PJ1084CP

PJ1084 5 Amp Low Dropout Positive Voltage Regulator T He PJ1084 Series are high performance positive voltage regulators are designed for use in applications requiring TO-220 TO-263 low dropout performance at full rated current, Additionally, the PJ1084 Series provides excellent regulation over variations due to changes in line, load and temperature. Outstanding features include low dropout performance at rated current, fast transient response, internal limiting and current thermal shutdown protection of the output 1 2 3 12 3 TO-252 2 1 3 TO-263-2L 2 device. The PJ1084 Series are three terminal regulators with fixed and adjustable voltage options available in popular packages. Pin: 1.Adj (com) 2.Out 3.In 1 3 FEATURES ORDERING INFORMATION • Low dropout performance 1.3V max. Full current rating over line and temperature Device Operating Temperature (Ambient) PJ1084CZ PJ1084CZ-2.5 TO-220 PJ1084CZ-3.3 PJ1084CM PJ1084CM-2.5 TO-263 PJ1084CM-3.3 -20℃ to +85℃ PJ1084CF PJ1084CF-2.5 TO-263-2L PJ1084CF-3.3 PJ1084CP PJ1084CP-2.5 TO-252 PJ1084CP-3.3 NOTE: Contact factory for additional voltage option. Package • • Fast transient response Total output regulation ±2% over line, load and temperature • • • • • Adjust pin current max 120μA over temperature Line regulation typical 0.015%. Load regulation typical 0.05%. Fixed/adjustable output voltage TO-220 & TO-263 & TO-263-2L & TO-252 package BLOCK INPUT S.O.A LIMIT CURRENT LIMITING AMPLIFIER SENSE THERMAL OVERLOAD OUTPUT VOLTAGE REGULATION AMPLIFIER VREF ADJ/G 1-7 2002/01.rev.A PJ1084 5 Amp Low Dropout Positive Voltage Regulator ABSOLUTE MAXIMUM RATING Parameter Input Voltage Power Dissipation Thermal Resistance Junction to Case Thermal Resistance Junction to Ambient Operating Junction Temperature Range Operating Ambient Temperature Range Storage Temperature Range Lead Temperature (Soldering) 10 Sec. Symbol VIN PD θJC θJA TJ TA TSTG TLEAD Maximum 12 Internally Limited 2.5 50 0 to +125 -20 to +85 -25 to 150 260 ℃ Units V W ℃/W ELECTRICAL CHARACTERISTICS Unless otherwise specified, Adjust VIN = 2.75V to 12V and Adjust Io = 10mA to 5.0A Fixed VIN = 4.75V to 12V and Fixed Io = 10mA to 5.0A Parameter Output Voltage(1) Fixed Voltage Reference Voltage Adj Voltage Line Regulation(1) (Vin-Vout=3V) Load Regulation (Vin-Vout=3V) Dropout Voltage ΔVREF =1% Current Limit (Vin-Vout=5V) Quiescent Current Fixed Model Temperature Coefficient Adjust Pin Current Adjust Pin Current Change Temperature Stability Minimum Load Current Adjust Model RMS Output Noise(2) Ripple Rejection Ratio (3) (1) (1) Symbol 5V Test Conditions VIN -VOUT IO 10mA TJ(4) 25 Over Temp. 5V 10mA 25 Over Temp. 10mA 25 Over Temp. 25 Over Temp. 25 Min 0.99|Vo| 0.98|Vo| 1.238 1.225 Test Limits Typ Vo Max 1.01|Vo| 1.02|Vo| 1.262 1.275 0.2 Units Vo V VREF REG(LINE) REG(LOAD) VD IcL 1.250 0.015 0.035 0.05 0.2 1 1.1 0.3 0.4 % 1.3 V Over Temp. 5V 5.5 6.5 A IQ Tc IADJ ΔIADJ Ts Io VN RA 12 0.005 25 55 14 mA %/℃ 120 0.2 5V 5V 25 5V 5.0A Over Temp. 60 500mA Over Temp. 0.5 5 0.003 72 10 5 μA % mA %Vo dB (1)Low duty cycle pulse testing with Kelvin connections required. (2)Bandwidth of 10Hz to 10KHz. (3)120Hz input ripple (CADJ for ADJ) =25µF . (4)Over Temp.