UFL-LP-062-A-L

Ultra Small SMT Coaxial Connectors - Low Profile 1.9mm or 2.4mm Mated Height U.FL Series Meets up to 6 GHz Requirement Mated Height Comparison (With Hirose Product) U.FL-LP-040 U.FL-LP-066 1.9(2.0Max) 2.4(2.5Max) 3(3.2Max) U.FL-LP(V)-040 E.FL-LP-040 E.FL-LP-066 U.FL Series E.FL Series sFeatures 1. Low Profile: 1.9mm or 2.4mm Nom. Mated Height Height from the circuit board is 2.0mm or 2.5mm maximum when a plug (right angle) is mated to a receptacle, which ranks with world’s smallest class. qSpace Factor of Mated Connector U.FL-LP-040 2.5Max Dia.0.81 U.FL-R-SMT U.FL-LP-066 2.5Max Dia.1.32 Dia.1.13 U.FL-R-SMT U.FL-LP(V)-040 Dia.0.81 U.FL-R-SMT U.FL-LP-062 Dia.1.0 U.FL-R-SMT U.FL-LP-088 Dia.1.37 U.FL-R-SMT 2.Extremely Small Occupied Mounting Area In comparison with our SMT coaxial connectors E.FL series, the receptacle provides a reduction of approximately 18% of occupied mounting surface, which is only 7.7mm2. 3.Light Weight One of the world’s lightest coaxial connectors. Receptacle: 15.7mg 4.Applicable Up to 6 GHz Frequency To meet the frequency requirements of a wide variety of miniature equipment, these connectors offer high frequency performance from DC to 6 GHz. 5.Board placement with automatic equipment Supplied on tape-and-reel packaging. NEW 2.0Max 6.Use of Ultra-fine Teflon Cable From among the types of applicable cable, dia. 0.81mm(single shielded) ultra-fine Teflon coaxial cable has been made a standard specification in construction area. Refer to the following pages for different cable types. 7.Simple Removal of Connector The extraction jig permits simple removal of connectors. NEW 2.4Max 8.User Friendly Mating Operation Tactile lock feeling ensures engagement even with this small size. sApplications Mobile phones, Wireless LAN, Mini-PCI, Bluetooth, PDA, GPS, electronic measuring instruments, etc. NEW 2.4Max 2003.9 1 s Product Specifications Ratings Nominal characteristic impedance Voltage rating Frequency range 50 ohms 60 V AC (rms) DC to 6 GHz Operating temperature range Operating humidity -40˚C to +90˚C 90% max. Item 1. Contact resistance Specification Center: 20 m ohms max. Outside: 10 m ohms max. 10 mA max. 100 V DC 200 V AC / 1 minute Up to 3GHz 1.3 Max 1.3 Max 1.3 Max 1.3 Max 1.3 Max 1.3 Max Conditions 2. Insulation resistance 3. Withstanding voltage 4. V.S.W.R.* 500 M ohms min. No flashover or insulation breakdown. Part No. U.FL-LP-040 dia.0.81mm Coaxial Cable Assembly U.FL-LP(V)-040 dia.0.81mm Coaxial Cable Assembly U.FL-LP-066 dia.1.13mm Coaxial Cable Assembly U.FL-LP-066 dia.1.32mm Coaxial Cable Assembly U.FL-LP-062 dia.1mm Coaxial Cable Assembly U.FL-LP-088 dia.1.37mm Coaxial Cable Assembly 3 to 6GHz 1.35 Max 1.3 Max 1.4 Max 1.5 Max 1.3 Max 1.4 Max 5. Female contact holding force 0.15 N min. 6. Durability (mating/un-mating, with corresponding plug) 7. Vibration No electrical discontinuity of 1µs min. 8. Shock No damage, cracks or parts dislocation. Contact resistance Center: 25 m ohms max. Outside: 15 m ohms max. Measured with a Ø 0.475 pin gauge 30 cycles Frequency: 10 to 100 Hz, single amplitude of 1.5mm, acceleration of 59m/s2, for 5 cycles in the direction of each of the 3 axis. Acceleration of 735 m/s2, 11ms duration, sine half-wave waveform, 2 cycles in each of 3 axes. 9. Humidity (Steady state) No damage, cracks or parts dislocation. Insulation resistance 100 M ohms min.