S1C17704B403100

S1C17704 Low Power 16-bit Single Chip Microcontroller ● Low Power MCU (operating voltage 1.8 V, 1 μA/SLEEP, 2.6 μA/HALT) ● 64K-Byte Flash Memory and 4K-Byte RAM ● High Quality and Stable Display LCD Driver with Voltage Booster (56 SEG × 32 COM) ● Infrared Remote Controller with Carrier Generator ● S1C17 High Performance 16-bit RISC CPU Core with C Optimized Compact Code and Serial ICE Support „ DESCRIPTIONS The S1C17704 is a 16-bit MCU that features high-speed operation, low power consumption, small size, large address space, and on-chip ICE. The S1C17704 consists of an S1C17 CPU Core, a 64K-byte Flash memory, a 4K-byte RAM, serial interface modules (UART that supports high bit rate and IrDA 1.0, SPI and I2C) for connecting various sensor modules, 8-bit timers, 16-bit timers, a PWM & capture timer, a clock timer, a stopwatch timer, a watchdog timer, 28 GPIO ports, an LCD driver with 56-segment × 32-common outputs and a voltage booster, a supply voltage detector, 32 kHz (typ.) and 8.2 MHz (max.) oscillators, and a voltage regulator for generating the 1.8 V internal voltage. The S1C17704 is capable of high-speed operation (8.2 MHz) with low operating voltage (1.8 V). Its 16-bit RISC processor executes one instruction in 1 clock cycles. The S1C17704 also provides an on-chip ICE function that allows on-board erasing/programming of the embedded Flash memory, on-board debugging and evaluating the program by connecting the S1C17704 to the ICD Mini (S5U1C17001H) with only three wires. The S1C17704 is suitable for battery driven applications with sensor interfaces and up to 56 × 32-dot LCD display, such as remote controllers and sports watches. The product lineup offers two S1C17704 models with a different main oscillator. „ FEATURES ● CPU ● Main (OSC3) oscillator ● Sub (OSC1) oscillator ● Built-in flash memory ● Built-in RAM ● Built-in display RAM ● I/O ports ● Serial interfaces ● Timers ● LCD Driver ● Supply voltage detector ● Interrupts ● Power supply voltage ● Operating temperature ● Power consumption Seiko Epson original 16-bit RISC CPU core S1C Crystal/ceramic oscillator 8.2 MHz (max.) CR oscillator 2.2 MHz (max.) Crystal oscillator 32.768 kHz (typ.) 64K bytes (for instructions and data), 1,000 erase/program cycles, Read/program protection On-board programming by a debugging tool such as ICD Mini (S5U1C17704H) and self-programming by software control 4K bytes 576 bytes Max. 28 general-purpose I/O ports (Pins are shared with the peripheral I/O.) SPI (master/slave) 1ch I2C (master) 1ch UART (115200 bps, IrDA 1.0) 1ch Remote controller (REMC) 1ch 8-bit timer (T8F) 1ch 16-bit timer (T16) 3ch PWM & capture timer (T16E) 1ch 8-bit OSC1 timer (T8OSC1) 1ch Clock timer (CT) 1ch Stopwatch timer (SWT) 1ch Watchdog timer (WDT) 1ch 56 SEG × 32 COM or 72 SEG × 16 COM (1/5 bias) Built-in voltage booster 13 programmable detection levels (1.8 V to 2.7 V) Reset, NMI, 16 programmable interrupts (8 levels) 1.8 V to 3.6 V (for normal (low-power) operation with the 1.8 V internal voltage) 2.7 V to 3.6 V (for Flash erasing/programming with the 2.5 V internal voltage) -20°C to 70°C SLEEP state: 1 μA typ. HALT state: 2.6 μA typ. (32 kHz OSC1 crystal oscillator, LCD off) SEIKO EPSON CORPORATION S1C17704 Run state: ● Shipping form 2 17 μA typ. (32 kHz OSC1 crystal oscillator, LCD off) 1950 μA typ. (8 MHz OSC3 ceramic oscillator, LCD off) TQFP24-144pin plastic package(16 mm × 16 mm × 1.0 mm, lead pitch: 0.4 mm) PFBGA6U-96 package*(6 mm × 6 mm × 1.0 mm, ball pitch: 0.5 mm) VFBGA7H-161 package(7 mm × 7 mm × 1.0 mm, ball pitch: 0.5 mm) VFBGA10H-144 package(10 mm × 10 mm × 1.0 mm, ball pitch: 0.8 mm) Chip Seiko Epson Corporation S1C17704 „ Block Diagram DCLK, DST2, DS IO(P31-33) CPU Core S1C17 32 bits 1 cyc le Internal RAM (4K byt es) TEST1-3 Flash memory (64K bytes) Display RAM (57 6 bytes) 8/16 bits 3 cycles I/O 2 (0 x5 000-) 16 bits 1-5 cycles Power generator 8 bits 2-5 cycles SVD circuit LCD driv er #RESET Test circuit Reset circuit 8/16 bits 1 cycles I/O 1 (0 x4 000-) Interrupt sy stem #TEST Oscillat or/ Clock generator 8-bit OSC t imer Pre scaler Clock timer 8-bit timer Stopwatch tim er 16-bit t imer Wat chdog timer SIN, S OUT, SCLK (P23-25) UART PWM & capture tim er SDI, S DO, SPICLK (P20-22) SPI Remote controller I 2C I/O port/ I/O MUX SDA, SCL (P14- 15) SEG 0-5 5/71, COM0-31/15 MISC regist er Interrupt controller EXCL0-2 (P16, P07, P06) VDD, VSS, VD1, VD2, VC1-VC5, CA-CG OSC1- 2, OSC3-4 FOUT1( P13), FOUT3( P30) EXCL3(P27), TOUT(P26) REMI(P04), REMO(P05) P0 0- 07, P10-17, P2 0- 27, P30-33 NOTICE: No part of this material may be reproduced or duplicated in any form or by any means without the written permission of Seiko Epson. Seiko Epson reserves the right to make changes to this material without notice. Seiko Epson does not assume any liability of any kind arising out of any inaccuracies contained in this material or due to its application or use in any product or circuit and, further, there is no representation that this material is applicable to products requiring high level reliability, such as, medical products. Moreover, no license to any intellectual property rights is granted by implication or otherwise, and there is no representation or warranty that anything made in accordance with this material will be free from any patent or copyright infringement of a third party. This material or portions thereof may contain technology or the subject relating to strategic products under the control of the Foreign Exchange and Foreign Trade Law of Japan and may require an export license from the Ministry of Economy, Trade and Industry or other approval from another government agency. All brands or product names mentioned herein are trademarks and/or registered trademarks of their respective companies. ©Seiko Epson Corporation 2010, All rights reserved * This product uses SuperFlash® Technology licensed from Silicon Storage Technology, Inc. „ Epson semiconductor website SEIKO EPSON CORPORATION SEMICONDUCTOR OPERATIONS DIVISION http://www.epson.jp/device/semicon_e/ IC Sales Department IC International Sales Group 421-8 Hino, Hino-shi, Tokyo 191-8501, JAPAN Phone: +81-42-587-5814 FAX: +81-42-587-5117 Document code: 411717801 First issue Oct, 2009 Revised Feb, 2010 in Japan Seiko Epson Corporation 3