-over specified operating junction temperature range. 2-7 2002/01.rev.A PJ1084 5 Amp Low Dropout Positive Voltage Regulator Typical Application Circuit (1) C1 NEEDED IF DEVICE IS FAR FROM FILTER CAPACITORS (2) C2 REQUIRED FOR STABILITY (1) C1 NEEDED IF DEVICE IS FAR FROM FILTER CAPACITORS (2) C2 REQUIRED FOR STABILITY 3-7 2002.rev.A PJ1084 5 Amp Low Dropout Positive Voltage Regulator 4-7 2002.rev.A PJ1084 5 Amp Low Dropout Positive Voltage Regulator 5-7 2002.rev.A PJ1084 5 Amp Low Dropout Positive Voltage Regulator TO-220 Mechanical drawing TO-220 Unit : mm 1.Top View A 2.Side View B C I J P O DIM A B C D E F G H I J K L M N O P D N K G F E M L TO-220 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 10.00 10.50 0.394 0.413 3.24 4.44 0.128 0.175 2.44 2.94 0.096 0.116 3.565 4.315 0.140 0.170 0.68 0.92 0.027 0.036 1.115 1.485 0.044 0.058 2.345 2.715 0.092 0.107 13.49 14.31 0.531 0.563 4.475 5.225 0.176 0.206 1.15 1.39 0.045 0.055 27.78 29.62 1.094 1.166 2.175 2.925 0.086 0.115 0.297 0.477 0.012 0.019 8.28 8.80 0.326 0.346 14.29 15.31 0.563 0.603 6.01 6.51 0.237 0.256 H TO-263 Mechanical drawing TO-263 Unit : mm 1.Top View A 2.Side View J E F DIM A B C D E F G H I J B I D C G H TO-263 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 10.00 10.50 0.394 0.413 14.60 15.87 0.575 0.625 0.68 0.92 0.027 0.036 2.42 2.66 0.095 0.105 4.31 4.83 0.170 0.190 1.14 1.40 0.045 0.055 2.28 2.79 0.090 0.110 0.45 0.73 0.018 0.029 8.28 8.80 0.326 0.346 1.14 1.4 0.045 0.055 6-7 2002.rev.A PJ1084 5 Amp Low Dropout Positive Voltage Regulator TO-252 Mechanical drawing TO-252 Unit : mm 1.Top View A J 2.Side View E F DIM A B C D E F G H I J I B G D H C TO-252 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 6.57 6.84 0.259 0.269 9.25 10.40 0.364 0.409 0.62 0.76 0.024 0.030 2.56 2.67 0.101 0.105 2.30 2.39 0.090 0.094 0.49 0.57 0.019 0.022 1.46 1.58 0.057 0.062 0.52 0.57 0.020 0.022 5.34 5.55 0.210 0.219 1.46 1.64 0.057 0.065 TO-263-2L Mechanical drawing TO-263-2L Unit : mm 1.Top View A 2.Side View J E F DIM A B C D E F G H I J K I B K D C G H TO-263-2L DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 10.00 10.50 0.394 0.413 14.60 15.58 0.575 0.625 0.68 0.92 0.027 0.036 2.42 2.66 0.095 0.105 4.31 4.83 0.170 0.190 1.14 1.40 0.045 0.055 2.28 2.79 0.090 0.110 0.45 0.73 0.018 0.029 8.28 8.80 0.326 0.346 1.14 1.40 0.045 0.055 1.48 1.52 0.058 0.060 7-7 2002.rev.A