2016A

Quality Innovations Customer Satisfaction INTEGRAL ELECTRONICS (IEPE) PIEZOELECTRIC ACCELEROMETER • Outstanding Dynamic Range • Wide Bandwidth • Low Impedance Output • Top Connector • Stud Mounted Description The VIP Sensors Model 2016A is a stud mounted piezoelectric accelerometer designed for general vibration measurement on structures and objects. It features a high signal-to-noise ratio, a high output sensitivity, and a wide bandwidth. The accelerometer transmits its low impedance voltage output through the same cable that supplies the constant current power. The Model 2016A design is sealed against external contamination. Signal ground is connected to the outer case of the unit. When used with an isolated mounting stud, the accelerometer is electrically isolated from ground. The accelerometer features a 10-32 top connector that is used with coaxial cable for error-free operation. VIP Sensors Signal Conditioner Models 5005, 5100 and 5102 are recommended for use with this low impedance accelerometer. MODEL 2016A 1 0 -3 2 5) 0.1 9 ( 5.5 ) 1 0 -3 2 0.2 2 ( 0.4 6 ( 1 1.7 ) in (mm) Typical Amplitude Response 15.00 Typical Temperature Response 15 10 5 0 -5 -10 -15 -50 50 (10) 150 (66) 250 % DEVIATION % DEVIATION 10.00 5.00 0.00 -5.00 0 1 10 100 1000 10000 100 350 (121) (1 FREQUENCY (-46) TEMPERATURE °F (°C) VIP Sensors California, USA Ph (949) 429 3558 Fx (949) 528 0126 info@vipsensors.com www.vipsensors.com VIP Sensors reserves the right to modify these specifications without notice. V01 0.8 5 ( 2 1.5 ) Quality Innovations Customer Satisfaction INTEGRAL ELECTRONICS (IEPE) PIEZOELECTRIC ACCELEROMETER SPECIFICATIONS The following performance specifications conform to ISA-RP-37.2 (1964) and are typical values, referenced at +75°F (+24°C) and 100 Hz, unless otherwise noted. Calibration data, traceable to National Institute of Standards and Technology (NIST), is supplied. MODEL 2016A UNITS DYNAMIC CHARACTERISTICS Range Voltage Sensitivity, typical Transverse Sensitivity Frequency Response Resonance Frequency Amplitude Response +5% + 1 dB Temperature Response Amplitude Linearity ELECTRICAL CHARACTERISTICS Output Polarity Power Source Voltage (Constant Current) Supply Current Bias Voltage Full Scale Output Voltage (peak) Output Impedance Noise Grounding VDC mA V Vp Ω mg (mm/s2) g (m/s2) mV/g (mV/m/s2) % Hz Hz Hz % 50 (490.3) 100 (10.02) ≤5 See Typical Amplitude Response 15,000 2 – 6,000 0.5 – 8,000 See Typical Temperature Response