S1-0009

H igh Linearity Position Sensing Detector Part Number: S1-0009 Description: 1L5_CP1 The SiTek 1L5 PSD functions according to the Lateral Effect Photodiode principle. It is an analogue device and therefore displays excellent position resolution. The resolution is determined by the system signal-to-noise ratio. The 1L5 is operated in the biased mode. Typical applications include: distance and height measurement, alignment, position and motion measurements and vibration studies. Special UV- or YAG-enhanced and Nuclear versions are available. Parameter Active area Position non-linearity Detector resistance Dark current Noise current Responsivity Capacitance Rise time (10-90%) Reverse voltage (bias) Thermal drift Symbol Min. Typ. 5x1 0,1 Max. 0,2 80 20 1,0 6 80 20 100 Unit mm2 %(±) kΩ nA pA/ √ Hz A/W pF ns V ppm/°C Rdet Id Inoise r Cj tr Vr 40 50 4 0,4 0,63 5 50 5 15 20 Maximum ratings Reverse voltage Operating temperature Storage temperature VR-max Toper Tstg 30 70 100 V °C °C Test conditions: Package: Room temperature 23°C. Reverse voltage 15 V. Light-source wavelength 940 nm. Position non-linearity and thermal drift are valid within 80% of the detector length. 4-pin ceramic DIL-package, 9,9 x 5,8 mm2, with protective window. LASER COMPONENTS GmbH, Werner-von-Siemens-Str. 15, 82140 Olching, Germany, Phone: +49 8142 2864 0, Fax: +49 8142 2864 11 info@lasercomponents.com 1 L5_CP1 Pin configuration: 1 2 3 4 Bias Output Y1 N/C Output Y2 Note: Outputs Y1, Y2 are interchangeable. The anodes Y1, Y2 must be at negative potential compared to the cathode. Application information: The inherent resolution of a PSD is very good. It is proven to be better than one part in one million. The performance of a PSD based measurement system is thus limited by its mechanical, optical and electrical components. To get the best performance you have to consider: • Modulated light source. Modulation makes it possible to avoid influence of other light sources. • Stable temperature. • Mechanical stable system. • High optical resolution. • High resolution in division of the sum- and difference signals. Resolution, optical sensitivity and measurement speed are related to each other in the PSD measurement system and you have to make the proper choices and tradeoffs for your system. Further information as schematics of a recommended hook-up is obtainable from your local distributor or from SiTek Electro Optics AB. SiTek PSD Position Measurement electronic boards: For most position measurement applications the SiTek PM-kit offers a complete and easy-to use solution. It is a series of general purpose, high performance, low-noise electronic boards designed for SiTek PSD. You can easily build your own measurement system using our PM-kit. Further information is obtainable from your local distributor or from SiTek Electro Optics AB. Information in this data sheet is believed to be reliable. However, no responsibility is assumed for possible inaccuracies or omissions. Specifications are subjected to change without notice. www.lasercomponents.com Issue: 01/06 / V1 / HW / www/pdf/sitek/ 1l5_cp1.pdf LASER COMPONENTS GmbH, Werner-von-Siemens-Str. 15, 82140 Olching, Germany, Phone: +49 8142 2864 0, Fax: +49 8142 2864 11 info@lasercomponents.com