1SS201

1 SS101 THUR 1SS301 XIN SEMICONDUCTOR ISO9002 FEATURES For general purpose applications SUPER HIGH SPEED SWITCHING DIODE SPECIAL DESIGN FOR PROTECTING SOLAR BATTERY R-1 These diodes features very low turn-on voltage and fastswitching. These devices are protected by a Pnjunction guard ring against excessive voltage, such as electrostatic discharges. APPLICATIONS High speed switch circuit IC polarity protection Solar battery polarity protection Small signal rectifier MECHANICAL DATA Case: JEDEC R-1 molded plastic body Polarity: color band denotes cathode end Mounting Position: Any Weight: 0.0063ounce, 0.18 gram Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (Ratings at 25 C ambient temperature unless otherwise specified ,Single phase ,half wave ,resistive or inductive load. For capacitive load,derate by 20%.) Symbols Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum non-repetitive peak reverse voltage Maximum average forward rectified current 0.375"(9.5mm)lead length at TL=90 C Peak forward surge current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) at TL=70 C Maximum instantaneous forward voltage at 1mA 200mA Maximum instantaneous reverse T A=25 C current at rated DC blocking T A=100 C voltage) Typical junction capacitance Typical thermal resistance Operating junction and storage temperature range 1SS101 20 14 20 24 1SS201 30 21 30 36 0.5 5.0 0.20 0.35 0.01 1.0 10.0 50.0 15.0 -65 to +125 1SS301 40 28 40 48 Units VRRM VRMS VDC VRSM I(AV) IFSM VF IR CJ R JA R JL TJ TSTG Volts Volts Volts Volts Amp Amps Volts mA PF C/W C R ATINGS AND CHARACTERISTIC CURVES 1SS101 THRU 1SS301 FIG.1-FORWARD CURRENT DERATING CURVE AVERAGE FORWARD CURRENT AMPERES FIG.2-MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT TJ=TJMAX PEAK FORWARD SURGE CURRENT(AMPERES) 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) RESISTIVE OR INDUCTIVE LOAD 0.375" (9.5MM) LEAD LENGTH LEAD TEMPERATURE ( C) NUMBER OF CYCLES AT 60Hz FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS FIG.4-TYPICAL REVERSE CHARACTERISTICS INSTANTANEOUS FORWARD CURRENT( AMPERES) TJ=125 C PULSE WIDTH=300 S 1% DUTY CYCLE INSTANTANEOUS REVERSE CURRENT MILL (AMPERES) TJ=25 C TJ=125 C TJ=75 C TJ=25 C INSTANTANEOUS FORWARD VOLTAGE (VOLTS) PERCENT OF RATED PEAK REVERSE VOLTAGE% FIG.5-TYPICAL JUNCTION CAPACITANCE FIG.6-TYPICAL TRANSIENT THERMAL IMPEDANCE TRANSIENT THERMAL IMPEDANCE, C/ W JUNCTION CAPACITANCE(pF) TJ=25 C f=1.0MHZ Vsig=50mVp-p REVERSE VOLTAGE. VOL TS T, PULSE DURATION ,sec.