PJ78LXXCS

PJ78L00 3-Terminal Low Current Positive Voltage Regulators of applications that require a regulated supply of up to 100 mA. Like their higher powered PJ7800 Series cousins, these regulators feature internal current limiting and thermal shutdown making them remarkably rugged. No external components are required with the PJ78L00 devices in many applications. These devices offer a substantial performance advantage over the traditional zener diode-resistor combination, as output impedance and quiescent current are substantially reduced. T he PJ78L00 Series of positive voltage Regulators are inexpensive, easy-to-use devices suitable for a multitude TO-92 SOT-89 PJ78L00 Pin Pin 1. Output 2. Ground 3. Input 1. Input 2. Ground 3. Output PJ78L00A 1. Output 2. Ground 3. Input (Heatsink surface connected to Pin 2) SOP-8 FEATURES Wide Range of Available, Fixed Output Voltages Low Cost Internal Short Circuit Current Limiting Internal Thermal Overload Protection No External Components Required Complementary Negative Regulators Offered (PJ79L00 Series) Available in ±4% Voltage Tolerance. Pin: 1.Vout 2.Gnd 3.Gnd 4.Nc 5.Nc 6.Gnd 7.Gnd 8.Vin ORDERING INFORMATION Device Operating Temperature Package PJ78LxxCT PJ78LxxCS PJ78LxxCY PJ78LxxACY -20℃ to +85℃ TO-92 SOP-8 SOT-89 CIRCUIT SCHEMATIC TYPICAL CONNECTING CIRCUIT REPRESENTATIVE CIRCUIT SCHEMATIC STANDARD APPLICATION A common ground is required between the input and the output voltages. The input voltage must remain typical 2.0V above the output voltage even during the low point on the input ripple voltage. *=Cin is required if regulator is located an appreciable distance from from power supply filter. **=Co is not needed for stability, however, it does improve transient response. 1-8 2002/07.rev.A PJ78L00 3-Terminal Low Current Positive Voltage Regulators MAXIMUM RATINGS ( Ta=+25℃ unless otherwise noted.) SYMBOL Vi *1 Vi *2 Tstg Tj -65 0 PJ78L00 SERIES 35 40 to +150 to +150 UNIT V V ℃ ℃ RATING Input Voltage Input Voltage Storage Junction Temperature Range Operating Junction Temperature Range Note : *1. PJ78L05 to PJ78L18 *2. PJ78L24 This specification applies only for DC power dissipation permitted by absolute maximum ratings. Pulse testing techniques are used to maintain the junction temperature as close to the ambient temperature as possible. Thermal effects must be taken into account separately. All characteristics are measured with a 0.33uF capacitor across the input and a 0.1uF capacitor across the output. • PJ78L05 ELECTRICAL CHARACTERISTICS (VI =10V, Io=40mA, CI=0.33µF, Co=0.1µF, 0℃ < TJ