(when humidity high) 96 hours at temperature of 40ç and humidity of 95%. Insulation resistance 500 M ohms min.(when dry) 10. Temperature cycle No damage, cracks or parts dislocation. Contact resistance:25 m ohms max. (Center) 15 m ohms max. (Outside) Temperature:-40˚C/+5 to +35˚C/+90˚C/+5 to +35˚C Time: 5 cycles 5% salt water solution, 48 hours 30 / 5 max. /30 /5 max.(Minutes) 11. Salt spray test No excessive corrosion *V.S.W.R. Measurement System The above V.S.W.R. standard values were measured using the measurement system of the diagram below. Note 1: Cable type connectors were measured with SMA conversion adapters attached to both ends of the harness product of a suitable 100cm cable. Note 2: Board type connectors were mounted to a 50 Ω glass epoxy board and measurements were conducted with SMA conversion adapters attached. sMaterials Part Shell Male center contact Female center contact Insulator Plug Receptacle Material Phosphor bronze Brass Phosphor bronze PBT LCP Finish Silver plating Gold plating Gold plating Color: Black Color: Beige Remarks ————— ————— ————— UL94V-0 UL94V-0 2 sCable Assembly (Plug) U.FL-LP-040 U.FL-LP-066 U.FL-LP(V)-040 U.FL-LP-062 U.FL-LP-088 2.8 2.8 3 Part No. 4 1.93 1.93 4 1.5 3.4 1.8 3 4 1.85 3 5 Mated Height 2.5mm Max. (2.4mm Nom.) Dia. 0.81mm Coaxial cable 53.7 2.5mm Max. (2.4mm Nom.) Dia. 1.13mm and Dia. 1.32mm Coaxial cable 59.1 2.0mm Max. (1.9mm Nom.) Dia. 0.81mm Coaxial cable 34.8 2.4mm Max. (2.3mm Nom.) Dia. 1mm Coaxial cable 45.5 2.4mm Max. (2.3mm Nom.) Dia. 1.37mm Coaxial cable 71.7 Applicable cable Weight (mg) qCable Guide Description Dia.0.81mm Coaxial Cable Dia.1.13mm Coaxial Cable Dia.1.32mm Coaxial Cable Dia.1mm Coaxial Cable Dia.1.37mm Coaxial Cable CableDia. 0.81mm Inner TypeCoaxial cable * Conductor 04 7/0.05 SA (AWG36) 7/0.08 SA (AWG32) 7/0.08 SA (AWG32) 7/0.071 SA (AWG33) 7/0.102 SA (AWG30) Cable Specification Dia. 0.81mm Dielectric Outer Single Shield SA Single Coaxial Diameter cableConductor* Dia.0.40 PFA Dia.0.68 FEP Dia.0.66 FEP Dia.0.62 FEP Dia.0.88 FEP Jacket Diameter Dia.0.81 PFA Dia.1.13 FEP Dia.1.32 FEP Dia.1 FEP Dia.1.37 FEP Dia. Nominal Dia. 1.37mm attenuation Nominal 1mm Coaxial cable Coaxial cable Impedance At 3GHz At 6GHz 50 ohms 6.45dB/m 3.43dB/m [3.73dB/m] 3.8dB/m 9.42dB/m 5.13dB/m [5.44dB/m] 5.6dB/m 068 Shield SA[TA] Double Shield TA Tape, single Shield TAT Single Shield TA 50 ohms 066 50 ohms 062 50 ohms 3.1dB/m 4.4dB/m 088 50 ohms 2.8dB/m 4.3dB/m (data as provided by material suppliers, for reference only) * SA : Silver plated annealed copper wire, TA : Tin plated annealed copper wire, TAT : Tin plated copper wire alloyed with tin sHow to Specify Cable Assembled Plug Dimension of U.FL Series assembly products should be made as indicated below. Double-Ended Cable Assembly L Single-Ended Cable Assembly L qOrdering Information qTotal Standard Tolerance for Total Length of Cable Assembly 3 4 Total Length(mm) 00350