AT4558

AT4558 Dual Operational Amplifier for Audio Features ˙Operating Voltage : ±1.5~±8V or 3~16V ˙Large DC Voltage Gain: 100 dB ˙High input Resistance :0.8MΩ ˙Low Input Offset Voltage:0.7mV ˙Bandwidth(unity gain):3MHz ˙Bipolar Technology Description The AT4558 consists of two independent, high gain, internally compensated amplifiers which were designed specifically to operate from a single or split power supply. Application areas include transducer amplifier, DC gain blocks and all the conventional operational amplifier circuits. The AT4558 can be directly operated +5V power supply, which is normally used in digital systems. Block Diagram 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 1 AT4558 Dual Operational Amplifier for Audio Absolute maximum ratings (Ta = 25oC) Parameter Power supply voltage Diffeential Input Voltage Input Voltage Range Power Dissipation Operating temperature Storage temperature Symbol V+/VVID VIN PD Topr Tstg Limits ±8 ±14 ±7 500 0~+85 -55~+150 unit V V V mW o C o C *Stresses beyond those listed under “ absolute maximum ratings” may cause permanent damage to the device. Exposure to absolute-maximum-rated conditions for extended peeriods may affect device reliability. Recommended Operating Condition Parameter Power supply voltage Symbol V+/VLimits ±1.5~±8(3~16) unit V Electrical characteristics (unless otherwise noted, Ta = 25oC, V+ = 6V, V- =-6V) Parameter Input Offset Voltage Input Offset Current Input Bias Current Input Resistance Input Voltage Range Large Signal Voltage Gain Gain Bandwidth Phase Margin Output Voltage Swing DC common mode Rejection ratio Power supply rejection Ratio Slew rate Input Noise Voltage Output Resistance Output Short-Circuit Current Channel separation Rise Time Operating Current Symbol VIO IIO IB RIN Vin Av GBW θm Vsw CMRR PSRR SR Vnoise Ro Ios α Tr Icc Min. 0.5 86 0.9 Typ. 0.7 5 70 0.8 100 3 60 ±5 98 95 1.0 1.94 75 100 100 55 5.5 Max. 6 200 500 ±5 10 Unit mV nA nA MΩ V dB MHz deg. V dB dB V/μS uVrms Ω mA dB ns mA Conditions Rs≤10KΩ RL=10KΩ Rs≤10KΩ, fin=100Hz Vp-p=100mV RL=2KΩ CL=100pF RIAA, Rs=1KΩ, 30kHz, LPF * f=1KHz~20KHz *1 Due to power disspation issue, it is not allowed for both channels to operate at this condition at the same moment. 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 2 AT4558 Dual Operational Amplifier for Audio Typical Curve Open-Loop Gain Bandwidth and Phase Margin 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 3 AT4558 Dual Operational Amplifier for Audio 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 4 AT4558 Dual Operational Amplifier for Audio 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 5 AT4558 Dual Operational Amplifier for Audio Application Circuit MIC Pre-Amp circuit for ECHO Application Change the value of the R and C to adjust the cutoff frequency of the high pass filter as you like. The output is connected to the input point of the echo application circuit. 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 6 AT4558 Dual Operational Amplifier for Audio 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 7 AT4558 Dual Operational Amplifier for Audio Package Outlines : DIP-8 SYMBOL A b1 b2 c1 D E e eA L Q s1 α INCHES MIN MAX 0.200 0.014 0.023 0.045 0.065 0.008 0.015 0.355 0.400 0.220 0.310 0.100 BSC 0.300 BSC 0.125 0.200 0.015 0.060 0.005 1050 900 MILLIMETERS MIN MAX 5.08 0.36 0.58 1.14 1.65 0.20 0.38 9.02 10.16 5.59 7.87 2.54 BSC 7.62 BSC 3.18 5.08 0.38 1.52 0.13 900 1050 NOTES - 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 8 AT4558 Dual Operational Amplifier for Audio Small Outline SOP-8 SYMBOL A B C D E F H J K M L e1 α INCHES MIN MAX 0.188 0.197 0.149 0.158 0.228 0.244 0.050 BSC 0.013 0.020 0.004 0.010 0.053 0.069 0.011 0.019 0.007 0.010 0.016 0.050 0.150 REF 450 0 80 0 MILLIMETERS MIN MAX 4.80 5.00 3.80 4.00 5.80 6.20 1.27 BSC 0.33 0.51 0.10 0.25 1.35 1.75 0.28 0.48 0.19 0.25 0.40 1.27 3.81 REF 450 0 0 80 NOTES - 2F, No.10, Prosperity RD. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C. Tel: 886-3-563-0878 WWW: http://www.aimtron.com.tw Fax: 886-3-563-0879 Email: service@aimtron.com.tw 9 AT4558 Dual Operational Amplifier for Audio Reflow Condition (IR/Convection or VPR Reflow) Reference JEDEC Standard J-STD-020A Classification Reflow Profiles Convection or IR/Convction Average Heating Rate(180°C to peak) Preheat Temperature(125±20°C) Temperature maintained above 180°C Time within 5°C of actual Peak Temperature Peak Temperature Range(Note 1) Cooling Rate Time 25°C to Peak Temperature 5°C/second max. 120 seconds max. 10~150 seconds 10~20 seconds 219~225°C or 235~240°C 6°C /second max. 6 minutes max. VPR 10°C/second max. 60 seconds 219~225°C or 235~240°C 10°C/second max. *1 The maximum peak temperatures for IR and VP reflow are depending on package dimensions. Package Reflow Conditions Pkg. Thickness ≥2.5mm Pkg. Thickness