C8051F302

C8051F302 C8051F302 ANALOG PERIPHERALS 8KB Flash, 256 RAM, 8-Bit ADC, 11-Pin MCU PRELIMINARY HIGH SPEED 8051 µC Core Pipe-lined Instruction Architecture; Executes 70% of Instructions in 1 or 2 System Clocks Up to 25MIPS Throughput with 25MHz Clock Expanded Interrupt Handler 256 Bytes Internal Data RAM 8k Bytes FLASH; In-System Programmable in 512 byte Sectors 8 Port I/O; All 5V tolerant with High Sink Current Enhanced Hardware UART and SMBus Serial Ports Three General Purpose 16-Bit Counter/Timers 16-bit Programmable Counter Array with Three Capture/Compare Modules, WDT 8-BIT ADC - Up to 500ksps - Up to 8 External Inputs - Programmable Amplifier Gains of 4, 2, 1, & 0.5 - VREF from External Pin or VDD - Internal or External Start of Conversion Sources - Built-in Temperature Sensor (± 3°C) Comparator - Programmable Hysteresis and Response Time - Configurable as Wake-up or Reset Source - Low Current (0.4uA) MEMORY DIGITAL PERIPHERALS - ON-CHIP DEBUG On-Chip Debug Circuitry Facilitates Full Speed, Non-Intrusive In-System Debug (No Emulator Required!) Provides Breakpoints, Single Stepping, Watchpoints Inspect/Modify Memory, Registers, and Stack Superior Performance to Emulation Systems Using ICE-Chips, Target Pods, and Sockets Low Cost, Complete Development Kit Typical Operating Current: 5.8mA @ 25MHz 11uA @ 32kHz Typical Stop Mode Current: