SENACC-010

Technical Data Sheet Acceleration Sensor - SENACC • • • • • Single axis acceleration measurements (lowfrequency vibrations and movements). W ide acceleration range. Excellent EMI/RFI immunity. Rugged epoxy-filled enclosure, small size. W atertight mini sure-seal® connector. The SENACC measures vibrations up to 150Hz with a recorder that is setup accordingly. It may also measures longitudinal, lateral or vertical acceleration of the body or the moving parts of a vehicle. When its sensing axis is oriented to gravity the SENACC experiences an acceleration of +1.0 g. • • • Range ± 1.0G ± 3.3G ± 5.0G ± 10.0G ± 25.0G ± 50.0G Do not expose wire/connector to water, oil or fuel. Route the sensor cable away from sources of interference, such as ignition coils, plug leads, electronic modules or antennas. Verify that the cable is not pinched or stretched by moving parts. Do not bend cable with curvature radius smaller than 1.60″ [40 mm]. • Available ranges: Sensor SENACC-010 SENACC-030 SENACC-050 SENACC-011 SENACC-250 SENACC-051 • • • • • Operating temperature: -40°C to 85°C. Power supply: 5 mA, 11-24Vdc. Dimensions: 33mm x 38mm. W eight: 56 grams (1.975 oz.) • • • • Align the sensor‘s sensitivity axis with the measuring direction. Use the #4-40 screw-holes to fasten the sensor rigidly to the moving body. Connect the sensor to an analog input of the system: A, B or C. Carefully align indexing rib when mating mini sure-seal® connectors. SENACCTDS/E - ISSUE 4 – October 2004 PAGE 1 of 3 Technical Data Sheet Acceleration Sensor - SENACC Refer to the nameplate on each sensor for individual calibration parameters. Name Predefined Equation Units P1 Name Predefined Equation Units P1 Name Predefined Equation Units P1 Name Predefined Equation Units P1 Name Predefined Equation Units P1 Name Predefined Equation Units P1 SENACC-010 Acceleration g or m/s2 See nameplate P2 See nameplate SENACC-030 Acceleration g or m/s2 See nameplate P2 See nameplate SENACC-050 Acceleration g or m/s2 See nameplate P2 See nameplate SENACC-011 Acceleration g or m/s2 See nameplate P2 See nameplate SENACC-250 Acceleration g or m/s2 See nameplate P2 See nameplate SENACC-051 Acceleration g or m/s2 See nameplate P2 See nameplate SENACCTDS/E - ISSUE 4 – October 2004 PAGE 2 of 3 Technical Data Sheet Acceleration Sensor - SENACC Black anodized aluminum enclosure MIL-C-27500 shielded cable (+) sensitivity axis #4-40 THRU hole 2 PL Water tight mini sure-seal® connector All dimensions are in inches [millimeters]. SENACCTDS/E - ISSUE 4 – October 2004 PAGE 3 of 3