AZ852PJ-6DE

AZ852PJ-6DE

  • 厂商:

    ETC

  • 封装:

  • 描述:

    AZ852PJ-6DE - MICROMINIATURE POLARIZED RELAY - List of Unclassifed Manufacturers

  • 详情介绍
  • 数据手册
  • 价格&库存
AZ852PJ-6DE 数据手册
AZ852 MICROMINIATURE POLARIZED RELAY FEATURES • Conforms to IEC60950/UL60950/EN60950 spacing and high breakdown voltage Supplementary insulation mains voltage 250 Vrms (SMT); 200 Vrms (THT) Pollution Degree 2 (external); 1 (internal) • Monostable and bistable (latching) coil versions available • High dielectric and surge voltage: 2.5 KV surge (per Bellcore TA–NWT–001089) 2.5 KV surge (per FCC Part 68) 1,000 Vrms, open contacts • Stable contact resistance for low level signal switching • Epoxy sealed • UL, CUR pending CONTACTS Arrangement Ratings DPDT (2 Form C) Bifurcated crossbar contacts Resistive load: Max. switched power: 60 W or 62.5 VA Max. switched current: 2.0 A Max. switched voltage: 220 VDC* or 250 VAC * Note: If switching voltage is greater than 30 VDC, GENERAL DATA Life Expectancy Mechanical Electrical Operate Time (typical) Release Time (typical) Bounce (typical) Capacitance Minimum operations 1 x 108 1 x 105 at 0.5 A, 125 VAC, Res. 1 x 105 at 2.0 A, 30 VDC, Res. 1 ms at nominal coil voltage 1 ms at nominal coil voltage (with no coil suppression) At 10 mA contact current 1 ms at operate or release < 2 pF at 10 KHz - coil to contacts < 1 pF at 10 KHz - between open contacts < 2 pF at 10 KHz - between contact sets See table Greater than 10% of nominal coil voltage 109 ohms min. at 25°C, 500 VDC, 50% RH At nominal coil voltage -40°C (-40°F) to 85°C (185°F) -40°C (-40°F) to 105°C (221°F) Operational, 20 g, 10–1,000 Hz Operational, 50 g min., 11 ms Non-destructive, 500 g min., 0.5 ms P.B.T. polyester, UL 94 V-0 Tinned copper alloy, P.C. 260°C (500°F) 10 seconds 0.8 grams 50 per plastic tube, 1000 per carton box 1000 per reel, 1000 or 5000 per carton box special precautions must be taken. Please contact the factory. Rated Load UL/CUR 0.5 A at 125 VAC 2.0 A at 30 VDC 0.24 A at 220 VDC Palladium Ruthenium; gold clad < 50 milliohms initially at 20 mV, 10 mA Material Resistance Dielectric Strength (at sea level) Dropout Insulation Resistance COIL (Polarized) Power At Pickup Voltage (typical) Max. Continuous Dissipation Temperature Rise 79 mW (3–12 VDC) 98 mW (24 VDC) 0.73 W at 20°C (68°F) At nominal coil voltage 21°C (38°F) (3–12 VDC) 30°C (54°F) (24 VDC) Max. 115°C (239°F) Ambient Temperature Operating Storage Vibration Shock Enclosure Terminals Max. Solder Temp. Temperature NOTES 1. 2. 3. 4. 5. All values at 20°C (68°F). Relay may pull in with less than “Must Operate” value. Relay has fixed coil polarity. Specifications subject to change without notice. Ultrasonic cleaning is not recommended. Max. Solder Time Weight Packing unit in pcs ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-03-11 Junkersstrasse 3, D-82178 Puchheim, Germany EU AZ852 RELAY ORDERING DATA NON-LATCHING VERSION Nominal Coil VDC 1.5 3 4.5 5 6 9 12 24 Must Operate VDC 1.13 2.10 3.15 3.50 4.20 6.30 8.40 16.80 Max. Continuous VDC 3.4 6.8 10.3 11.4 13.7 20.4 27.3 45.6 Coil Resistance Ohm ± 10% 16 64 145 178 257 574 1,028 2,880 THT AZ852N–1.5DE AZ852N–3DE AZ852N–4.5DE AZ852N–5DE AZ852N–6DE AZ852N–9DE AZ852N–12DE AZ852N–24DE ORDER NUMBER Gull Wing* AZ852G–1.5DE AZ852G–3DE AZ852G–4.5DE AZ852G–5DE AZ852G–6DE AZ852G–9DE AZ852G–12DE AZ852G–24DE J-Leg* AZ852J–1.5DE AZ852J–3DE AZ852J–4.5DE AZ852J–5DE AZ852J–6DE AZ852J–9DE AZ852J–12DE AZ852J–24DE LATCHING VERSION Nominal Coil VDC 1.5 3 4.5 5 6 9 12 24 Must Operate VDC 1.13 2.25 3.38 3.75 4.50 6.75 9.00 18.00 Max. Continuous VDC 4.1 8.1 12.1 13.5 16.2 24.2 32.3 41.9 Coil Resistance Ohm ± 10% 23 90 203 250 360 810 1,440 2,880 THT AZ852PN–1.5DE AZ852PN–3DE AZ852PN–4.5DE AZ852PN–5DE AZ852PN–6DE AZ852PN–9DE AZ852PN–12DE AZ852PN–24DE ORDER NUMBER Gull Wing* AZ852PG–1.5DE AZ852PG–3DE AZ852PG–4.5DE AZ852PG–5DE AZ852PG–6DE AZ852PG–9DE AZ852PG–12DE AZ852PG–24DE J-Leg* AZ852PJ–1.5DE AZ852PJ–3DE AZ852PJ–4.5DE AZ852PJ–5DE AZ852PJ–6DE AZ852PJ–9DE AZ852PJ–12DE AZ852PJ–24DE * Available only in Tape and Reel available (1K pcs/reel minimum) INITIAL DIELECTRIC STRENGTH (minimum) VRMS, 1 min. Between open contacts Between contact sets Between coil and contacts 1,000 1,000 1,800 Peak (V) 1,500 1,500 2,500 SURGE Rise Time (µs) 2 (10) 2 (10) 2 (10) Decay Time* (µs) (1/2 peak) 10 (160) 10 (160) 10 (160) * Decay time measured from beginning of surge. Temperature Profile Recommended Soldering Profile according CECC 00802 ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-03-11 Junkersstrasse 3, D-82178 Puchheim, Germany EU AZ852 MECHANICAL DATA PC BOARD LAYOUT Narrow Version Narrow Version Non-latching type not energized condition WIRING DIAGRAM ø min 0.75 TOP VIEW Gull Wings Gull Wings Latching type, 1 coil RESET condition J Legs J Legs TOP VIEW VIEWED TOWARD TERMINALS DIMENSIONS NARROW L W H T T1 T2 D1 D2 Tw S mm 10 ±0.08 5.7 ±0.3 5.85 -0.15 3.2 N/A 3.2 ±0.1 3.2 ±0.15 2.2 ±0.15 0.4 0.3 ±0.05 inch 0.393 ±0.003 0.224 ±0.012 0.230 -0.006 0.125 N/A 0.126 ±0.006 0.126 ±0.006 0.087 ±0.006 0.015 0.011 ±0.002 GULL WINGS mm 10 ±0.08 6 ±0.08 5.65 -0.2 N/A 7.5 ±0.3 5.08 ±0.1 3.2 ±0.15 2.2 ±0.15 0.4 N/A inch 0.393 ±0.003 0.236 ±0.003 0.222 -0.008 N/A 0.295 ±0.011 0.200 ±0.004 0.126 ±0.006 0.087 ±0.006 0.015 N/A J-LEGS mm 10 ±0.08 6 ±0.08 5.65 -0.2 N/A 2.8 ±0.2 5.08 ±0.1 3.2 ±0.15 2.2 ±0.15 0.4 N/A inch 0.393 ±0.003 0.236 ±0.003 0.222 -0.008 N/A 0.110 ±0.007 0.200 ±0.004 0.126 ±0.006 0.087 ±0.006 0.015 N/A ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-03-11 Junkersstrasse 3, D-82178 Puchheim, Germany EU AZ852 Packaging Specifications Tape and reel for SMT version - 1000 relays per reel, 1000 or 5000 relays per box Reel dimension Tube for THT version - 50 relays per tube, 1000 relays per box ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-03-11 Junkersstrasse 3, D-82178 Puchheim, Germany EU
AZ852PJ-6DE
1. 物料型号: - AZ852是一款微小型极化继电器,具有单稳态和双稳态(自锁)线圈版本。

