MZPC0204610A

046/47-MZ 2P 10A eng 2-03-2001 11:48 Pagina 46 Miniature Relays Series M Type MZ 2 poles 10A Monostable • • • • • • • • • Miniature size PCB mounting Reinforced insulation 4 kV / 8 mm Switching capacity 10 A DC coils 1.87 to 160 VDC AC coils 4.8 to 264 VAC General purpose, industrial electronics Types: Standard, flux-free or sealed Switching AC/DC load MZP Product Description H: Sealed with inert gas Sealing according to IP 67,suitaP: Standard,suitable for sol ble for automatic solde dering and manual washing. ring and/or partial immerF: Flux-free, suitable for autosion or spray washing. matic soldering and partial immersion or spray washing. Ordering Key Type Sealing Version (A = Standard) Contact code Coil reference number Contact rating MZ P A 200 47 10 For General data, notes and special versions see page 48 Version A = 5.0 mm / Ag CdO (standard) C = 5.0 mm / hard gold plated D = 5.0 mm / flash gilded S = 5.0 mm / Ag Sn 02 Available only on request Ag Ni Type Selection Contact configuration 2 normally open contact 2 normally closed contact 2 change over contact (DPST -NO {2-form A}) (DPST -NC {2-form B}) DPDT {2-form C}) Contact rating 10 A 10 A 10 A Contact code 200 020 002 Coil Characteristics DC Coil reference number 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 (20°C) Winding resistance Ω 11 30 55 110 170 280 450 720 860 1150 1750 2700 4300 6450 9900 12550 16200 23500 Rated Voltage 200/002 020 VDC VDC 2.6 4.3 5.9 8.5 10.5 13.0 17.0 21.5 23.5 27.0 34.5 42.5 54.5 68.0 87.5 101.0 115.0 132.0 2.5 4.1 5.6 8.0 10.0 12.5 16.0 20.5 22.5 26.0 32.5 40.5 51.5 64.5 83.0 95.0 109.0 125.0 ±% 10 10 10 10 10 10 10 15 15 15 15 15 15 15 15 15 15 15 Operating range Min. VDC Max.VDC 200/002 020 1.98 3.30 4.52 6.49 7.99 9.98 13.0 16.3 18.0 20.7 26.2 32.6 41.8 52.0 67.2 77.0 87.9 101.0 1.87 3.13 4.28 6.14 7.56 9.49 12.30 15.50 17.10 19.70 24.90 30.90 39.60 49.20 63.60 73.00 83.30 96.00 3.50 5.75 7.80 11.00 13.70 17.60 22.50 28.60 30.80 35.70 44.00 55;00 69.30 84.70 104.00 117.00 136.00 160.00 Must release VDC ≥ 5% of rated voltage 46 Specifications are subject to change without notice 046/47-MZ 2P 10A eng 2-03-2001 11:49 Pagina 47 Miniature Relays Series M Type MZ 2poles 10A Monostable Coil Characteristics AC Coil ref. no. 90 91 92 93 94 95 96 97 (20°C) Inductance H 0.059 0.267 1.123 4.170 6.450 22.400 100.200 107.800 Must release Rated Current (mA) Rated Voltage Winding resistance Operating range VAC VAC 50Hz 60Hz Ω ±% min. VAC Max. VAC 6 12 24 48 60 110 220 240 12 56 230 870 1500 5300 20000 25000 10 10 10 15 15 15 15 15 4.8 9.6 19.2 38.4 48.0 88.0 176.0 192.0 6.6 13.2 26.4 52.8 66.0 129.0 242.0 264.0 270.0 119.0 57.0 30.5 23.8 12.3 5.9 5.7 237.0 104.0 50.0 26.7 21.0 10.8 5.2 5.0 ≥ 15% of rated voltage Contact Characteristics Rating Material (standard version)2) Current (at 250VAC) Rated current Max. switching current Overload current (4sec ON / 40sec OFF cycle) Voltage Rated voltage Max.switching voltage (VDE 0435) 2) 3) 10 A AgCdO 10 A 12 A 14 A Power Max. switching power with resistive load in AC 3) Max. switching power in DC Minimum switching current 2) (typical value) Life (see diagram 1) Typical electrical life at max. resistive load 1000 cycles/h 500 cycles/h Max.electrical repetition rate Mech. life at 18000 cycles/h 2500 VA see diagram 3 100mA at 24VDC 250 VAC 380 VAC 7.5 x 10 cycles 8 x 10 cycles 3600 cycles/h 50 x 10 cycles 4 6 4 See pag. 48 Dimensions MZP...200/020/002 10A h Pin View 200 020 002 Wiring Diagrams 200 020 002 h’ MZP: h = 25,2 mm h’= 4,3 - 5,3 mm MZF/MZH: h = 26.5 mm h’= 2.8 - 3.8 mm Diagrams 1 Expected life at 250 VAC (Resistive loads and repetition rate 1000 cycles/h) 2 Reduction of expected life against load power factor cos ϕ 3 Max. switching power DC I (Ampere) DC Load power factor V (Volt) DC 47 Specifications are subject to change without notice Specifications are subject to change without notice 47