions in certain jurisdictions (e.g. because they are classed as hazardous). Useful information on this will be found in our Material Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed questions, please contact our sales offices. We constantly strive to improve our products. Consequently, the products described in this publication may change from time to time. The same is true of the corresponding product specifications. Please check therefore to what extent product descriptions and specifications contained in this publication are still applicable before or when you place an order. We also reserve the right to discontinue production and delivery of products. Consequently, we cannot guarantee that all products named in this publication will always be available. The aforementioned does not apply in the case of individual agreements deviating from the foregoing for customer-specific products. Unless otherwise agreed in individual contracts, all orders are subject to the current version of the “General Terms of Delivery for Products and Services in the Electrical Industry” published by the German Electrical and Electronics Industry Association (ZVEI). The trade names EPCOS, BAOKE, Alu-X, CeraDiode, CSSP, CTVS, DSSP, MiniBlue, MKK, MLSC, MotorCap, PCC, PhaseCap, PhaseMod, SIFERRIT, SIFI, SIKOREL, SilverCap, SIMDAD, SIMID, SineFormer, SIOV, SIP5D, SIP5K, ThermoFuse, WindCap are trademarks registered or pending in Europe and in other countries. Further information will be found on the Internet at www.epcos.com/trademarks. 2. 3. 4. 5. 6. 7. 8 Jun 09, 2008