2. 器件简介: - AZ852继电器符合IEC60950/UL60950/EN60950标准,具有高击穿电压和补充绝缘。适用于信号切换,具有稳定的接触电阻和环氧密封。UL和CUL认证待定。

3. 引脚分配: - 引脚排列为双刀双掷(DPDT)分叉横臂接触点。

4. 参数特性: - 电阻负载:最大切换功率60W或62.5VA,最大切换电流2.0A,最大切换电压220VDC或250VAC。 - 额定负载UL/CUR:0.5A在125VAC,2.0A在30VDC,0.24A在220VAC。 - 材料:钯钌;镀金。 - 电阻:初始小于50毫欧姆,在20mV、10mA条件下。 - 线圈(极化):在拾取电压下的功率(典型)为79mW(3-12VDC)和98mW(24VDC),最大连续功率为0.73W在20°C(68°F)。

5. 功能详解: - 机械电气寿命:最小操作次数为1x10^8次,1x10^5次在0.5A、125VAC、电阻条件下,1x10^5次在2.0A、30VDC、电阻条件下。 - 操作时间(典型):1ms在额定线圈电压下。 - 释放时间(典型):1ms在额定线圈电压下(无线圈抑制)。 - 弹跳(典型):在10mA接触电流下,操作或释放时1ms。 - 电容:线圈到接触点小于2pF在10kHz,开放接触点之间小于1pF在10kHz,接触点集之间小于2pF在10kHz。 - 耐压(海平面):详见表格。

6. 应用信息: - 适用于低级别信号切换,具有稳定的接触电阻和环氧密封。

7. 封装信息: - 封装材料为P.B.T.聚酯,UL 94 V-0。 - 端子材料为镀锡铜合金。 - 最高焊接温度为260°C(500°F),最大焊接时间为10秒。 - 重量为0.8克。 - 包装单位为每塑料管50个,每纸箱1000个,每卷1000个,每纸箱1000或5000个。
AZ852PJ-6DE 价格&库存

很抱歉,暂时无法提供与“AZ852PJ-6DE”相匹配的价格&库存,您可以联系我们找货

免费人工找货