SME1400B-10-PCB

Low Cost Broadband Surface Mount Mixer SME1400B-10 The Communications Edge ™ Product Features • RF 1 to 2200 MHz • LO 1 to 2200 MHz • IF 1 to 2000 MHz • LO Drive: +10 dBm (Other Levels Available) • No Internal Solder Connections Product Photo Specifications Parameter SSB Conversion Loss (Max) RF/LO = 10-1300 MHz, IF = 10-1000 MHz RF/LO = 10-2500 MHz, IF = 10-1000 MHz RF/LO = 1-2500 MHz, IF = 1-2000 MHz Port-to-Port Isolation (Min) L-R = 10-2000 MHz L-R = 10-2500 MHz L-I = 10-2000 MHz L-I = 10-2500 MHz R-I 3rd Order Input Intercept Point VSWR R-Port = 600-2000 MHz R-Port = 10-2500 MHz L-Port = 600-2000 MHz L-Port = 10-2500 MHz I-Port 1 dB Conversion Compression Units dB dB dB dB dB dB dB dB dBm Typical 6.2 7.5 8.0 35 25 26 22 25 19 1.7:1 2.0:1 1.6:1 2.0:1 1.8:1 +6 Guaranteed +25°C -40° to +70°C 8.0 9.0 8.5 9.5 24 17 19 15 25 18 20 16 dBm 1. Measured in a 50-ohm system with nominal LO drive of +17 dBm, low side LO, and downconverter application only, unless otherwise specified. 2. Measured at LO = 400-2100 MHz, RF = 500-2200 MHz, IF = 100 MHz, unless otherwise specified. Absolute Maximum Ratings Parameter Operating Temperature Storage Temperature RF Input Power Rating -40 to +70°C -65 to +100°C +23 dBm at +25°C Ordering Information Part No. Description SME1400B-10 Mixer (Available in tape and reel) SME1400B-10-PCB Fully Assembled Application Circuit WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com September 2000 SME1400B-10 Performance Charts IIP3 vs. Frequency 28 26 Intercept Point (dBm) 24 22 20 IF = 10 MHz IF = 300 MHz RF1 = 2000 MHz IIP3 vs. LO Power 19.0 5 Conversion Loss vs. Frequency IF = 100 MHz IF = 1000 MHz 6 Conversion Loss (dB) 7 IF = 100 MHz IF = 100 MHz Intercept Point (dBm) 18.5 RF2 = 2010 MHz LO = 100 MHz 18.0 8 9 10 FL F R < IF = 2000 MHz 18 16 14 0 500 1000 1500 2000 2500 Frequency (MHz) 17.5 17.0 7 8 9 10 LO Power (dBm) 11 12 13 11 0 500 1000 1500 2000 2500 3000 Frequency (MHz) Conversion Loss vs. RF Power 6.0 6.0 Conversion Loss vs. LO Power 1500 MHz Conversion Loss vs. Temperature 6.4 6.5 Conversion Loss (dB) 6.6 6.7 6.8 6.9 Conversion Loss (dB) Conversion Loss (dB) 6.5 1000 MHz 6.5 7.0 RF = 900 MHz 7.0 7.5 LO = 800 MHz 8.0 7.5 0 1 2 3 4 5 6 7 8 7 8 9 10 LO Power (dBm) 11 12 13 RF Power (dBm) 7.0 -40 -20 0 20 Temperature ( C) ° 40 60 80 VSWR vs. Frequency 1.0 1.2 LO IF VSWR vs. Frequency 1.0 1.2 LO = 500 MHz Isolation vs. Frequency 55 50 45 Isolation (dB) 40 L-I L-R 1.4 VSWR 1.6 1.8 2.0 2.2 2.4 0 500 1000 1500 2000 2500 3000 Frequency (MHz) RF 1.4 LO = 1000 MHz 1.6 VSWR 1.8 2.0 2.2 2.4 0 500 1000 Frequency (MHz) 1500 2000 LO = 2000 MHz 35 R-I 30 25 20 0 500 1000 1500 2000 2500 Frequency (MHz) WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com September 2000 SME1400B-10 Single-Tone IM Products Harmonics of fLO 0 Harmonics of fRF 0 1 2 3 4 5 LO Mult 0 0 0 0 0 1 -1 1 1 1 1 2 -2 2 2 2 2 3 -3 3 3 -3 3 4 -4 4 4 4 -4 5 -5 5 5 5 5 27 63 >80 77 >80 1 34 0 55 69 >80 >80 RF Mult 1 2 3 4 5 0 1 -2 -3 -4 -5 0 1 -2 -3 -4 -5 0 1 -2 -3 4 -5 0 1 -2 -3 -4 5 0 1 -2 -3 -4 -5 2 44 33 56 >80 >80 >80 LO MHz 1950 1950 1950 1950 1950 2000 1950 2000 2000 2000 2000 1000 550 2000 2000 2000 2000 700 400 1500 2000 2200 2000 500 420 800 1100 2000 2075 400 350 700 1000 1150 1710 3 46 12 55 68 >80 >80 RF MHz 2000 1000 700 600 400 1950 2000 975 650 488 390 1950 2000 1975 1317 988 790 1950 1550 1200 1983 1700 1190 1950 2000 1200 1200 1987 1700 1950 1950 1200 1200 1200 1700 4 57 35 59 73 >80 >80 5 53 28 59 47 >80 >80 IM Prod MHz dB 2000 2000 2100 2400 2000 2000 50 50 50 48 50 2000 900 50 49 48 50 2100 350 2100 51 200 50 2000 320 800 800 52 200 2000 200 1100 1400 950 50 27 63 84 77 80 34 0 55 69 90 88 44 33 56 89 90 89 46 12 55 68 80 89 57 35 59 73 89 88 53 28 59 47 86 88 Test Conditions RF at -10 dBm; LO at +10 dBm RF harmonics and intermodulation products are referenced to a desired signal produced by fLO = 2000 MHz and fRF = 1950 MHz. LO harmonics are referenced to the LO drive signal. WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com September 2000 SME1400B-10 Outline Drawing Land Pattern Mounting Configuration Specifications and information are subject to change without notice. Caution! ESD sensitive device. WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-433-5649 • e-mail: sales@wj.com • Web site: www.wj.com September 2000