LM358M

Dual Operational Amplifiers DESCRIPTION The LM358 consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage. Application areas include transducer amplifiers, dc gain blocks and all the conventional op amp circuits. LM358M FEATURES Wide range of supply voltages Low supply current drain independent of supply voltage Low input biasing current Low input offset voltage and offset current Input common-mode voltage range includes ground Differential input voltage range equal to the power supply voltage DC voltage gain 100 V/ mV Typ Internally frequency compensation ELECTRICAL CHARACTERISTICS at specified free-air temperature, Vcc = 5 V (unless otherwise noted) PACKAGE INFORMATION LM358/ LM358M/ LM358MMK PARAMETER VIO Input offset voltage αVIO Average temperature coefficient of input offset voltage lIO Input offset current TEST CONDITIONS* Vcc = 5 V to MAX, VIC = VICR min, Vo=1.4 V 25 °С Full range Full range Vo=1.4 V 25 °С Full range Full range 25 °С Full range 25° С Full range 25 °С Full range Full range Full range 25 °С Full range 25 °С 25 °С 25 °С 25 15 65 65 MIN TYP 3 7 2 10 -20 MAX 7 9 UNIT mV µV/°C 50 150 nA pA/°C αlIO Average temperature coefficient of input offset current IIB Vo=1.4 V Input bias current VICR Vcc = 5 V to MAX Common-mode input voltage range VOH High-level output voltage VOL Low-level output voltage AVD Large-signal differential voltage amplification CMRR Common-mode rejection ratio kSVR Supply voltage rejection ratio (∆Vcc/∆VIO) Vo1 /Vo2 Crosstalk attenuation lo Output current RL ≥2 KΩ (NOTE 1) Vcc = MAX, RL=2 kΩ Vcc = MAX, RL ≥ 10 kΩ RL ≥ 10 kΩ Vcc = 15 V, Vo=1V to 11 V, RL ≥ 2 kΩ Vcc = 5 V to MAX, VIC = VICR min Vcc = 5 V to MAX f=1 kHz to 20 kHz -250 -500 nA V V 0 to Vcc-1.5 0 to Vcc - 2 Vcc-1.5 26 27 28 5 100 20 mV V/mV 80 100 120 dB dB dB Vcc = 15 V, 25 °С -20 -30 mA VID=1 V,VO= 0 Full range -10 Vcc = 15 V, 25 °С 10 20 VID = - 1 V, Vo = 15 V Full range 5 VID = - 1 V, 25 °С 12 30 µA Vo =200 mV lOS Vcc at 5 V, 25 °С ±40 ±60 mA Short-circuit output current GND at -5 V,Vo=0 ICC Vo - 2.5 V, No load Full range 0.7 1.2 mA Supply current (two amplifiers) Vcc = MAX, Full range 1 2 Vo = 0.5Vcc, No load • All characteristics are measured under open-loop conditions with zero common-mode input voltage unless otherwise specified. “MAX” VCC for testing purposes is 30 V. Full range is 0 °С to 70 °С. Note1 Only for LM358 1 LM358M Dual Operational Amplifiers PAD LOCATION LM358M 2 1 3 4 8 5 6 7 Chip Size: 0.8 x 0.95 mm2 PAD LOCATION COORDINATES Pad N 1 2 3 4 5 6 7 8 Pad Name #1 OUT #1 IN#1 IN+ GND #2 IN+ #2 IN#2 OUT VCC Pad size (µm × µm) 95 x 95 95 x 95 95 x 95 95 x 95 95 x 95 95 x 95 95 x 95 95 x 95 Coordinates, µm X Y 657,5 807,5 116,5 831,5 660,5 116,5 475 116,5 289,5 116,5 118,5 116,5 657,5 142,5 687,5 474,5 2