313LCPOAALJGE

SUBMERSIBLE LEVEL TRANSMITTER Model 313L G ENERAL PURPOSE FEATURES: • • • • All-welded, stainless steel construction Rugged, all encapsulated electronics. Leakproof 1/2” NPT conduit thread standard Standard PRESSURE RANGES: • From 0-3 through 0-100 psig (See ordering guide.) ACCURACY: • From ± 0.1% FSO (RSS) to ± 0.5% FSO (RSS) (See specifications & ordering guide.) with Option LJ tapered inlet with stand off plate ORDERING GUIDE Ordering: Specify model, and pressure range and indicate modifications or accessories required. Use the following codes to identify desired item. Example 313L-B-PZ-LJ MODEL SERIES RANGE OPTIONS • MODEL 313L 4-20mA SERIES B ± 0.5% FSO (RSS) C ± 0.2% FSO (RSS) D ± 0.1% FSO (RSS) • • •/•/• OPTIONS AA None (standard connector) CZ Alternate cable length (specify) ALTERNATE PRESSURE PORT FH 1/8” NPT (F) FL 1/8” NPT (M) LD Tapered inlet LJ Tapered inlet with standoff plate PRESSURE RANGE psi in wc PG 3 XK 100 PJ 5 XM 150 PL 7.5 XO 200 PN 10 XQ 300 PP 15 PR 20 PO 25 PT 30 PV 50 PX 75 PZ 100 GENERAL CT Tefzel jacketed cable GA Standardized output to ± 0.5% FSO GB Alternate output, pressure units, or full scale outputs that are non-standard GE Improved temperature compensation to ± 0.5% FSO unless otherwise specified GG Alternate calibration signal GH Internal calibration resistor set to 100 ± 0.5% FSO unless other wise specified JH Remote cable mounted (in-line) zero & span controls. 3’ cable on open side. Length of cable on closed side as required. (500’ maximum) GZ Customer special Specifications printed on reverse side of this brochure. GP:50 reserves the right to make product improvements and amendments to the product specification stated throughout this brochure without prior notification. Please contact the factory on all critical dimensions and specifications for verification. TOPE Co., Ltd. Tel. (02) 8228-0658 • Fax. (02) 8228-0659 • E-mail: tope@ms1.hinet.net • Website: www.sensor.com.tw SL5B-313L.02C SPECIFICATIONS SPECIFICATIONS Unless otherwise stated, these specifications are the standards to which the units are normally constructed. Alterations may be easily and readily accomplished by the standard modification code or by discussion with the factory. We invite your inquiry. Accuracy (Static error band includes non-linearity, hysteresis, non-repeatability) Series B ± 0.5% FSO (RSS) Series C ± 0.2% FSO (RSS) Series D ± 0.1% FSO (RSS) Temperature Limits* Compensated Operating Storage Temperature Compensation* Zero Span Electricals Excitation Zero Balance Span Load Impedance Circuit Protection Insulation Resistance Resolution Mechanicals Proof Pressure Burst Pressure External Pressure Case Materials Pressure Response Long Term Stability Position Effect Calibration Orientation Cycle Life Fluid Fill Length Diameter Connections Pressure Electrical Cable Identification * See modifications on ordering guide. 0°F to +140° F -40 °F to +150° F -40 °F to +150° F Less than ± 2% FSO/100°F at full scale pressure range and/or upper range limit Less than ± 2% FSO/100°F at full scale pressure range and/or upper range limit 12 - 40 Vdc 4.0mA ± 2% FSO at 70 ° F 16.0mA ± 2% FSO at 70° F 1400 ohm maximum at 40 Vdc excitation Short Circuit - Indefinite Reverse Wired - Indefinite Greater than 10 M ohm at 50 Vdc and 70°F Infinite 2 times rated full scale pressure 4 times rated full scale pressure 500 psi maximum Type 316 stainless steel < 5 ms to 90% < +0.5% FSO / year ± 0.01% FSO for a 90° c hange in orientation Horizontal unless specified 1 million pressure cycles 200 CS. Dow Corning 200. (Silicon Oil) 6.1 inches 1.0 inches PVC bullet nose Molded polyurethane jacket, 6 conductor with breather tube, 24 AWG, 8’ long Etched onto housing WIRING CODE 313L Red Green White Black Blue Brown Shield + Excit./Signal NC NC - Excit./Signal NC Option GH NC Option GH Open Some options will affect dimensions. Consult factory if important. Note: Altering option codes will alter the unit length. FLATS 1/2 NPT CONDUIT FITTING 1.0" DIA. REF. BREATHER TUBE 1.00" 6.1 REF. SUBMERSIBLE CABLE 2770 Long Road, Grand Island, NY 14072 USA Tel. (716) 773-9300 • Fax (716) 773-5019 • E-mail: sales@gp50.com • Website: www.gp50.com