NIKO-SEM
Three-Terminal Positive-Voltage Regulator
FEATURES
L78L15
GENERAL DESCRIPTION
This Series of fixed- voltage monolithic integrated circuit voltage regulators is designed for a wide range of applications. These applications include on-card regulation for elimination of noise and distribution problems associated with singlepoint regulation. In addition, they can be used with power-pass elements to make high-current voltage regulators. One of these regulators can deliver up to 100 mA of output current. The internal limiting and thermal shutdown features of these regulators male them essentially immune to overload. When used as a replacement for a zener diode- resistor combination, an effective improvement in output impedance can be obtain -ed together with lower-bias current.
l 3-terminal regulators l Output current up to 100 mA l No external component l Internal thermal overload protection l Internal short-circuit current limiting
APPLICATIONS
l Linear regulator l Instrumentation l Switching power supplies l PCs, Industrial equipment
PIN CONFIGURAT IONS
DEVICE SELECTION GUIDE
Device Package Marking L78L15N TO-92 78L15
1
MAR-14- 2002
NIKO-SEM
Three-Terminal Positive-Voltage Regulator
L78L15
ABSOLUTE MAXIMUM RATINGS
PARAMETER Input Voltage - V I Continuous total power dissipation Storage Temperature Range - TSTG Junction Temperature - TJ Lead Temperature (Soldering, 10 Seconds) - TL VALUE 30V (See Note 1) -55 to +150 °C 125 °C 260 °C
Note1: To avoid exceeding the design maximum virtual junction temperature, three ratings should not be exceeded. Due to variations in individual device electrical characteristics and thermal resistance, the built-in thermal overload protection may be activated at power levels slightly above or below the rated dissipation.
DISSIPATION RATING TABLE 1 – FREE-AIR TEMPERATURE
PACKAGE TO-92 TA ≤ 25°C POWER RATING 650 mW DERATING FACTOR 6.2 mW/°C DERATING ABOVE TA 25 °C TA = 70°C POWER RATING 350 mW
† The TO-92 package dissipation rating is based on thermal resistance θJA measured in still air with the device mounted in an Augat socket. The bottom of the package is 10mm (0.375 in) above the stock.
DISSIPATION RATING TABLE 2 – CASE TEMPERATURE
PACKAGE TO-92 TA ≤ 25°C POWER RATING 1600 mW DERATING FACTOR 28.6 mW/°C DERATING ABOVE TC 94 °C TC = 125°C POWER RATING 713 mW
RECOMMENDED OPERATING CONDITIONS
PARAMETER Input Voltage - V I L78L15 Output Current - IOUT Operating Virtual Junction Temperature - TJ VALUE 17.5V to 30V 100 mA (Max) 0 to 125 °C
2
MAR-14- 2002
NIKO-SEM
Three-Terminal Positive-Voltage Regulator
L78L15
ELECTRICAL SPECIFICATIONS (L78L15)
( V I = 23V, IO = 40 mA, CI = 0.33 µF, CO = 0.1 µF, 0 °C < TJ < +125 °C unless otherwise noted.)
PARAMETER Output Voltage Line Regulation
TEST CONDITIONS
MIN
TYP MAX UNITS 15 65 58 25 15 15.6 300 250 150 75 15.75 15.75 6.5 1.5 0.1 82
V mV
Load Regulation Output Voltage Input Bias Current
TJ = +25 °C 14.4 TJ = +25 °C 17.5V ≤ VI ≤ 30V 19V ≤ VI ≤ 30V TJ = +25 °C 1.0 mA ≤ IO ≤ 100 mA 1.0 mA ≤ IO ≤ 40 mA 17.5V ≤ VI ≤ 30V, 1.0 mA ≤ IO ≤ 40 mA 14.25 14.25 VI = 23V, 1.0 mA ≤ IO ≤ 70 mA TJ = +25 °C
mV V mA mA µV dB V
4.6
Input Bias Current Change 19V ≤ VI ≤ 30V 1.0 mA ≤ IO ≤ 40 mA Output Noise Voltage TA = +25 °C, 10 Hz ≤ f ≤ 100 KHz TJ = +25 °C, f = 120 Hz Ripple Rejection 18.5V ≤ VI ≤ 28.5V Dropout Voltage TJ = +25 °C
34
39 1.7
3
MAR-14- 2002
NIKO-SEM
Three-Terminal Positive-Voltage Regulator
L78L15
TO-92 MECHANICAL DATA
mm Dimension A B C D E F G Min. 4.445 4.318 12.7 0.356 1.143 3.175 0.762 1.27 Typ. Max. 5.207 5.334 15.5 0.533 1.397 4.191 1.270 Dimension H I J K L M N Min. 2.413 0.356 mm Typ. 2.540 Max. 2.667 0.533
4
MAR-14- 2002
很抱歉,暂时无法提供与“L78L15”相匹配的价格&库存,您可以联系我们找货
免费人工找货- 国内价格
- 1+0.20999
- 100+0.19599
- 300+0.18199
- 500+0.168
- 2000+0.161
- 5000+0.1568
- 国内价格
- 1+0.5169
- 30+0.49747
- 100+0.45861
- 500+0.41974
- 1000+0.40031
- 国内价格
- 1+0.8185
- 10+0.78602
- 100+0.70807
- 500+0.66909
- 国内价格
- 1+0.67779
- 10+0.62177
- 30+0.61057
- 100+0.57696